lock MAZDA MODEL CX-5 2017 Smart Start Guide (in English)

5 MAZDAUSA.COM
ADVANCED KEYLESS ENTRY SYSTEM
This system allows you to lock and unlock the doors without taking the key out of your pocket or purse.
While Carrying the Advanced Key…•
Unlock the driver’s door by pushing
the driver’s door request switch once.
•
Unlock all doors by pushing the
driver’s door request switch once or twice (depending on personalization
setting, p. 15) OR by pushing the passenger’s door request switch once.
•
Lock all doors (and liftgate) by
pushing any request switch once.
NOTE: Only vehicles equipped with the
Advanced Keyless Entry System allow you to lock and unlock the doors with the
door request switches (without taking the key out of your purse or pocket).
Vehicles equipped with the Keyless Entry System do not have request switches on the doors/liftgate. To lock and unlock
the doors, the corresponding transmitter button must be pushed.
Refer to your Owner’s Manual for additional
details about “Personalization Features”.
CAUTION:
The RED KEY indicator light
may illuminate on the instrument
cluster (p. 45) if the advanced key is placed in the
cup holder. The key may not be
detected in the
cup holder.
CAUTION:
Make sure the
engine is OFF and take the key with
you when leaving the vehicle.
When locking the doors using
the inside door
switches, be
careful not to leave the key
inside the vehicle
to prevent lock-out.
ADVANCED KEYLESS ENTRY
(IF EQUIPPED)
Door Request Switch
Lock
Unlock
Power
Liftgate
Panic
Alarm
2364256 17a CX-5 SSG 030117.indd 53/1/17 5:48 PM

9 MAZDAUSA.COM
POWER LIFTGATE
To open or close the liftgate from inside the vehicle:
Push the power liftgate switch on the left side of the dash.
To open the liftgate from outside the vehicle: Open the power liftgate using the electric liftgate opener or
advanced keyless remote.
To close the liftgate from outside the vehicle: Close the power liftgate by pushing the power liftgate close
switch or by using the advanced keyless remote.
Push the liftgate request switch to lock or unlock the vehicle.
The power liftgate can be changed to open to your
desired position.
To change how far the liftgate will open: Stop the liftgate at the desired position. Then push and hold the power liftgate close switch for about three seconds. A beep will
sound two times to indicate that the position change has been
completed.
NOTE: The power liftgate cannot be set to less than halfway
open.
To reset to the original position:
Open the liftgate and push and hold the power liftgate close switch
for about seven seconds. A beep will sound three times to indicate that the reset has been completed.
POWER LIFTGATE
(IF EQUIPPED)
Power
Liftgate Power Liftgate
Close Switch
Electric
Liftgate Opener Liftgate

Request Switch
Power Liftgate Switch
2364256 17a CX-5 SSG 030117.indd 93/1/17 5:49 PM

15 MAZDAUSA.COM
MAZDA CONNECT SETTINGS
To view the different setting screens: 1 Move the commander switch to the left or right to change tabs.
2 Turn the commander switch to scroll down the list.
3 When the desired tab is highlighted, push the commander switch.
NOTE: If there is a scroll bar on the right side, there are more items farther down.
MAZDA CONNECT SETTINGS
(IF EQUIPPED)
CLOCK SETTINGS
The Clock tab can be used to adjust
the time, sync the clock with GPS,
and change between 12-hour and
24-hour clock.
SAFETY SETTINGS
ACTIVE DRIVING

DISPLAY SETTINGS SOUND SETTINGS
2364256 17a CX-5 SSG 030117.indd 153/1/17 5:50 PM

m{zd{ cx-5 18
TO MAKE OR RECEIVE A HANDS-FREE CALL
Push button: To Receive/Swap a call
Push
button: To Activate Voice Recognition
•
To start a voice recognition session.
•
To skip the voice recognition system voice prompts.
Push
button: To Hang Up
•
To end a voice recognition session.
Automatic Bluetooth
® Reconnection:
•
On engine start, the last connected device will automatically be re-connected after
several seconds. If the devices do not automatically reconnect, you may manually reconnect by going to Device Setting and selecting Bluetooth
®.
• To switch devices, go to Device Settings and select Bluetooth®.
For a stable Bluetooth
® connection:
•
Make sure there is no metal object nor any obstacle blocking Bluetooth
® signal
between the vehicle’s display and your mobile device.
•
Turn OFF unnecessary applications on your mobile device. When your mobile device is
busy, it often drops Bluetooth
® connection.
•
Turn OFF energy saving mode on your mobile device.
NOTE: Some phone models do not support all features. If your phone or device does
not pair, please visit www.mazdausa.com/mazdaconnect or contact (800) 430-0153 for further assistance or to report a phone/audio device concern.
The following icons are displayed on the touchscreen during a call:
Ends a call.

Transfers a call from hands-free to the
mobile phone.

Transfers a call from the mobile phone
to hands-free.

Mutes the microphone.

Switches the call
on hold.

