glove box NISSAN 300ZX 1984 Z31 Electrical System Workshop Manual

METER AND GAUGES -Needle Type Combination Gauge
Oil Temp. Sensor Check
1 Warm up engine
2
3
Stop engine and turn ignition switch OFF
Check resistance of
oil temp sensor
SEL695D
- Boost Gauge Trimmer Adjustment -
When boost gauge does not give proper reading,
adjust
0 kPa (0 mmHg, 0 inHg) point with the
trimmer located on interlor upper wall of glove
box
Use a screwdriver to adjust trimmer
For checking oil pressure sensor and boost
sensor, refer to pages EL-53 and 56
EL-70

0 To @I (White) 0 Diode (Voice warnmg system equipped
0 To @ (Blue) (GLL models) models except CLL models) 0 To @ Wile) 0 Speakcr R H (CLL models) 0 Jomt (POI 0, sensor warning lamp) 0 Glove box lamp switch @O Glove box lamp @ Hold relay (Canada models)
0 @9 To (Black) @9 . To 0 (White)
To @ (Blue) (GLL models)
Speak; L H (GLL models)
IUumlnation control switch
Instrument swtch
L H
Instrument swtch L H
Combination meter (Black)
Combination meter (While)
Combination meter (White)
Combination meter White)
Combination meter (White)
Combination meter (Blue)
Combmation meter (Black)
Chune Instiument switch
R H
Instrument switch R H
Needle type meter
Digital type meter
& Combmation gauge (CLL models)
@ Combmalion gauge (SF and CL models)
TO COMBINATION
METER (BRAKE WARNING LAMPI
TO ENGINE ROOM H (BRAKE FLUID LEVEL SWI
6 TO MAIN H IPARKING
BRAKE SW AND VOICE
WARNING UNIT1
[For voice warnmg system1