brake NISSAN 300ZX 1984 Z31 Clutch Workshop Manual

HYDRAULIC CLUTCH CONTROL
(08.1 2.58 -8 71
Clutch master cylinder
Release bearing
Omrating cylinder
I3 1.4 1,22 - 301
Clutch damper
(c1 N rn (kg-m. ft-lbl
(08.12.58 -8 71
SCL16I
Precautions
0
Recommended fluid is brake fluid "DOT 3'.
Do not reuse drained brake fluid.
Be careful not to splash brake fluid
on painted
areas
When removing and installing clutch tube,
use
Tool GG94310000.
To clean or wash all parts of master cylinder,
operating cylinder and clutch damper, clean
brake fluid must be
used.
Never use mineral oils such as gasoline or
kerosene.
It will ruin the rubber parts of the
hydraulic system.
CL-2

HYDRAULIC CLUTCH CONTROL
Bleeding Procedure
0 Carefully monitor fluid level at master cylinder
during bleeding operation.
1 Top up reservoir with recommended brake
fluid
2 Connect a transparent vinyl tube to air bleeder
valve of operating cylinder
3. Fully depress clutch pedal several times
4 With clutch pedal depressed, open bleeder valve
to release air
5 Close bleeder valve.
6. Repeat steps 3 through 5 above untll clear
brake fluid comes out of air bleeder valve
-- Adjusting Clutch Pedal
or clutch witch
108-12, ir--- u I 58-87)
Dash insulator
[)ash floor panel -/
(91 N rn Ikg-rn,ft-lb)
SCL162
Pedal height "H"
Pedal free play "A"
195 - 205 mm (7.68 - 8.07 in)
1 - 3 mm (0.04 - 0.12 in)
1 Adjust pedal height with pedal stopper or
2
clutch switch
Adjust pedal free play with push rod
CL-3