warning light NISSAN 300ZX 1984 Z31 Body Workshop Manual
[x] Cancel search | Manufacturer: NISSAN, Model Year: 1984, Model line: 300ZX, Model: NISSAN 300ZX 1984 Z31Pages: 77, PDF Size: 1.97 MB
Page 17 of 77
BATTERY .A,. (Via fusible link) (Theft warning system power l0"reel THEFT WARNING INDICATOR LAMP 10A Iln combination meter -
FUSE^^^^^ A ACC or ON
SWlTCl
IGNITION SWITCH 1 ST I
IGNITION SWITCH ON or ST
STARTER MC
BATTERY (Via fusible link1
BATTERY (Via fusible link1
To horn switch
TO llghtlng system
A
HEADLAMP RH
HEADLAMP LH
TO
lighting
system
POWERDOORLOCKACTUATOR gg
2 a A 0 U I-
;;
m
2 0 DOOR SWITCH IAsrirt) z z U
2
t UI I I-
R
H -I
DOOR SWITCH IDrwerI
I
(Via fusible
1
I I I I POWER DOOR LOCK SWITCH
Page 24 of 77
BODYENDANDDOOR
Theft Warning System (Cont'd)
TROUBLE-SHOOTING
0 When disconnecting the main harness connector, as instructed in this trouble-shooting, always be sure to
remove the battery ground cable
first
In trouble-shooting, if the cause of trouble is found to be due to the "Faulty sub-control AMP" or
"Faulty main control AMP", be sure to refer to "Controller inspection"
0 @ through @ indicate the respective terminals of the main harness connector (refer to Wiring
Diagram)
The term "door" indicates the driver door, assist side door, back door, and hood, unless otherwise
specif led.
The term "alarm" means
that the horn sounds intermittently and the headlamps blink 0
0 Contents
-
Will not blmk (Remains out1 -Disarmed phase
Remains blinking - Disarmed phase
Will not mme on
Will not come on
- Ready phase with key lock
- Ready phase with keyless lock and closing hood lor back door1 after
closing & locking doors
Remains lighted -Disarmed phaseand resetting
from ready phase
Will not go out (Comer on1 - Disarmed phase
Will not go out (Remains lighted1 -Armed phase
. ISset -Disarmed phase
~snot ret - Ready & armed phase
isgiven Without any cause - Armed phase
Will not operate -Alarm phase
Will not stop (Alarm continuer
over 4 minutes) -Alarm phase
stops
too soon IWIII not contlrlue
2 to 4 minutes) -Alarm phase
Continues 1,s not intermittent) -Alarm phase
0 Cannot operate
Canoperate -Alarm phase
Cannot be performed
.
- Except alarm phase
indicator lamp
Reset by unlocking power door lock
Reset by opening door
cylinder with key
4iarm
;tarter motor
3eret
IND-@
INO-@
IND-@
INO-@
IND-@
INO-@
INO-a
ARM-@
ARM-@
ALR-@
ALR-@
ALR-@
ALR.@
ALR-@
ST. @
ST- @
RES
Symbol. Condition 11 Action 0 Judgment Probable cause
BF-24
Page 30 of 77
BODYENDANDDOOR
Theft Warning System (Cont'd)
Indicator lamp will not go out (Comes on1 - Disarmed phars (Owation chart Rep @ @ Ignition witch OFF Doorsclose and unlock
(Driver, asstst side. back door and hood) .
or. or hood1 (Dperatlon chart nep @ 1
""r v
Refer to Troubleshooting, "Indicator
lamp remains lighted''- Disarmed phase
v
I
Disconnect main harness connector at subcontrol AMP
YES lndtcator
I v
Chsk power door lock wmm operation.
0 Checkcontinuity between 0-0 and NO (At least one of them)
I - 0-B wch unlocking doors
Refer to Trouble-rhootmg, "Indicator
lamp
will nor blmV - Disarmed phase
-~ (Checkat main harness sidel / YES IBoth of them1
Faulty subControl AMP
Faulty main control AMP Faulty adapter harness
Malfunctioning power door loek
system
BF-30
Page 33 of 77
BODY END AND DOOR
Theft Warning System (Cont'd)
ARM-@
Ignitton witch OFF
Doors closed & locked
(Driver. assist back door and hood)
I
NG
I
OK
I
lamp will not go out IRemainr lighted)
not ooerate - Alarm ohare"
I v
Refer to Trouble-shooting
"Indicator lamp will not come
on - Ready phase with key lock''
Refer to Trouble-shooting
"Indicator lamp will
not come on
-Ready phase with keylerr lock and closmg hood (OT back door) after
closng & locktng doors [Driver asstst
$,de and back door (or hood1 1
BF-33
Page 35 of 77
BODYENDANDDOOR
Theft Warning System (Cont'd)
ALR-O
~larm wdl not operate - Alarm phase (Operation chaR Rep @ @> )
Ignition switch OFF Any door opens without key
(Driver, assist
stde. back door or hood1
Any key cylinder draws out
(Drwer. assist side or back door1
v Check to IBLI if vehicle has besn armed check to see if indicator lamp operates NG
I normally / +
I OK I Refer to Troubleihoottng
concerning indicator lamp 1-
Disconnect main harness connector at
Check to IBB of alarm clrcun IS norml. Wtth bttery ground cable connected
and
0 (at main harness side1 grounded,
check to see
if horn rounds and head- lamps light /
YES (Both of them)
.
0 Faulty alarm circuit 0 Faultv theft warning relay - 1 I 1 I
Check ahrm wgnal When any door open or any key cylinder
draw out, check mntinuity between
@-@ (Assist door. assist tamper) @-@
(Driver door. driver tamper, back door
tamperl.
@I-@ (Backdoor) or @.@ (Hood) (Check at main harness side)
NO (All of them)
Faulty door witch circuit
Faulty door swttch ground
Faulty key cylinder tamper switch
Fault" kev cvlmder tamper witch
YES (At least one Of them1
Faulty subcontrol AMP Faulty main control AMP
Faulty adapter harness
~. .. circu I t Faulw key cylinder
Faulty key cylinder installation
Faulty harnessgrwnd
Faulty door alignment
BF-35
Page 38 of 77
BODY END AND DOOR
Theft Warning System (Cont’d)
Alarm mmtnusr (8s not intamittent) - Alarm phase IOperatlon cham step @ 1
Ignition witch OFF
Alarmphase
-
Disconnect main harness connector at
sub-control AMP
YES IAt least one of them)
1
Ched alarm errnit Connect battery ground cable to see
If horn rounds and headlampi light
NO
(Both of them) Faulty theft warning relay - 1
Faulty sub-control AMP
Faulty main control AMP
Faulty adapter harness
BF-38