headrest NISSAN TEANA 2008 Owner's Manual

SE-140
< ON-VEHICLE REPAIR >[WITHOUT VENTILATION SEAT]
REAR SEAT
REAR SEAT
Exploded ViewINFOID:0000000003840026
HEADREST FIXED TYPE
HEADREST REMOVED AND INSTALLED TYPE
1. Seat belt hook 2. Bushing 3. Armrest bracket
4. Armrest assembly 5. Cup holder 6. Seat cushion hook
7. Seat cushion pad 8. Seat cushion trim 9. Seatback pad
10. Seatback trim
Refer to GI-4, "
Components" for symbols in the figure.
JMJIA1882GB

SE-142
< ON-VEHICLE REPAIR >[WITHOUT VENTILATION SEAT]
REAR SEAT
Removal and Installation
INFOID:0000000003840027
REMOVAL
CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1. Remove the headrest.
2. Remove the seat cushion.
 Pull the lock lever (1) at the front bottom of the seat cushion
forward (1 for each side), and pull the seat cushion upward to
release the wire (2) from the seat cushion hook. Then pull the
seat cushion forward to remove.
 Remove the seat cushion from the vehicle.
3. Remove the seatback.
 Remove the bolts under seatback.
 Lift up seatback from underneath, and then remove seatback from seatback hook that is fixed to the
vehicle.
 Remove the seatback from the vehicle.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
Disassembly and AssemblyINFOID:0000000003840028
SEATBACK
Disassembly
1. Remove armrest assembly.
 Remove the pawls, and pull out the cup holder.
19. Seatback center pad 20. Seat cushion heater unit 21. Seatback heater unit
22. Seatback pad 23. Seatback trim 24. Seat belt hook
25. Headrest holder (locked) 26. Headrest holder (free) 27. Headrest side (long type)
28. Headrest side (normal type) 29. Headrest center (normal type) 30. Headrest center (long type)
31. Seatback duct C 32. Seatback duct B 33. Ventilation motor (seatback)
34. Blower filter 35. Seatback duct A 36. Ventilation seat control unit
Refer to GI-4, "
Components" for symbols in the figure.
JMJIA0251ZZ
: Pawl
JMJIA1936ZZ

REAR SEAT
SE-143
< ON-VEHICLE REPAIR >[WITHOUT VENTILATION SEAT]
C
D
E
F
G
H
I
K
L
MA
B
SE
N
O
P
 Remove the bolts (A), and then remove armrest retainer.
 Remove the armrest assembly.
2. Remove the seatback trim.
 Remove the screws, and then seat belt hook.
 Remove the headrest holder.
CAUTION:
Before installing headrest holder, check its orientation
(front/rear and right/left).
 Remove the hog rings to separate the seatback trim and seatback pad.
Assembly
Assemble in the reverse order of disassembly.
SEAT CUSHION
Disassembly
Remove the hog rings, and separate the seat cushion trim and seat cushion pad.
Assembly
Assemble in the reverse order of disassembly.
JMJIA1939ZZ
PIIB4084J