sensor LEXUS GS400 2000 Service Service Manual

I04038
I04039
BE±42
± BODY ELECTRICALHEADLIGHT AND TAILLIGHT SYSTEM
2343 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)8 ± Ground
Headlight dimmer switch HIGH beam or FLASHContinuity
1 ± GroundIgnition switch LOCK or ACCNo voltage
1 ± GroundIgnition switch ON or STARTBattery positive voltage
5 ± GroundEngine StopNo voltage
5 ± GroundEngine RunningBattery positive voltage
7 ± GroundConstantBattery positive voltage
9 ± GroundConstantBattery positive voltage
If circuit is specified, try replacing the relay with a new one.
If circuit is not as specified, inspect the circuits connected to oth-
er parts.
16. INSPECT AUTOMATIC LIGHT CONTROL
AUTO ON:
(a) Turn the ignition switch ON.
(b) Turn the light control switch to AUTO.
(c) Gradually cover the top of the sensor.
(d) Check the accessory lights and the headlights should turn
ON.
17. INSPECT AUTOMATIC LIGHT CONTROL
AUTO OFF:
(a) Gradually expose the sensor.
(b) Check the headlights and the accessory lights should turn
OFF.
18. INSPECT LIGHT±OFF CONDITION
(a) Turn the ignition switch ON.
(b) Gradually cover the top of the sensor.
Lights auto ON:
(c) Check that the lights go off under the following conditions.
(1) Light control switch is OFF.
(2) The area surrounding the sensor gets bright.
(3) The driver's door is opened with the ignition switch
OFF.

I01254
Wire Harness Side
4 3 2 1
± BODY ELECTRICALHEADLIGHT AND TAILLIGHT SYSTEM
BE±43
2344 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)
19. INSPECT LIGHTS±ON CONDITION
(a) Open the driver's door while the ignition switch is OFF.
(b) Turn the light control switch to AUTO leaving the door
open and cover the top of the sensor, and verify that the
lights go on when the ignition switch is turned ON.
20. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
CIRCUIT
Connector disconnected:
Disconnect the connector from the sensor and inspect the con-
nector on the wire harness side, as shown in the table.
Tester connectionConditionSpecified condition
3 ± GroundConstantContinuity
1 ± GroundIgnition switch LOCK or ACCNo voltage
1 ± GroundIgnition switch ONBattery positive voltage
4 ± GroundIgnition switch LOCK or ACCNo voltage
4 ± GroundIgnition switch ON5.2 ± 9.0 V
If circuit is as specified, perform the inspection on the following
page.
If the circuit is not as specified, inspect the circuit connected to
other parts.

I01255
1
2 3 4
From Back Side BE±44
± BODY ELECTRICALHEADLIGHT AND TAILLIGHT SYSTEM
2345 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)
21. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
CIRCUIT
Connector connected
Connect the wire harness side connector to the sensor and in-
spect wire harness side connector from the back side, as
shown.
HINT:

Ignition switch ON.

Light control switch AUTO.

Vehicle's surroundings are bright.
Tester connectionConditionSpecified condition
3 ± GroundConstantContinuity
1 ± GroundIgnition switch LOCK or ACCNo voltage
1 ± GroundIgnition switch ON9.5 V or more
Vehicle is under the direct sun light.
(Sensor is not covered)Taillight and Headlight are ON.
If circuit is as specified, try replacing the sensor with a new one.
If the circuit is not as specified, inspect the circuit connected to
other parts.

BE01R±06
I01351
Headlight Beam Level Control Actuator
Height Control SensorHeadlight Beam Level Control ECU
Driver Side Junction Block

ECU±IG Fuse

GAUGE Fuse
± BODY ELECTRICALHEADLIGHT BEAM LEVEL CONTROL SYSTEM
BE±49
2350 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)
HEADLIGHT BEAM LEVEL CONTROL SYSTEM
LOCATION
The vehicle shown in this illustration is ºGS400º.
All components of ºGS300º other than the ones used for engine are same as ºGS400º.

