oil temperature NISSAN 300ZX 1984 Z31 Maintenance Workshop Manual
[x] Cancel search | Manufacturer: NISSAN, Model Year: 1984, Model line: 300ZX, Model: NISSAN 300ZX 1984 Z31Pages: 38, PDF Size: 1.19 MB
Page 7 of 38
kmlmils Month
ENGINE ANTI FREEZE- - COOLANT
FRONT WHEEL
BEARING GREASE -
BRAKE FLUID -
DIFFERENTIAL - GEAR OIL
* Maintenance under severe driving condittons
z
tl
:
h)
whsather conditions or in areas where ambient
temperatures are either extremely low or extreme ly high, the filter might becomeclogged In such
, -1 --I-- 4 - -1 - t WINDSHIELD AND REAR
WINDOW WASHER FLUID --
-/---l--]--t-]-- POWERSTEERINGFLUID
w-1 --I- -ENGINE OIL (Except turbocharger engine)
- - @) OIL FILTER
*
--MANUAL TRANSMISSION
--AUTOMATIC
TRANSMISSION
@ Replace at the first 011 change After that. replace 011 filter every second engine 011 change
Page 14 of 38
ENGINE MAINTENANCE
Checking idle Speed (VG30E engine)
Preparation
WARNING:
a. Depress brake pedal while accelerating the engine to prevent forward surge of vehicle.
b. Inspection should
be carried out while shift lever IS in "D" position on automatic transmission equipped
models.
c. After inspection and adjustment have been made, shift the lever to "N" or "P" position.
Engage parking brake and lock both front and rear wheels with wheel chocks.
Turn
off air conditioner and headlamps.
Keep front wheels straight ahead.
c START I 1
Start engine and warm up untgl water
temperature Indicator poinrs to middle of
I
To harness 4
Stop engine and anach adapter harness between ignmon coil primary winding terminals and harness connector Then set
timer under no-load, then run engine at
+
Stop engine and connect idle UP solenoid
harness connector
Dismnnm adapter harness Connector and
connect ignition
coil harness connector io
(- END
MA-I 4
-
Page 16 of 38
ENGINE MAINTENANCE
Checking Exhaust Gas Sensor (Cont'd)
Preparation
When checking exhaust gas sensor, make sure that the following are
in good order
0 Battery
0 Hoses
Engine oil and coolant levels
E C C S. components
E.C C S. harness and connectors
Oil filler cap and oil level gauge
Checking procedure
START
Stan engine and warm UP until water
temperature indicator Points
IO middle
of gauge
I +
Run engine at about 2.000 rpm for abut
2 minutes under noload
I
E C C S control unit is turned fully
referring to MIXTURE RA
MA-1 6
Page 19 of 38
CHASSIS AND BODY MAINTENANCE
1 Check automatic transmission for signs of
leakage
SMA430A
2 Check under following conditions
(1) Place selector lever in "P" (PARK) position
and
idle engine
(2) Maintain fluid temperature at 50 to 80°C
(122 to 176'F)
(3) Add oil, if necessary
Use only A/T fluid having "DEXRON"
SMA559A
L/T Fluid
3 Check automatic fluid condition.
Check fluid for contamination to determine
condition of automatic transmission If fluid
is very dark or smells burned, the frictional
material (clutches, band,
etc ) may need re-
placement
Check flwd for COntaminarlOn
r?
,w
Check fluid for smell SMA107
MA-19