ABS PEUGEOT 107 2012 Owners Manual

.
.
Contents
Horn 48
Hazard warning lamps 48
Parking brake 48
Emergency braking assistance 49
ABS, EBFD, CSC systems 49
ASR and ESP systems 50
Seat belts 51
Airbags 54
Safety
Rev counter 19
Instrument panel 19
Warning lamps 20
Distance recorder 23
Indicators 23
Setting the time 25
Instruments and controlsFamiliarisation
Keys / Remote control 26
Doors 28
Electric windows 28
Rear windows 29
Boot 29
Fuel tank 30
Access
Ventilation 33
Heating 34
Air conditioning 35
Mirrors 37
Steering wheel adjustment 37
Front seats 38
Rear seats 39
Comfort Eco-driving
Interior fi ttings 40
Boot fi ttings 41
Fittings
2 Tronic gearbox 42
Driving
Lighting control stalk 44
LED daytime running lamps 45
Headlamp adjustment 46
Courtesy lamp 46
Windscreen wiper stalk 47
Visibility

Instruments and controls
20





Warning lamps
Warning lampis onCauseAction/Observations



Parking brake

fixed. The parking brake is applied or not properly released. With
your foot on the brake pedal, release the parking brake
to switch off the warning lamp.
Observe the safety recommendations.
For more information, refer to the "Parkin
g brake" section.



STOP

fixed, associated
with another warning lamp.It is associated with the en
gine
oil pressure or the engine coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a PEUGEOT dealer or qualified workshop.



Engine oilpressure

fixed, associated
with the STOP warning lamp.The en
gine oilpressure is too low.
Stop as soon it is safe to do so.
Park, switch off the ignition and contact a PEUGEOT dealer or a qualified workshop.



Braking


fixed. The braking system fluid level has dropped significantly. Top up with brake
fluid recommended by PEUGEOT.
If the problem persists, have the system checked by a
PEUGEOT dealer or a qualified workshop.
+

fixed, associated
with the ABSwarning lamp.The braking systemhas a fault. Stop as soon as it is safe to do so. Park, switch off the ignition
and contact a PEUGEOT dealer or a qualified workshop.

1
VSC
Instruments and controls
21


Anti-lock Braking System (ABS)

fixed. The anti-lock braking system has a fault. The vehicle retains conventional brakin
g.
Drive carefully at reduced speed and contact a PEUGEOT
dealer or a qualified workshop without delay.



Electronicstability programme(ASR/ESP)

fixed. The ASR /ESP system is inaction. The system optimises traction and improves
the directional stability of the vehicle.




fix
ed. The ASR/ESP system has a fault. Have it checked by a PEUGEOT dealer or
a qualified workshop.



Coolanttemperature
fixed. The temperature of the engine coolant is too high.
Stop as soon as it is safe to do so.
Wait until the engine has cooled down before checking up thelevel; top up if necessary.
If the problem persists, contact a PEUGEOT dealer or qualified workshop.



Airbagstemporar
ily.This lamp comes on for a fewseconds when you turn on the
ignition, then goes off. This lamp should
go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or a qualified
workshop.

flashing. At least one of the airbags hasa fault. The airba
gs may not be deployed in the event of a serious
impact. Have it checked by a PEUGEOT dealer or a qualified
workshop.
Warning lampis onCauseAction/Observations

7
49 Safety





Emergency braking
assistance


In an emergency, this system enables you to
reach the optimum braking pressure morequickly and therefore reduce the stoppingdistance.
It is triggered by the speed at which the brake pedal is pressed. This is felt by a reduction in
the resistance of the pedal and an increase in
the effectiveness of the braking.
*
The CSC system is linked with the EBFD on
vehicles which are not fitted with ASR/ESP
systems.















Anti-lock braking system (ABS) and
braking systems (EBFD and CSC * )
The ABS, in conjunction with the EBFD and
CSC *
braking systems, increases the stability and manoeuvrability of your vehicle on brakingand provides improved control, in particular on poor or slippery road surfaces.
The ABS prevents wheel lock in the event of
emergency braking.
The EBFD and CSC * systems provide fullcontrol of the braking pressure wheel by wheel.A distribution between:
- the front and the rear in the case of the
EBFD (Electronic Brake Force Distribution),
- the left and the right in the case of theCSC * (Cornering Stability Control).


When changing wheels (tyres), make
sure that these are approved.

The anti-lock braking system comesinto operation automatically when thereis a risk of wheel lock.
When this warning lamp comes on,
it indicates that there is a fault with
the ABS, which could cause a loss of control of the vehicle when braking.
Contact a PEUGEOT dealer or a qualified
workshop.

