sensor MERCEDES-BENZ CLS-Class 2014 W218 Workshop Manual
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2014, Model line: CLS-Class, Model: MERCEDES-BENZ CLS-Class 2014 W218Pages: 382, PDF Size: 5.36 MB
Page 364 of 382

X
Stow the jack and the res tofthe vehicle
tool sint he trunk again.
X Check the tire pressure of the newly
mounted wheel and adjus titifnecessary.
Observe the recommended tire pressure
(Y page 338).
i Vehicles with tire pressure monitor: all
wheels mounted must be equipped with
functioning sensors. Wheel and tirec
ombinationsGeneral notes
! For safety reasons, Mercedes-Benz
recommends that you only use tires and
wheels which have been approved by
Mercedes-Benz specifically for your
vehicle.
These tires have been specially adapted for
use with the control systems, such as ABS
or ESP ®
,a nd are marked as follows:
R MO =Mercedes-BenzO riginal
R MOE =Mercedes-BenzO riginal Extended
(tires featuring run-flat characteristics)
R MO1 =Mercedes-Benz Original (only
certain AMG tires)
Mercedes-BenzO riginal Extended tires
may only be usedonw heels that have been
specifically approved by Mercedes-Benz.
Only use tires, wheels or accessories
tested and approved by Mercedes-Benz.
Certain characteristics, e.g. handling,
vehicl enoise emissions or fuel
consumption, may otherwise be adversely
affected. In addition, when driving with a
load, tire dimension variations coul dcause
the tires to come into contact with the
bodywork and axle components. This could
result in damage to the tires or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tires,
wheels or accessories other than those
tested and approved. Information on tires, wheels and approved
combinations can be obtained from any
qualified specialist workshop.
Overvie wofabbreviations usedint he
following tire tables:
R BA: both axles
R FA: front axle
R RA: rear axle
The recommended pressures for various
operating conditionsc an be found:
R on the Tire and Loading Information placard
with the recommended tire pressures on
the B-pillar on the driver's side
R in the tire pressure table on the inside of
the fuel filler flap
Observe the notes on recommended tire
pressures under various operating conditions
(Y page 338).
Check tire pressures regularly,a nd only when
the tires are cold. Comply with the
maintenancer ecommendations of the tire
manufacturer in the vehicle document wallet.
Notes on the vehicle equipment –always
equip the vehicle with:
R tires of the same size on agiven axle (left/
right)
R the same type of tires at agiven time
(summer tires, winter tires, MOExtended
tires)
Vehicles with MOExtende dtires are not
equipped with aTIREFIT kit at the factory. It
is therefore recommende dthat you
additionally equip your vehicle with aTIREFIT
kit if you moun ttires that do not feature run-
flat properties ,e.g. winter tires. ATIREFIT kit
may be obtained from aqualified specialist
workshop.
i Not all wheela nd tire combinations are
available at the factory for all countries.
i On the following pages, you can find
information on approved wheelr ims and
tir es izesfor equipping your vehicle with
winter tires. Winter tires are not available 362
Wheel and tir
ecombinationsWheels and tires
Page 380 of 382

Windshield washe
rsyste mand
headlamp cleaning system
Important safety notes G
WARNING
Windshiel dwasher concentrate is highly
flammable. If it comes into contact with hot
engine components or the exhaust syste mit
could ignite. There is ariskoff ire and injury.
Make sure that no windshield washer
concentrate is spilled nex ttothe filler neck.
! Only use washer fluid that is suitable for
plastic lamp lenses, e.g. MB SummerFit or
MB WinterFit. Unsuitable washer fluid
could damage the plastic lenses of the
headlamps.
! Do not add distilled or de-ionized water to
the washer fluid container. Otherwise, the
level sensor may be damaged.
! Only MB SummerFit and MB WinterFit
washer fluid should be mixed together. The
spray nozzles may otherwise become
blocked.
Comply with the importan tsafet ynotes for
servic eproduct swhen handlin gwasher fluid
(Y page 373).
At temperatures abov efreezing:
X Fill th ewashe rfluid reservoir with amixture
of water and windshield washer fluid, e.g.
MB SummerFit.
Add 1part MB SummerFit to 100 part swater. At temperatures below freezing:
X
Fill th ewashe rfluid reservoir with amixture
of water and washer fluid, e.g. MB
WinterFit.
Adapt the mixing ratio to the outside
temperature.
R Down to 14 ‡(002210 †): mix 1part MB
WinterFit to 2partsw ater.
R Down to 00224‡(002220 †): mix 1part MB
WinterFit to 1part water.
R Down to 002220.2‡(002229 †): mix 2partsMB
WinterFit to 1part water.
i Add windshield washer fluid, e.g. MB
SummerFit or MB WinterFit, to the washer
fluid all year round. Climate control system refrigerant
Important safety notes Typ
eofr efrigerant
The climate control system of your vehicle is
The instruction label regarding the refrigerant
type used can be foun donthe radiator cross
member.
Refrigerant R-134a !
Only the refrigeran tR-134a and the PAG
oil approved by Mercedes-Ben zmay be
used. The approved PA Goil may no tbe
mixed with any other PAG oil that is not
approved for R-134a refrigerant.
Otherwise, the climate control system may
be damaged.
Service work, such as topping-u prefrigerant
or replacing components, may only be carried
out by aqualified specialist workshop .All
applicable regulations must be adhered to,
SA Es tandard J639 included.
Always have work on the climate control
system carried out at aqualified specialist
workshop. 378
Service products and filling capacitiesTechnica
ldata
filled with refrigerant sR-134a.