seat adjustment NISSAN 300ZX 1984 Z31 Front Suspension Workshop Manual

FRONT AXLE - Wheel Hub
Preload Adjustment
I
After wheel bearing has been replaced or front
axle
has been reassembled be sure to adjust wheel
bearing preload
as described below
1. Before adjustment, thoroughly clean all parts
to prevent
dirt entry.
2 Apply recommended multi-purpose grease
sparingly to the following parts
Threaded portion of spindle
Contact surface between lock washer and outer
wheel bearing
Hub cap and O-ring
Grease seal lip
O-'lng7
e- "
MulttpUrpOse grease point
SMAZO3A
3 Tighten wheel bearing lock nut,
25- 29N m 12.5 - 3 0 kgm, 18.22 h-lbl
SFAS87
4. Turn wheel hub several times in both direc-
tions to seat wheel bearing correctly
5. Again tighten wheel bearing nut
6. Turn back wheel bearing lock nut within
60".
7. Fit adjusting cap and new cotter pin,
SMAlZO
8 Measure wheel bearing preload and axial play
Axial play 0 mm IO In) When bearing preloal (As meamred at wheel hub bolt1 WRh new parts
With used parts ~errthanv7~ (iakg,aoIbl
Lerrthan6 9N (07 kg. 15 Ibl SFAS88
Repeat above procedures until correct starting
torque
is obtained
9. Spread cotter pin
SRA417
10 Install hub cap with new O-ring.
I
FA- 5