remove seats MITSUBISHI 3000GT 1991 Service Manual

BODY - Service Adjustment Procedures
42-17
I18FOO33
Front floor pan+ Drain plug
lFlFOO91
18FOO9132. If out of specifications, adjust as described below.@ Remove the door trim. (Refer to
P.42-41.)@ Loosen the screw attaching the inside handle and slide
the inside handle back and forth to adjust the inside
handle play.
FLOOR PAN INSPECTIONM42FIADA common result of body leaks is a soaked floor mat pad or
carpet, and it’s not unusual to find that the water is getting in
through the floor pan to some other low point
jn the body. It is
possible however, for water to enter higher up and run
downward to soak the mat.
Since a soaked mat should be removed for drying, it’s a good
way to start your check. Of course, mat removal means you’ll
have to take off door sill plates and pull out seats or seat
cushion. But, this gives you a clear field for action so you can
check body seam sealing and the plugs in the floor pan.
It’s usually not practical to water test for floor pan or
wheelhousing leaks unless a special underbody water spray
arrangement is available. As an alternate, the best way to
locate these leak points is to look for rusty seam edges or other
traces of leaks after the mats and cushions are removed.
Traces of mud are an indication that the water is coming in from
below.
TSB Revision