lock OLDSMOBILE AURORA 2003 Manual Online

I I
4. Near each wheel well is a notch in the frame to
position the jack head. Position the jack under
the vehicle and raise the jack head until it fits firmly
against the sheet metal.
Do not raise the vehicle
yet. Put the compact spare tire near you.
.
Getting u..-er a vehicle when it is ja,..ed up is
dangerous. If the vehicle slips
off the jack you
could be badly injured or killed. Never get
under
a vehicle when it is supported only by
a jack. Raising
, -ur vehic-- ____ h the jack imk.
Jpe..,
positioned can damage the vehicle and even
make the vehicle fall.
To help avoid personal
injury and vehicle damage, be sure to
fit the
jack
lift head into the proper location before
raising the vehicle.
5. Raise the vehicle by turning the wheel wrench
clockwise on the jack. Raise the vehicle far
enough
off the ground so there’s enough room for
the compact spare tire to fit underneath the
wheel well.
6. Remove all the wheel nuts and take off the flat tire.
5-75
ProCarManuals.com

9. Put the wheel nuts
back on with the
rounded end
of the
nuts toward the wheel.
Tighten each nut by
hand until the wheel
is held against
the hub.
If a nut cannot be tightened by hand, use the wheel
wrench, and see your dealer right away.
10. Lower the vehicle by turning the wheel wrench
counterclockwise. Lower the jack completely.
5-77
ProCarManuals.com

Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses and circuit
breakers. This greatly reduces the chance of fires
caused by electrical problems.
Look at the silver-colored band inside the fuse.
If the
band is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical
size and rating. If a MaxiFuse@ should blow, see your
dealer for service immediately.
If you ever have a problem on the road and don’t have
a spare fuse, you can “borrow” one that has the
same amperage. Pick some feature of your vehicle that
you can get along without
- like the radio or cigarette
lighter
- and use its fuse, if it is the correct amperage.
Replace it as soon as you can. You will find a fuse puller
clipped in both
of the fuse blocks. Snap the wide end
of the fuse puller at the side indentations and pull
the fuse out.
The MaxiFuses@ are located in two fuse blocks, one
located in the engine compartment and the other under
the rear seat. If a MaxiFuse@ should blow, have your
vehicle serviced by your dealer immediately.
Engine Compartment Fuse Block
The engine compartment
fuse block is located near
the front on the
Comparfment Oiewiew on
page 5-14 for more
information on location.
Lift the cover to gain access. Fuse
22 or 23 can be
moved
to the outer position to provide continuous power
to the accessory power outlet or cigarette lighter
when the ignition is not on. See your dealer for
additional assistance,
if needed.
Leaving an accessory on for a long period of time can
drain the vehicle’s battery.
5-92
ProCarManuals.com

Removing the Rear Seat Cushion
To access the battery and rear compartment fuse
panels, the rear seat cushion
must be removed. This
procedure is somewhat difficult. You may wish to have
your dealer do this for you.
Notice: The battery and main fuse blocks are
located under the rear seat cushion. The battery’s
ground terminal and some relay wires are exposed.
To help avoid damage to the battery and wires,
be careful when removing or reinstalling the seat
cushion.
Do not remove covers from covered parts.
Do not store anything under the seat, as objects
could touch exposed wires and cause a short.
To remove the rear seat cushion, do the following:
1. Pull up on the front of the cushion to release the
2. Pull the cushion up and out toward the front of the
front hooks.
vehicle.
To reinstall the rear seat cushion, do the following: A safety belt that
isn’t properly routed through
the seat cushion or
is twisted won’t provide
the protection needed
in a crash. ld the safety
belt hasn’t been routed through the seat
cushion at all,
it won’t be there to work for the
next passenger. The person sitting
in that
position could be badly injured. After
reinstalling the seat cushion, always check to
be sure that the safety belts are properly
routed and are not twisted.
5-95
ProCarManuals.com

1.
2.
Buckle the center passenger position safety belt,
then route the safety belts through the proper slots
in the seat cushion. Don’t let the safety belts get
twisted.
Slide the rear of the cushion up and under the
seatback
so the rear locating guides hook into
the wire loops on the back frame.
3. With the seat cushion lowered, push rearward and
then press down
on the seat cushion until the
spring locks on both ends engage.
4. Check to make sure the safety belts are properly
routed and that no portion
of any safety belt is
trapped under the seat.
Also make sure the seat
cushion is secured.
Rear Underseat Fuse Block
The rear fuse block is
located below the rear seat
on the driver’s side. The rear seat cushion must be
removed to access the
fuse block. See
Removing
the Rear Seat Cushion
on
page 5-95.
5-96
ProCarManuals.com

Fuses 35
36
37
38
Relays 39
40
41
42 43
44 Usage
Anti-lock Brake System (ABS)
Turn SignaVHazard HVAC Battery
Dimmer
Usage Fuel Pump
Parking Lamp
Ignition
1
Rear Fog Lamp
Not Used Park Relays
45
46
47
4%
49
50
51
52
53
54 55 Usage
Reverse
Retained Accessory Power (RAP)
Fuel Tank Door Lock
Not Used
Ignition 3
Fuel Tank Door Release
Interior Lamps
Trunk Release
Front Courtesy Lamps
Not Used Electronic Level Control (ELC)
5-98
ProCarManuals.com