BE0H6±08
I01356
Stop Light Switch
Driver Side Junction Block

STOP Fuse
Light Failure Sensor
Stop Lights
± BODY ELECTRICALSTOP LIGHT SYSTEM
BE±69
2370 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)
STOP LIGHT SYSTEM
LOCATION

I04053
Wire Harness Side
± BODY ELECTRICALSTOP LIGHT SYSTEM
BE±71
2372 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)
4. INSPECT HI±MOUNTED STOP LIGHT CIRCUIT
Disconnect the connector from the light and inspect the con-
nector on the wire harness side, as shown.
Tester connectionConditionSpecified condition
2 ± GroundConstantContinuity
If circuit is not as specified, inspect the power source or wire
harness.
5. INSPECT LIGHT FAILURE SENSOR
(See page DI±841 and BE±92)

BE0HH±07
I01359
Brake Master Cylinder

Brake Fluid Level
Warning Switch
Combination Meter
and Telltale Light
Assembly
Airbag Sensor Assembly Parking Brake Switch
Driver Side
Junction Block

GAUGE Fuse

SRS±B FuseIgnition Switch
ECM
Washer Tank

Washer Level
Warning Switch Engine Room No.1
Junction Block

MPX±B Fuse
Seat Belt Buckle Switch
Rheostat Light Control
ABS, TRAC and VSC ECU
Clock Assembly

Passenger Seat Belt
Waning Light
BE±80
± BODY ELECTRICALCOMBINATION METER
2381 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)
COMBINATION METER
LOCATION
The vehicle shown in this illustration is ºGS400º.
All components of ºGS300º other than the ones used for engine are same as ºGS400º.

I01360
Fuel Tank

Fuel Main
Sender Gauge
Fuel Tank

Fuel Sub
Sender Gauge
Occupant Detection Sensor
(Passenger seat belt
warning sensor)
Engine Oil Level
Warning Sensor Engine Oil Level
Warning Sensor
Park/ Neutral
Position Switch
Low Oil Pressure
Warning Switch
Park/ Neutral
Position Switch
Low Oil Pressure
Warning Switch
GS300GS400 Light Failure Sensor
± BODY ELECTRICALCOMBINATION METER
BE±81
2382 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)

I04251

Combination Meter Wiring Circuit ± 2
Left Turn Indicator
Right Turn Indicator
Hi±beam Indicator
SRS Warning
Washer Level Indicator
Headlight leveling
Indicator
Malfunction
Indicator
VSC Warning
ABS Warning
VSC OFF Indicator
SLIP Indicator IG+IG+ IG+
IG+
IG+
IG+Combination Meter ECU
A14 A15 A16 A13 A12 B18 A10 to HEAD FuseB15B3B2
A7
B12Headlight Dimmer Switch
Airbag Sensor Assembly
Washer Fluid Level
Warning Switch
Healight Leveing
Contorl ECU
ECM
ABS, TRAC and
VSC ECU Turn Singal
Flasher RelayODO/TRIP Switch
RESET Switch to Combination Meter ECU
to Combination Meter ECUU8
U3
U10
U9
U4
SRS +B BE±84
± BODY ELECTRICALCOMBINATION METER
2385 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)

Clock (Passenger seat belt warning light)
Tilt and telescopic ECU
Fuel main sender gauge
Fuel sub sender gauge
ABS, TRAC and VSC ECU (Speed signal)
Speed control unit
Headlight dimmer switch
Ground
Window washer level warning switch
Body control No.2 ECU
ECM
ABS, TRAC and VSC ECU (VSC warning light)
ABS, TRAC and VSC ECU (SLIP warning light)
ABS, TRAC and VSC ECU (TRAC OFF warning light)
ABS, TRAC and VSC ECU (ABS warning light)
ABS, TRAC and VSC ECU (Brake warning light)
GAUGE fuse
Turn signal flasher (Left turn side)
Turn signal flasher (Right turn side)
Light control rheostat (+B)
Light control rheostat (Signal)
Light control rheostat (Ground)
PANEL fuse
Airbag sensor assembly
MPX+B fuse
DOME+B fuse
HEAD±RH fuse
Igniter
Headlight beam leveling control ECU
Ground
Telltale light assembly (IG+)
Telltale light assembly (ODO/TRIP switch)
Telltale light assembly (Right turn signal)
Telltale light assembly (RESET switch)
Telltale light assembly (Left turn signal)
GroundWiring connector side No.1
1
1
2
3
4
5
6
7
8
10
11
12
13
14
15
16
17
1 1
1
2
3
4
5
6
9
12
13
14
15
16
18
22
1 1
1
3
4
8
9
10 U B A
± BODY ELECTRICALCOMBINATION METER
BE±85
2386 Author: Date:
2000 LEXUS GS300/GS400 (RM718U)