heater Lancia Delta 2008 Owner handbook (in English)

58GETTING TO KNOW YOUR CAR
heated rear windscreen and door mirrors
demisting/defrosting fig. 26
Press button F (
() to activate the function: When the
function is active, an LED on the button lights up.
This function is timed and will turn off automatically af-
ter 20 minutes. Press
(again to disable the function in
advance.
IMPORTANT Do not apply stickers on the inside of the
rear window over the heating filaments to avoid damage
that might cause it to stop working properly.
IMPORTANT Press
Tto draw air in from the outside
(in this case the LED on the button should be off).Rapid window demisting/defrosting
(MAX-DEF function) fig. 26
Press button G
-to automatically activate the timed op-
eration of all the functions required to rapidly
demist/defrost the windscreen and front windows.
The functions are:
climate control compressor engagement (with an out-
door temperature of above 4°C);
disengagement (if previously engaged) of air recircu-
lation (the LED on button
Tshould be off);
engagement of heated rear windscreen (the LED on
button
-should be on) and door mirror heater coils;
air temperature set to maximum;
activation of air flow.
Activation of air recirculation and enablement of
AQS (Air Quality System) fig. 26
Press button
T.
Air recirculation is carried out according to three possi-
ble operation modes:
automatic control, indicated by the AQS appearing on
the display and the LED on button
Tshould be off;

GETTING TO KNOW YOUR CAR75
1
fig. 41L0E0034m
Cooled drinks compartment
Press button A-fig. 41 and lift up armrest B: you can then
access cooled drinks compartment fig. 41.
IMPORTANT The compartment is designed to maintain
the temperature of the drinks placed inside it, which
should be chilled or heated before being placed in the com-
partment. The drinks will remain hot if the heater is
switched on or cool if the air conditioning compressor is
switched on.

STARTING UP AND DRIVING153
3
Accessories fitted on longitudinal bars
Remove any accessories such as: longitudinal bars, ski
racks, luggage rack, from the roof if they are not being
used. These accessories decrease aerodynamic penetration
and have a negative effect on fuel consumption. It is bet-
ter to use a trailer to transport particularly bulky objects.
Electrical devices
Use electrical devices only for the amount of time needed.
The heated rear windscreen, additional headlights, wind-
screen wipers and heater fan need a considerable amount
of energy; increasing the requirement of current increas-
es fuel consumption (up to +25% in the urban cycle).
Climate control
The climate control system leads to higher fuel consump-
tion (up to +20% on average): use air vents only when the
external temperature allows.
Spoilers
The use of non-certified aerodynamic items may adversely
affect air drag and fuel consumption levels.DRIVING STYLE
Starting
Do not warm the engine up with the car standing: the en-
gine warms up very slowly in these conditions, increas-
ing fuel consumption and emissions. It is advisable to start
off immediately and slowly keeping the engine speed
down: the engine will warm up much faster this way.
Unnecessary actions
Avoid revving up when starting at traffic lights or before
stopping the engine. The latter action, like doubling the
clutch, is unnecessary and causes increased fuel con-
sumption and pollution.
Gear selection
Use a higher gear as soon as traffic and road conditions
allow. Using a low gear for faster acceleration will increase
fuel consumption.
In the same way improper use of a high gear increases
fuel consumption, emissions and engine wear.
Top speed
Fuel consumption considerably increases as speed in-
creases. Keep your speed as even as possible, avoiding un-
necessary braking and acceleration, which cause excessive
fuel consumption and increased emissions.

IN AN EMERGENCY193
4
–
40
40
40
40
40
40
40
40
40
40
40
40
40
40
40F08
F09
F10
F11
F14
F15
F16
F17
F18
F19
F22
F22
F23
F24
F30
F85–
20
10
10
15
30
7.5
10
7.5
7.5
15
20
20
5
15
15
FUSE SUMMARY TABLE - Engine compartment control unit
CONSUMERS FUSE AMPERE DIAGRAM
Spare
Headlight washer pump
Horn
Electronic injection secondary loads
Main beam headlights
PTC1 additional heater
Engine Management Node
Electronic injection primary loads
Engine Management Node
Air conditioning compressor
Electronic injection primary loads (1.4 engine)
Electronic injection primary loads (1.8 and diesel engine)
Brake Node (valves)
Electric Steering Node
Fog/cornering lights
Fuel pump