When these warning lampscome on simultaneously, it
indicates that there is a fault
with the braking system or that the parking
brake has not been released fully, which cancause a loss of control of the vehicle when
braking. You must stop as soon as it is safe to do so. Contact a PEUGEOT dealer or a qualified
workshop.
Normal operation of the ABS may make itself felt by slight vibrations of the brake pedal.
In emergency braking, pressvery firmly without releasing thepressure.

8
61 Child safety
Children under the age of 10 must not travelin the "forward facing" position on the front passenger seat, unless the rear seats are already occupied by other children, cannot be used or are absent.Deactivate the passenger airbag * when a "rear facing" child seat is installed on the front seat. Other wise, the child would risk beingseriously injured or killed if the airbag were to inflate.
As a safety precaution, do not leave:


- one or more children alone and unsupervised in a vehicle,

- a child or an animal in a vehicle which is exposed to the sun, with the windowsclosed,

- the keys within reach of children insidethe vehicle.
To protect young children from the rays of the sun, fit side blinds on the rear windows.
Installing a booster seat
The chest par t of the seat belt must bepositioned on the child's shoulder without touching the neck.Ensure that the lap part of the seat belt
passes correctly over the child's thighs.PEUGEOT recommends the use of a booster seat which has a back, fitted with a seat beltguide at shoulder level.

*

According to country.
Advice on child seats
The incorrect installation of a child seat in a vehicle compromises the child's protection in the event of an accident.Remember to fasten the seat belts or the child seat harness keeping theslackin relation to the child's body to aminimum, even for short journeys.To install a child seat using the vehicle's seat belt, ensure that the belt is welltightened on the child seat and that itholds the child seat firmly against the vehicle's seat. For optimum installation of the "forward facing" child seat, ensure that the back of the child seat is in contact with the back of the vehicle's seat and that thehead restraint does not cause any discomfort. If the head restraint has to be removed,ensure that it is stored or attached
securely to prevent it from being thrownaround the vehicle in the event of sharpbraking.

70Practical information
Direction indicator side
repeaters (WY 5 W amber)
Third brake lamp
(Four W 5 W bulbs) Number
plate lamps
(W 5 W)
Do not tighten the screws more than isnecessary, to avoid the risk of breaking
the lamp.
)Pass your hand under the bumper. )Remove the bulb holder turning it onequar ter of a turn.)Remove the bulb and change it.
)
Unscrew the 2 fixing screws A.)
Release the lamp unit by pushing the two
tabs Binwards.)
Disconnect the connector and the rear screen wash pipe.)
Remove the bulb holder.)
Remove the bulb and change it.
When refitting, proceed in the reverse order
and ensure that the lamp unit seal and the rear
screen wash pipe have been put back in place correctly.
)Push the repeater forwards or rearwardsand detach it by pulling towards you. )Disconnect the bulb holder and change it.

9
73 Practical information
* Fuses located behind the instrument panel. To change them, contact a PEUGEOT dealer or a qualified workshop.
FuseN°Rating(A)Functions
110Brake lamps - ABS - 2 Tronic gearbox
225Central locking/unlocking - Remote control
320Rear screen demisting
47.5Rear lamps - Number plate lamps - Instrument panel - Screen - headlamp adjustment - LED daytime runninglamps - Sidelamps
57.5Diagnostic socket
67.52 Tronic gearbox - Rear foglamp - ESP - LED daytime running lamps - Instrument panel - Rev counter
7-Not used
87.5
ABS/ESP - Power steering - Fan assembly
910Reversing lamps - Central locking/unlocking - Electric windows - Rear screen demisting - Speedometer - Air conditioning - Heating - Rev counter - Remote control
1020Front and rear wipers and screenwash
1115
Audio equipment - 12 V socket (120 W max)
127.5Heated rear screen - ABS - Fan assembly - Front and rear wipers and screenwash - Power steering - Central locking/
unlocking - Air conditioning - Heating - Electric windows - Speedometer - Rev counter - Remote control - Reversing lamp
1315
Airbag - Fuel injection system - 2 Tronic gearbox - Instrument panel - Rev counter - LED daytime running lamps
147.5 Air conditioning - Heating
15 *40
Audio system - 12 V socket - Front and rear wipers - Power steering - ABS/ESP - Cooling fan assembly
16 * 30Electric windows
17 *40
Air conditioning - Heating

