2 ohm MITSUBISHI ENDEAVOR 2004 Service Manual PDF

2004 BODY & ACCESSORIES
Rear Window Defogger - Endeavor
REAR WINDOW DEFOGGER GENERAL DESCRIPTION Rear Defogger operation The defogger relay turns ON if the defogger switch built-in the A/C-ECU is turned
ON when the ignition switch is in the "ON" position. When the defogger relay turns
ON, power is supplied to the defogger and the defogger is activated. The defogger
comes with a timer function that causes the defogger switch to automatically turn
OFF in about 17 minutes after the defogger switch is turned ON. EQUIPMENT DIAGNOSIS REAR WINDOW DEFOGGER DIAGNOSIS The rear window defogger is controlled by the A/C-ECU. For troubleshooting, refer
to MANUAL A/C DIAGNOSIS
.
ON-VEHICLE SERVICE PRINTED-HEATER LINES CHECK 1. Run the engine at 2,000 r/min. Check the heater element with the battery at
full.
2. Turn "ON" the rear window defogger switch. Measure the heater element
voltage with an ohmmeter at the rear window glass center A. Condition is good
if it indicates about 6 V.
2004 Mitsubishi Endeavor XLS
2004 BODY & ACCESSORIES Rear Window Defogger - Endeavor


2004 Mitsubishi Endeavor XLS
2004 BODY & ACCESSORIES Rear Window Defogger - Endeavor

Fig. 14: Checking Power Window Fuse Voltage

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
POWER WINDOW RELAY CHECK POWER WINDOW RELAY CHECK SPECIFICATION BATTERY VOLTAGE
TESTER CONNECTION
SPECIFIED
CONDITION
Not applied
4-5
Open circuit
Connect terminal
No. 3 and the
negative battery
terminal. Connect terminal
No. 1 and the
positive battery
4-5
Less than 2 ohms

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

DOOR SWITCH CHEC
K
Check continuity between the switch terminals and body ground.
DOOR SWITCH CHECK SPECIFICATION
Fig. 21: Locating Door Switch Terminal

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
DOOR GLASS AND REGULATO
R
SWITCH POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
Released (ON)
1 - body ground
Less than 2 ohms
Depressed (OFF)
1 - body ground
Open circuit

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

SWITCH POSITION
TESTER
CONNECTION
SPECIFIED
CONDITION
FRONT (LH)
UP
8-13, 9-12,
Less than 2 ohms
OFF
8-12, 9-12
Less than 2 ohms
DOWN
9-13, 8-12
Less than 2 ohms
FRONT (RH)
UP
3-13, 11-12*
Less than 2 ohms
OFF
3-11, 3-12*, 11-12*
Less than 2 ohms
DOWN
11-13, 3-12*
Less than 2 ohms
REAR (LH)
UP
1-13, 2-12*
Less than 2 ohms
OFF
1-2, 1-12*, 2-12*
Less than 2 ohms
DOWN
2-13, 1-12*
Less than 2 ohms
REAR (RH)
UP
13-14, 6-12*
Less than 2 ohms
OFF
6-14, 6-12*, 12*--14
Less than 2 ohms
DOWN
6-13, 12*--14
Less than 2 ohms
NOTE: *: Set the window lock switch to UNLOCK position.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

Fig. 26: Identifying Main Switch Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SUB SWITCH < FRONT> SUB SWITCH SPECIFICATION SWITCH POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
UP
4-5, 6-7
Less than 2 ohms
OFF
4-5, 6-8
Less than 2 ohms
DOWN
4-7, 6-8
Less than 2 ohms

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

Fig. 27: Identifying Sub Front Switch Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SUB SWITCH < REAR> SUB SWITCH SPECIFICATION SWITCH POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
UP
4-5, 6-7
Less than 2 ohms
OFF
4-5, 7-8
Less than 2 ohms
DOWN
4-6, 7-8
Less than 2 ohms

