NISSAN 350Z 2007 Z33 Brake Control System Workshop Manual

VDC/TCS/ABS ACTUATOR
BRC-131
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
MA
B
BRC
Revision: 2006 November2007 350Z
VDC/TCS/ABS ACTUATORPFP:47660
Removal and InstallationNFS00051
COMPONENTS
Pay attention to the following when removing actuator.
CAUTION:

Before servicing, disconnect battery cables.

To remove brake tube, use flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use flare nut wrench (commercial service tool).

Do not remove and install actuator by holding harness.

After work is completed, bleed air from brake piping. Refer to BR-11, "Bleeding Brake System" .

Be sure to securely connect the ground cable.
SFIA0971E

BRC-132
[VDC/TCS/ABS]
G SENSOR
Revision: 2006 November2007 350Z
G SENSORPFP:47930
Removal and InstallationNFS00052
REMOVAL
1. Remove center console. Refer to IP-16, "CENTER CONSOLE" .
2. Remove harness connector.
3. Remove installation bolts. Remove yaw rate/side G sensor.
CAUTION:

Do not drop or strike the yaw rate/side G sensor, because it
has little endurance to impact.

Do not use power tool etc., because yaw rate/side G sensor
is weak for the impact.
INSTALLATION
To install, follow procedure for removal in reverse order.
CAUTION:

Do not drop or strike the yaw rate/side G sensor, because it has little endurance to impact.
SFIA0972E

STEERING ANGLE SENSOR
BRC-133
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
MA
B
BRC
Revision: 2006 November2007 350Z
STEERING ANGLE SENSORPFP:25554
Removal and InstallationNFS00053
REMOVAL
1. Remove spiral cable assembly. Refer to SRS-42, "SPIRAL CABLE" .
2. Remove steering angle sensor.
INSTALLATION
Install in the reverse order of removal.
NOTE:
After work, make sure to adjust neutral position of steering angle sensor. Refer to BRC-79, "
Adjustment of
Steering Angle Sensor Neutral Position" .
SFIA1404E

BRC-134
[VDC/TCS/ABS]
STEERING ANGLE SENSOR
Revision: 2006 November2007 350Z