Allows access to the numerical keypad.
Talk
Voice Control Switch
BLUETOOTH®
Receive/SwapHang Up
2364256 17a CX-5 SSG 030117.indd 183/1/17 5:51 PM

m{zd{ cx-5 36
WIPER / WASHER CONTROL
CAUTION:
If the ignition is ON, turn
the AUTO wipers OFF
when going through a car
wash or while cleaning or touching the windshield.
WINDSHIELD WIPER / WASHER CONTROL LEVER
(IF EQUIPPED)
The rain sensor senses the amount of rainfall and
turns the wipers on or off.
Rotating the inner ring
clockwise (away from you)
creates greater wiper sensitivity and makes the
wipers move faster. The + position increases wiper
speed. Rotating the inner ring counterclockwise
(toward you) makes the wipers move
slower. The - position
decreases wiper speed.
Normal speed
Intermittent
REAR WINDOW
WIPER/WASHER

(hold as desired)
NOTE: Vehicles not equipped with AUTO wipers will have
INT wipers. Set the lever to INT and choose an interval timing by rotating the ring between fast and slow.
Pull to
dispense
windshield
washer fluid.MIST
AUTO
LO
HI
12
3
Windshield
Wiper/Washer
Control Lever
2364256 17a CX-5 SSG 030117.indd 363/1/17 5:52 PM

m{zd{ cx-5 46
INSTRUMENT CLUSTER
Type "Å" Instrument Cluster (with LCD multi-information display) shown.
Refer to Owner's Manual for type "B" instrument cluster (without multi-information display) information.
Blind Spot Monitoring OFF
(p. 33)
Seat Belt Unbuckled/Malfunction
Headlight High Beams ON
Electric Parking Brake
Brake Warning
Parking brake on/
low brake fluid/malfunction

Adaptive Front-lighting System
OFF (p. 37)
Charging System Malfunction
Mazda Radar Cruise Control
Stop & Go Function and AUTOHOLD
Door Ajar
Liftgate Ajar
Low Washer Fluid Level
Anti-lock Brake
System Malfunction
Low Fuel Level
Check Fuel Cap
Perform Maintenance
High Beam Control ON
Mazda Radar Cruise Control
ON (White)
SET (Green)
SPORT Mode ON
LED Headlight
Brake Pedal Operation Demand
Lane-keep Assist System and
Lane Departure Warning System
TPMS NOTE: Low ambient temperature and/or high altitude causes tire pressures to
drop and may turn the TPMS warning light on. If the warning light comes on, check the tire pressure and fill the tires as soon as possible, preferably before moving the vehicle
and warming up the tires. Tire pressure should be checked when the tires are cold.
See your Owner’s Manual for more details and explanations.
1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
2 Push to toggle between trip meter (A & B). When a trip meter is selected, push and hold to reset to zero.
TYPE B
Information Display
ENGINE COOLANT TEMPERATURE LIGHTS
Since this vehicle does not use an engine coolant temperature
gauge, red and blue engine coolant temperature lights are used to indicate high and low coolant temperature.
Red Coolant Temperature
FLASHING: Engine is starting to
run hot. Drive slowly to reduce
engine load.
ON: Engine is overheating.
Safely pull over to the side of the road and turn the engine off.
Refer to the Owner’s Manual for
more information. Blue Coolant Temperature
ON: Engine coolant is cold and
no warm air is available for heater/defroster.
OFF: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on for a few minutes after start-up
when the engine is cold, but the vehicle can be driven with the light on or off.
2364256 17a CX-5 SSG 030117.indd 463/1/17 5:53 PM

CUSTOMER DELIVERY CHECKLIST
VEHICLE PRESENTATION:
Refer to the Smart Start Guide during presentation.
ESSENTIAL INFORMATION
Driver’s View •
Location of Switches and Controls
Advanced Keyless Entry System*
•
Door Request Switch*
Starting the Engine
•
Accelerated Warm-up System
•
Push-Button Start System
•
Emergency Engine Stop
Tire Pressure Monitoring System
Multi-Information Display*
Power Liftgate*
Mazda Connect Infotainment System
Bluetooth®
• Pair Phone
• Make/Receive Call
• Toll-Free
Customer Service 800-430-0153
Navigation System* • SD Card
• Planning a Route
Commander / Voice Control
SAFETY AND TECHNOLOGY INFORMATION
Mazda Connect Settings*
Active Driving Display*
Mazda Radar Cruise Control*
Smart City Brake Support*
Smart Brake Support*
Lane-keep Assist System and Lane
Departure Warning System*
Distance Recognition Support System*
Electric Parking Brake / AUTOHOLD
Blind Spot Monitoring
Rear Cross Traffic Alert*
Exterior Lights
Wiper / Washer
GENERAL INFORMATION
Set Clock
Adaptive Front-lighting System (AFS)*
High Beam Control (HBC)*
Audio Controls*
• Bluetooth® Audio
• Sirius XM® Activation and Operation
Audio USB and AUX Inputs
Automatic Climate Control*
Instrument Cluster (Type A)*
•
Review of Warning and
Indicator Light Function
Automatic Transmission*
Auto-Dimming Mirror and HomeLink®*
*If equipped SCHEDULED MAINTENANCE: When replacing or topping off engine oil, use Mazda Genuine Oil. For optimal engine performance, use SAE 5W-30 engine oil. Please consult
an Authorized Mazda Dealer for additional information
.
2364256 17a CX-5 SSG 030117.indd 553/1/17 5:54 PM