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

Fig. 34: Identifying Lock And Lever Of Front Door Latch Check (Front Door)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
DOOR LOCK ACTUATOR SWITCH INCORPORATED IN DOOR LATCH CHECK < LEFT SIDE> DOOR LOCK ACTUATOR SWITCH SPECIFICATION DOOR LOCK ACTUATOR INCORPORATED IN DOOR LATCH CHECK < RIGHT SIDE> DOOR LOCK ACTUATOR LATCH CHECK DOOR LOCK ACTUATOR SWITCH INCORPORATED IN DOOR LATCH CHECK < RIGHT SIDE> DOOR LOCK ACTUATOR SWITCH CHECK LEVER POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
At the "LOCK" position
1-2
Open circuit
At the "UNLOCK"
position
1-2
Less than 2 ohms
LEVER POSITION
BATTERY
CONNECTION
LEVER OPERATION
At the "LOCK" position
Connect terminal No.
4 and the negative
battery terminal. Connect terminal No.
6 and the positive
battery terminal.
The lever moves from
the "LOCK" position to
the "UNLOCK"
position.
At the "UNLOCK"
position
Connect terminal No.
6 and the negative
battery terminal. Connect terminal No.
4 and the positive
battery terminal.
The lever moves from
the "UNLOCK" position
to the "LOCK" position.
LEVER POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
At the "LOCK" position
2-3
Open circuit

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

REAR DOOR LOCK ACTUATOR CHECK The illustration shows when the door lock actuator is viewed from outside the door. DOOR LOCK ACTUATOR INCORPORATED IN DOOR LATCH CHECK < LEFT SIDE> DOOR LOCK ACTUATOR LATCH CHECK At the "UNLOCK"
position
2-3
Less than 2 ohms
LEVER POSITION
BATTERY
CONNECTION
LEVER OPERATION
At the "LOCK" position
Connect terminal No.
4 and the negative
battery terminal. Connect terminal No.
6 and the positive
battery terminal.
The lever moves from
the "LOCK" position to
the "UNLOCK"
position.
At the "UNLOCK"
position
Connect terminal No.
6 and the negative
battery terminal. Connect terminal No.
4 and the positive
battery terminal.
The lever moves from
the "UNLOCK" position
to the "LOCK" position.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

Fig. 35: Identifying Lock And Lever Of Front Door Latch Check (Rear Door)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
DOOR LOCK ACTUATOR SWITCH INCORPORATED IN DOOR LATCH CHECK < VEHICLES WITH THEFT ALARM
SYSTEM (LEFT SIDE)> DOOR LOCK ACTUATOR SWITCH LATCH CHECK DOOR LOCK ACTUATOR INCORPORATED IN DOOR LATCH CHECK < RIGHT SIDE> DOOR LOCK ACTUATOR LATCH CHECK DOOR LOCK ACTUATOR SWITCH INCORPORATED IN DOOR LATCH CHECK < VEHICLES WITH THEFT ALARM
SYSTEM (RIGHT SIDE)> DOOR LOCK ACTUATOR SWITCH LATCH CHECK LEVER POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
At the "LOCK" position
2-3
Open circuit
At the "UNLOCK"
position
2-3
Less than 2 ohms
LEVER POSITION
BATTERY
CONNECTION
LEVER OPERATION
At the "UNLOCK"
position
Connect terminal No.
4 and the negative
battery terminal. Connect terminal No.
5 and the positive
battery terminal.
The lever moves from
the "UNLOCK" position
to the "LOCK" position.
At the "LOCK" position
Connect terminal No.
6 and the negative
battery terminal. Connect terminal No.
4 and the positive
battery terminal.
The lever moves from
the "LOCK" position to
the "UNLOCK"
position.
LEVER POSITION
TESTER CONNECTION
SPECIFIED
CONDITION

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

DOOR LOCK KEY CYLINDER SWITCH CHECK DOOR LOCK KEY CYLINDER SWITCH CHECK At the "LOCK" position
1-2
Open circuit
At the "UNLOCK"
position
1-2
Less than 2 ohms
SWITCH POSITION
TESTER CONNECTION
SPECIFIED
CONDITION
LOCK
2-3
Less than 2 ohms
NEUTRAL (OFF)
1-2, 2-3
Open circuit
UNLOCK
1-2
Less than 2 ohms

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor