warning OPEL ANTARA 2009 Service Manual

Instruments, controls71
rPark pilot 3
Illuminates in yellow when ignition is
switched on, then extinguishes.
If it stays illuminated wh ile driving, there is
a fault in the system - see page 142.
5DCS (Descent Control System)
Both control indicators illuminate when
ignition is switched on, then extinguish.
Green
; illuminates when DCS is ready for
operation. Flashes during driving when
DCS is in operation, after pressing the
DCS button.
Yellow
; flashes to indicate system is not
ready for conditions to operate.
Illuminates to indicate there is a fault in the
system.
If the yellow control indicator flashes or
illuminates during driving, friction material
needs to cool down: drive the vehicle
without braking as much as possible.
Further information - see page 138.
BAWD (All Wheel Drive)
Illuminates in yellow when ignition is
switched on, then extinguishes.
If it flashes during driving, the AWD system
is temporarily disabled.
If it illuminates, there is a fault in the
system. Consult a workshop as soon as
possible.
Further information - see page 121.
7ESC Active & Warning
(Electronic Stability Control)
see page 136.
AESC Not Ready
see page 136.
JESC OFF
see page 136.
qAutomatic headlamp range
adjustment 3
Illuminates in yellow when ignition is
switched on, then extinguishes.
Comes on during drivin g to indicate a fault
that requires immediate attention. Consult
a workshop as soon as possible.
Further information - see page 97.
WCoolant temperature
Illuminates in red when ignition is
switched on, then extinguishes.
If it illuminates when the engine is running
:
stop vehicle and switch off engine. Coolant
temperature is too high; danger of engine
damage. Check coolant level.
Further information - see page 195.
9 Warning
Allow engine to cool down before
removing coolant filler cap.

Instruments, controls72
o
Electronic immobiliser
Illuminates in red when ignition is
switched on, then extinguishes.
If it remains illuminated after the ignition is
on, there is a fault in the immobiliser
system; the engine cannot be started -
see page 22.
9Door open
Illuminates in red when a door is open.
3Engine electronics,
transmission electronics 3
Illuminates in yellow when ignition is
switched on, then extinguishes.
If it illuminates
during driving;
there may be a fault in the engine or
transmission electronics: interrupt your
journey and consult a workshop as soon as
possible.
Further information - see page 134.
vAirbag systems 3 , belt tensioners
see pages 44, 52.
1Tailgate open
Illuminates in red when ignition is
switched on, then extinguishes.
Illuminates when tailgate is open or not
securely latched.
Tailgate - see page 26.
XDriver’s seat belt reminder
Illuminates in red when ignition is
switched on, then extinguishes.
When the engine is runn ing, if driver’s seat
belt is not engaged, it will flash for approx.
90 seconds and then illuminate until
driver’s seat belt is fastened.
If vehicle speed exceeds approx. 22 km/h
(14 mph), control indicator will flash for
approx. 90 seconds along with a warning
chime and then remains illuminated until
driver’s seat belt is fastened.
Seat belts - see page 43.
OTurn signal lamps
The relevant control indicator flashes in
green when the turn signal is on.
Rapid flash; failure of a turn signal bulb or
the corresponding fuse or failure of a trailer
turn signal bulb 3. Both control indicators
flash when the hazard warning lamps are
active.
Further information - see pages 14, 95.
Bulb replacement - see page 185.
Fuses - see page 181.
YLow fuel level
Illuminates in yellow when ignition is
switched on, then extinguishes.
If it illuminates during dr iving; fuel level low:
fill up fuel tank as soon as possible.
Never let the tank run dry.
Erratic fuel supply can cause catalytic
converter to overheat - see page 133.
Diesel engines: if the tank has been run dry,
bleed the fuel system as described on
page 171.
Refuelling - see page 132.
Fuel tank capacity - see page 225.

Instruments, controls74
aAnti-theft alarm system activation
without monitoring of passenger
compartment and vehicle tilt 3
see page 28.
IEngine oil pressure
Illuminates in red when ignition is switched
on. Extinguishes after engine is started.
Can illuminate intermit tently when idling
with hot engine; must extinguish when
engine speed is increased.
If
it illuminates during driving;
engine oil pressure may be dangerously
low, interrupting engine lubrication and
resulting in damage to the engine and/or
locking of the driving wheels:
z Move out of the flow of traffic as quickly
as possible without impeding other
vehicles,
z Depress clutch,
z Move gearshift lever to neutral
(automatic transmission to N),
z Switch off ignition. Check engine oil level before consulting
a workshop. If the oil level is low, top up
using the specified engine oil - see pages
192, 213, 217.
If the oil level is normal, have a workshop
check the vehicle’s lubricating system.
pAlternator
Illuminates in red when ignition is switched
on. Extinguishes after engine is started.
If
it illuminates during driving:
stop vehicle and switch off engine. The
battery is not being charged and the
engine cooling may be interrupted. The
brake servo unit may cease to be effective.
Interrupt your journey immediately.
Remove key and check drive belt condition
and tensioning before consulting a
workshop.
ZExhaust emissions
Illuminates in yellow when ignition is
switched on. Extinguishes after engine is
started. Can illuminate briefly when
driving; this is normal and does not
indicate a system fault.
If it illuminates when the engine is running
;
fault in emission control system.
The permitted emission limits may be
exceeded. Fuel economy and vehicle
driveability may be impaired.
The control indicator also illuminates if
there is a fault in the diesel particle filter 3.
Consult a workshop as soon as possible.
If it flashes when the engine is running
;
for a fault that can lead to destruction of
the catalytic converter, see page 134.
Consult a workshop as soon as possible.
0Winter program 3
Illuminates in yellow when Winter program
for the automatic transmission is enabled -
see page 117.
9 Warning
When the engine is off, considerably
greater force will be required for braking
and steering.
Do not remove key until vehicle has come
to a standstill, otherwise the steering
column lock could engage unexpectedly.

Instruments, controls75
Instrument display
Tachometer
Making use of the tachometer helps to
save fuel; it indicates the engine speed in
revolutions per minute (rpm).
Red warning zone on right; maximum
permissible engine speed exceeded,
danger to engine.
If possible, drive in each gear in the low
engine speed range (between approx.
2000 and 3000 rpm) and maintain an even
vehicle speed to maximise fuel efficiency. Speedometer
Indicates the vehicle speed.
Odometer
The odometer indicates how far the vehicle
has been driven.
Trip odometer
There are two independent trip odometers
which indicate how far the vehicle has been
driven since the last reset.
Press the trip odometer button once to
toggle between
Trip A and Trip B .
To reset a trip odometer, press and hold
the trip odometer button.

Instruments, controls77
Graphical information display3,
colour information display 3
Display of time, outs ide temperature, and
date/Infotainment system (when it is on).
The graphical information display presents
the information in monochrome. The colour
information display presents the
information in colour. The type of information and how it is
displayed depends on the equipment of
the vehicle and the settings of the trip
computer
3 and Infotainment system.
Some information appears on the display
in an abbreviated form.
Infotainment system – see Infotainment
system instruction manual.
An F in the display indicates a fault.
Have the cause of the fault remedied by a
workshop.Outside temperature
A fall in temperature is indicated
immediately and a rise in temperature
after a time delay.
If outside temperature drops to 3 °C,
the symbol : illuminates in the board
information display as a warning for
icy road surfaces. : remains illuminated
until outside temperature reaches at
least 5 °C.
Range257km
Aver. Consump.
7.0Ltr./100km
Inst. Consumpt.
7.6Ltr./100km
19,5° 19:36
:
11:25}-1.5°C
Range
RDS[TP]
257km

Instruments, controls78
In vehicles with graphical information
display 3 or colour information display 3,
a warning message appears on the display
as a warning for icy road surfaces. There is
no message below -5 °C. Board information display,
selecting functions
Functions and settings
of some equipment
can be accessed via the board information
display.
This is done via the menus and the buttons
on the Infotainment system or with the left
adjuster wheel on the steering wheel. The
relevant menu options are then shown on
the subsequent row of the display. Select menu items using the arrow buttons:
9 Warning
Caution: the road surface may already
be icy, even though the display indicates
a few degrees above 0 °C.
Slippery road
-2,5°C
OK
11:25}21.5°C
Range
257km
OK button Select marked item,
confirm command.