9
75 Practical information
FuseN°Rating(A)Functions
15 LED daytime running lamps
220
Front foglamps
310
Left hand front lamp
410
Right hand front lamp
57.5 2 Tr o n i c gearbox - Fuel injection system
67.5
2 Tronic gearbox - Fuel injection system


730
LED daytime running lamps - Front foglamps
825
ABS
30
ABS/ESP (with VSC)
930
Starter motor - Heated rear screen - ABS -Cooling fan assembly - Front and rear wipers and screenwash - Power steering - Central locking/unlocking - Air conditioning - Heating - Electric windows - Speedometer -Rev counter - Remote control - Reversing lamp - Airbag - Fuel injection system - 2 Tronic gearbox - Instrument panel - LED daytime running lamps
FuseN°Rating(A)Functions
1010 Hazard warning lamps - Instrument panel - Rev counter - Direction indicators
1120
Left hand front lamp - Right hand front lamp
1215 Cour tesy lamp - Speedometer - Audiosystem- Instrument panel - Rev counter
1315
Fuel injection system - Cooling fan assembly
1410
Horn
157.5
Replacement fuse
1610
Replacement fuse
1715
Replacement fuse
1850 2 Tr o n i c gearbox
1930/40 Cooling fan assembly
20
40 ABS
50 ABS/ESP (with VSC)
2150
Power steering

80Practical information





Towing the vehicle
)
Install the towing bar. )
Put the gear lever into neutral (position Nfor the 2 Tronic gearbox).
)Take the removable towing eye stowed in
the spare wheel, under the boot carpet.
)Unclip the plastic cover. )Fully screw in the towing eye.

General
recommendations
Observe the legislation in force in your country.Ensure that the weight of the towing vehicle is higher than that of the towedvehicle.The driver must stay at the wheel of thetowed vehicle. Driving on motorways and fast roads is prohibited when towing.When towing a vehicle with all four wheels on the ground, always use an approved towing bar; rope and strapsare prohibited.When towing a vehicle with the engine off, there is no longer any power assistance for braking or steering.In the following cases, you must always call on a professional recovery service:- vehicle broken down on a motor way
or fast road,- when it is not possible to put the gearbox into neutral, unlock thesteering, or release the parkingbrake,- towing with only two wheels on theground, - where there is no approved towingbar available...

Your vehicle can only be towed at the front.
Never use the radiator crossmember.
To w i ng with fours wheels on theroad must be carried out at very low speed over a very shor t distance (in accordance with the legislation in force).
In all other cases, your vehicle must betranspor ted on a trailer.

Failure to obser ve this instruction maylead to damage to cer tain components (braking, transmission, ...) and the absence of braking assistance when theengine is started.
)
Unlock the steering by turning the key to
the first position and release the parkingbrake. ) Switch on the hazard warning lamps onboth vehicles.

113
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWER SOLUTION
There is a difference in sound quality between
the different audiosources (radio, CD...).
For optimum sound qualit
y, the audio settings (Bass, Treble, Ambience, loudness) can be adapted to the different sound sources, which mayresult in audible differences when changing source (radio, CD...).
Check that the audio settings (Bass, Treble, Ambience, Loudness) are adapted to the sources listened to. It is advisable to adjust audio settings
Bass, Treble, Front-Rear balance, Left-Right balance)to the middle position, select the musical ambience
and set the loudness correction to the "Active" position
in CD mode or to the "Inactive" position in radio mode.
When chan
ging the settings for treble andbass, the ambience setting is deselected.

When changing the
ambience setting, treble
and bass are reset to zero.Choosin
g an ambience imposes settings for treble and bass. Modifyingone without the other is only possible with a personalised ambience. Modify the treble and bass settings or the
ambience setting to obtain the desired sound quality.
The qualit
y of receptionof the radio station listened to graduallydeteriorates or the stored stations do not function(no sound, 87.5 MHz is
displayed...). The vehicle is too far from the transmitter used b
y the station listened
to or there is no transmitter in the geographical area through which the
vehicle is travelling.
Activate the RDS function to enable the system
to check whether there is a more powerful
transm
itter in the geographical area.
The environment
(hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode. This phenomenon is normal and does not indicate
a failure of the audio equipment.
The aerial is absent or has been damaged
(for example when going
through a car wash or into an underground car park). Have the aerial checked by a PEUGEOT dealer.

Sound cut-outs of 1 to
2 seconds in radio mode.During this brief sound cut-out, the RDS searches for any frequency
permitting better reception of the station. Deactivate the RDS function if the phenomenon is
too frequent and always on the same route. The
following tables contain answers to the most frequently asked questions.