check engine NISSAN 300ZX 1984 Z31 Body Workshop Manual

BODY ALIGNMENT
All dimensions indicated in figures are actual ones.
When
a tram tracking gauge is used, adjust both pointers to equal length and check the pointers and
gauge itself to make sure there
is no free play.
When
a measuring tape IS used, check to be sure there IS no elongation, twisting or bending.
Measurements should be taken
at the center of the mounting holes.
An asterisk
(*) following the value at the measuring point indicates that the measuring point on the
other side
is symmetrically the same value.
Measurement points
The coordinates of
the measurement points are the distances measured from the respective dimension
lines in the directions of
"x", "y" and "2".
Dimension lines: "x" line - Center line of vehicle
"y" line - Center line of front axle (Any measurement point in front of the dimen-
sion line refers to
a minus "-" value.)
"2" line - Datum line (Any measurement point under the dimension line refers to
a minus "-" value.)
Engine Compartment
MEASUREMENT
____
BF-71