At Least Twice a Year
Restraint System Check
Make sure the safety belt reminder light and all your
belts, buckles, latch plates, retractors and anchorages
are working properly. Look for any other loose or
damaged safety belt system parts.
If you see anything
that might keep a safety belt system from doing its
job, have it repaired. Have any torn or frayed safety belts
replaced.
Also look for any opened or broken air bag coverings,
and have them repaired or replaced. (The air bag
system does not need regular maintenance.)
Wiper Blade Check
Inspect wiper blades for wear or cracking. Replace
blade inserts that appear worn or damaged or that
streak or miss areas of the windshield.
Also see
“Windshield Wiper and Wiper Blades” under Cleaning
the Outside
of Your Vehicle on page 5-85.
Weatherstrip Lubrication
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth. During very cold,
damp weather more frequent application may be
required. See
Part D: Recommended Fluids and
Lubricants on page
6- 15.
Automatic Transaxle Check
Check the transaxle fluid level; add if needed. See
Automatic Transaxle Fluid on page 5-22. A fluid loss
may indicate a problem. Check the system and repair if
needed.
At Least Once a Year
Key Lock Cylinders Service
Lubricate the key lock cylinders with the lubricant
specified in Part D.
Body Lubrication Service
Lubricate all body door hinges. Also lubricate all hinges
and latches, including those for the hood, rear
compartment, glove box door, console door and any
folding seat hardware. Part
D tells you what to use. More
frequent lubrication may be required when exposed to
a corrosive environment.
6-1 0
ProCarManuals.com

Starter Switch Cher':
When you are doing this check, the vehicle
could move suddenly.
If it does, you or others
could be injured. Follow the steps below.
1. Before you start, be sure you have enough room
around the vehicle.
2. Firmly apply both the parking brake and the regular
brake. See
Parking Brake on page 2-29 if
necessary.
Do not use the accelerator pedal, and be ready to
turn
off the engine immediately if it starts.
3. Try to start the engine in each gear. The starter
should work only in PARK (P) or NEUTRAL (N).
ii ihe siarier works in any oiiler pvsiiivrl, your
vehicle needs service.
Automatic Transaxle Shift Lock Control
!- stem Check
When you are doing this check, the vehicle
could move suddenly.
If it does, you or others
could be injured.
Follow the steps below.
1. Before you start, be sure you have enough room
around the vehicle. It should be parked on a level
surface.
2. Firmly apply the parking brake. See Parking Brake
on
page 2-29 if necessary.
Be ready to apply the regular brake immediately
if
the vehicle begins to move.
but don't start the engine. Without applying the
regular brake, try to move the shift lever out
of PARK (P) with normal effort. If the shift lever
moves out
of PARK (P), your vehicle needs service.
3. With the engine off, turn the key to the ON position,
6-1 1
ProCarManuals.com

Ignition Transaxle Lock Check
While parked, and with the parking brake set, try to turn
the ignition key to OFF in each shift lever position.
The key should turn to OFF only when the shift lever
The key should come out only in OFF.
is in
PARK (P).
Parking Brake and Automatic Transaxle
Park
‘n’ “lech-ism Check
When you are doing this check, your vehicle
could begin to move. You or others could be
injured and property could be damaged. Make
sure there is room in front of your vehicle in
case it begins to roll. Be ready to apply the
regular brake at once should the vehicle begin
to move. Park
on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular brake, set the
parking brake.
To check the parking brake’s holding ability: With
the engine running and transaxle in NEUTRAL
(N), slowly remove foot pressure from the regular
brake pedal.
Do this until the vehicle is held by the
parking brake only.
ability: With the engine running, shift to PARK (P).
Then release the parking brake followed by the
regular brake.
To check the PARK (P) mechanism’s holding
Underbody Flushing Service
At least every spring, use plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly any areas where mud and other debris
can collect.
6-1 2
ProCarManuals.com

Part D: Recommended Fluids and
Lubricants
Fluids and lubricants identified below by name, part
number or specification may be obtained from your
dealer.
Usage
I Fluid/Lubricant
Engine Oil Engine oil with the
American
Petroleum Institute Certified for
Gasoline Engines starburst symbol
of the proper viscosity. To determine
the preferred viscosity for your
vehicle's engine, see
Engme Oil on
page 5- 15.
50/50 mixture of clean, drinkable
water and use only DEX-COOL
Coolant. See
Enqlne Coolant on Engine Coolant
Windshield GM Optikleen Washer Solvent or
Washer Solvent
I eauivalent.
Parking Brake Cable Guides Chassis Lubricant
(GM Part
No.
US. 12377985, in Canada
88901242, or equivalent) or lubricant
meeting requirements of NLGl #2,
Category LB or GC-LB.
GM Power Steering Fluid (GM Part
No. US. i052884, in Canada power
System 993294, or equivalent).
I Usaae I FluidLubricant
I 8,"gFEi; I Fluid. DEXRON-Ill Automatic Transmission
Y
Multi-Purpose Lubricant, Superlube
GM Part No.
U.S. 12346241, in Ke Lock
inders Lanada 10953474, or
equivalent).
Floor Shift Linkage Lubri late
Lubricant Aerosol (GM
Part
L 0. U.S. 12346293, in Canada
992723, or equivalent)
or lubricant
meeting re uirements of NLGl #2,
Cateqow
L a or GC-LB.
Hood Latch
Assembly,
Secondary
Latch, Pivots,
Sprin Anchor and
w elease
Pawl Lubri
late Lubricant Aerosol (GM
Part
R 0. US. 12346293, in Canada
992723, or equivalent) or lubricant
meeting re uirements of NLGl #2,
Category
L a or GC-LB.
Multi-Purpose Lubricant, Superlube
Hoo~,a,ngde~oor FM anada Part 10953474, No. US. 12346241, or equivalent). in
Fuel Door,
Glove
Box
Door, Console
Door and Rear
Compartment Lid Hinges Multi-Purpose
Lubricant, Superlube
(GM Part No. U.S. 12346241, in
Canada 10953474, or equivalent).
6-1 5
ProCarManuals.com