Instruments, controls79
To select using the left adjuster wheel on
the steering wheel:
If check control 3 issues a warning
message, the display is blocked from other
functions. Acknowledge the message by
pressing the OK button or the left adjuster
wheel. If there are several warning
messages, acknowledge them one at a
time. Board information display,
system settings
Press the
Settings button on the
Infotainment system. Menu item Audio or
System will appear.
Press the left arrow button to reach menu
item System and select. The first function
of the System menu is marked.
Some of the functions appear on the
display in an abbreviated form. The functions are displayed in the following
order:
z
Time synchronisation
z Time, setting hours
z Time, setting minutes
z Date, setting day
z Date, setting month
z Date, setting year
z Ignition logic
z Language selection
z Setting units of measure
Turn up Previous menu item.
Turn down Next menu item.
Press Select marked item,
confirm command.
11:25}21.5°C
System

Instruments, controls82
Average consumptionDisplay of average consumption.
The measurement can be restarted at any
time – see "Resetting trip computer
information".
Effective consumption
Displays amount of fuel consumed.
The measurement can be restarted at any
time – see "Resetting trip computer
information".
Average speed
Display of average speed.
The measurement can be restarted at any
time - see "Resetting trip computer
information".
Stoppages in the journey with the ignition
off are not included in the calculations.
Distance travelled
Displays number of kilometres (miles)
driven. The measurement can be restarted
at any time – see "Resetting trip computer
information".Range
Range is calculated fr
om current fuel tank
content and instantaneous consumption.
The display shows average values.
The vehicle updates the range
automatically after a brief delay when the
vehicle has been refuelled.
If the fuel in the tank will allow less than
50 km (30 miles) of travel, the warning
"Range" appears on the display.
If the fuel in the tank will allow less than
30 km (20 miles) of travel, the warning
"Refuel!" 3 appears on the display. Resetting trip computer information
The following trip computer information
can be reset (restart measurements):
z
Average consumption
z Effective consumption
z Average speed
z Distance travelled
Select the desired trip computer
information.
Reset by pressing the left adjuster wheel on
the steering wheel or the OK button on the
Infotainment system.
11:25}21.5°C
Range
257km

Instruments, controls84
To select using the arrow buttons:
Select menu items via menus and with
the buttons on the Infotainment system.
If check control3 issues a warning
message, the display is blocked from other
functions. Acknowledge the message by
pressing the right or left arrow button. If
there are several warning messages,
acknowledge them one at a time. To select using the multifunction knob:
To exit a menu, turn the multifunction knob
left or right to
Return or Main and select.
If check control 3 issues a warning
message, the display is blocked from other
functions. Acknowledge the message by
pressing the multifunction knob.
If there are several warning messages,
acknowledge them one at a time. To select using the le
ft adjuster wheel on
the steering wheel:
If check control 3 issues a warning
message, the display is blocked from other
functions. Acknowledge the message by
pressing the left adjuster wheel. If there are
several warning messages, acknowledge
them one at a time.
Turn Mark menu items or
commands, select functions.
Press Select marked item, confirm
command.Turn up Previous menu item.
Turn down Next menu item.
Press Select marked item,
confirm command.

Instruments, controls88
Graphical information display3 or
colour information display 3,
trip computer 3
The trip computers provide information on
driving data, which is continually recorded
and evaluated electronically.
The trip computer main page provides
information on range, average
consumption and instantaneous
consumption.
To display other trip computer data,
press the BC button on the Infotainment
system and select the trip computer menu
in the display. RangeRange is calculated fr
om current fuel tank
content and instantaneous consumption.
The display shows average values.
After refuelling, the vehicle updates the
range automatically after a brief delay. If the fuel in the tank will allow less than
50 km (30 miles) of travel, the warning
"Range" appears on the display.
If the fuel in the tank will allow less than
30 km (20 miles) of travel, the warning
"Refuel!"
3 appears on the display.
Acknowledge the menu item as described
on page 84.
Instantaneous consumption
Display changes depending on speed;
ÜBoard Computer 19,5° 19:36
BC 1 All values
BC 2
257.0kmTimerØ40km/hTyres
31.0Ltr.
Ø 7.0Ltr./100km
1
11 1
8
88
8
Range257km
Aver. Consump.
7.0Ltr./100km
Inst. Consumpt.
7.6Ltr./100km
19,5° 19:36
Display in l/h below 13 km/h.
Display in l/100 km above 13 km/h.
Range
33km
OK