battery location MAZDA MIATA 1991 Factory Service Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 1991, Model line: MIATA, Model: MAZDA MIATA 1991Pages: 392, PDF Size: 29.45 MB
Page 136 of 392
DIAGNOSTIC TEST NO. 1
Warning Light Remains On
Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure diagnostic module
connectors are properly connected. If connector is okay, replace diagnostic module.
DIAGNOSTIC TEST NO. 2
Warning Light Flashes 3 Times
1. Measure battery voltage. If voltage is less than 9 volts, charge battery. If battery voltage is okay, check
fuses/relays in order given in FUSE/RELAY LOCATION table. See Fig. 6
or Fig. 7 .
2. If fuses and relays are okay, disable air bag system. See DISABLING & ACTIVATING AIR BAG
SYSTEM. Ensure back-up battery connector is properly connected. If connection is okay, disconnect
back-up battery connector.
Circuit (See DIAGNOSTIC TEST
NO. 2)
3Flashes 5 TimesFaulty Front Impact Sensor (See
DIAGNOSTIC TEST NO. 3)
4Flashes 10 TimesFaulty Diagnostic Module (System
Down-Fused Burned) (See
DIAGNOSTIC TEST NO. 4)
5Flashes 4 TimesFaulty Rear safing Sensor (See
DIAGNOSTIC TEST NO. 5)
6Flashes 6 TimesFaulty Air Bag Module
Poor Connection Of Clockspring
Connector (See DIAGNOSTIC
TEST NO. 6)
7 (1) Flashes 7 TimesPoor Wiring Harness Ground (See
DIAGNOSTIC TEST NO. 8)
8Flashes 8 TimesPoor Ground Of Front Impact
Sensor (See DIAGNOSTIC TEST
NO. 8)
9Flashes 9 TimesOpen Circuit Between Diagnostic
Module and Front Impact Sensor
(See DIAGNOSTIC TEST NO. 3)
10Flashes 2 TimesPoor Ground Of All Front Impact
Sensors (See DIAGNOSTIC TSET
NO. 7)
(1)Code 7 Does not apply to 1990 Miata
1991 Mazda MX-5 Miata
AIR BAG RESTRAINT SYSTEM MAZDA 1990-91 AIR BAGS
Microsoft
Sunday, July 05, 2009 2:11:16 PMPage 11 © 2005 Mitchell Repair Information Company, LLC.
Page 137 of 392
3. Reconnect negative battery cable. Measure voltage between Green/Red wire of back-up battery connector
and ground. See Fig. 8
or Fig. 9 . If voltage is zero volt, replace wire harness assembly.
4. If battery voltage is present, disconnect negative battery cable and diagnostic module Black and Gray
connectors. See Fig. 10
or Fig. 11 . Reconnect negative battery cable. Measure voltage between
White/Green wire of Gray diagnostic module connector and ground. If voltage is zero volt, replace wire
harness assembly.
5. If battery voltage is present, measure voltage between Green/Yellow wire of Gray diagnostic module
connector and ground. If voltage is zero volt, replace wire harness assembly. If battery voltage is present,
replace diagnostic module.
FUSE/RELAY LOCATION
Fuse/RelayLocation
Miata
Air Bag (15 Amps)In Fuse Block
Air Bag (10 Amps)In Main Fuse Block
Engine (15 Amps)In Fuse Block
INJ (30 Amps)In Main Fuse Block
RX7
Air Bag (15 Amps)In Fuse Block
Air Bag (30 Amps)In Main Fuse Block
Engine (30 Amps)In Main Fuse Block
Wiper (15 Amps)In Fuse Block
1991 Mazda MX-5 Miata
AIR BAG RESTRAINT SYSTEM MAZDA 1990-91 AIR BAGS
Microsoft
Sunday, July 05, 2009 2:11:16 PMPage 12 © 2005 Mitchell Repair Information Company, LLC.
Page 295 of 392
SWITCHES
SWITCHES LOCATION
MISCELLANEOUS
MISCELLANEOUS LOCATION
COMPONENT LOCATION GRAPHICS
ComponentLocation
Idle Speed Control SolenoidOn throttle body.
Purge Control Solenoid ValveOn right side of engine compartment, on shock
tower.
ComponentLocation
A/C Pressure SwitchOn high pressure refrigerant line.
Back-Up Light SwitchOn left side of transmission.
Clutch SwitchOn bracket, above clutch pedal. See Fig. 2 .
Neutral SwitchOn right rear side of transmission. See Fig. 2 .
Parking Brake SwitchOn base of parking brake lever.
Power Steering Pressure SwitchOn power steering housing assembly. See Fig. 2 .
Seat Belt Buckle SwitchOn driver's side seat belt buckle.
Stoplight SwitchOn bracket, above brake pedal. See Fig. 2 .
ComponentLocation
Diagnostic Check ConnectorOn left rear of engine compartment, near master cylinder. See Fig. 2 .
IgniterOn right rear corner of engine compartment, near fuse/relay block. See
Fig. 2
.
SRS Back-Up BatteryMounted below SRS control unit. See Fig. 3 .
NOTE: Figures may show multiple component locations. Refer to appropriate table for
proper figure references.
1991 Mazda MX-5 Miata
ELECTRICAL COMPONENT LOCATOR 1991 MAZDA ELECTRICAL COMPONENTS
Microsoft
Sunday, July 05, 2009 2:15:23 PMPage 3 © 2005 Mitchell Repair Information Company, LLC.
Page 314 of 392
FUSES & CIRCUIT BREAKERS
Fuses & Circuit Breakers 1990-95 Mazda
FUSES & CIRCUIT BREAKERS
FUSE PANEL LOCATION
Fuse box is located above driver's left knee, accessible through a removable cover. The main fuse block is
located at the right rear of the engine compartment.
The Trunk Mounted Fuse Panel is located on the right side of the trunk, near the trunk hinge. (1992-95 Models)
MAIN FUSE BLOCK IDENTIFICATION
Fig. 1: Main Fuse Block Identification
Courtesy of MAZDA MOTOR OF AMERICA, INC.
Fuse & Circuit Breaker Identification
WARNING:Always disconnect battery ground cable before servicing "high-current"
fuses. It is recommended that "high-current" fuses be replaced by a
qualified technician.
1991 Mazda MX-5 Miata
FUSES & CIRCUIT BREAKERS Fuses & Circuit Breakers 1990-95 Mazda
1991 Mazda MX-5 Miata
FUSES & CIRCUIT BREAKERS Fuses & Circuit Breakers 1990-95 Mazda
Microsoft
Sunday, July 05, 2009 2:15:54 PMPage 1 © 2005 Mitchell Repair Information Company, LLC.
Microsoft
Sunday, July 05, 2009 2:15:57 PMPage 1 © 2005 Mitchell Repair Information Company, LLC.