wheel Peugeot 206 CC 2003 User Guide

YOUR 206 CC IN DETAIL95
For the front and side* air bags to be fully effective, observe the following safety rules:
¥ Wear a correctly adjusted seat belt.
¥ Sit in a normal upright position.
¥ Do not leave anything between the occupants of the front seats and the air bags (a child, pet, object...). This could hamper the operation of the air bags or injure the occupants.
¥ All work on the air bag system is strictly forbidden unless it is carried out by qualified personnel of the PEUGEOT network.
¥ After an accident or if the vehicle has been stolen or broken into, have the air bag systems checked. Front air bags
¥ Do not drive holding the steering wheel by its spokes or resting your hands on the centre part of the wheel.
¥ Passengers must not place their feet on the fascia.
¥ Smoke as little as possible; deployment of the air bags can cause burns or the risk of injury from a cigarette or pipe.
¥ Never remove or pierce the steering wheel or hit it violently. Side air bags*
¥ Only put approved covers on the front seats. Contact your PEUGEOT dealer.
¥ Do not fix or glue anything to the front seat backs. This could cause injury to the chest or arms when the side air bag inflates.
¥ Do not sit with the upper part of the body any nearer to the door than necessary.
* According to destination.
30-06-2003

30-06-2003
PRACTICAL INFORMATION
100
PUNCTURES Because this version does not pos- sess a spare wheel, you have twoaerosols for temporary tyre repairsstored in an insulated storage box
1
secured by a strap to the right-handside of the boot. Using a repair aerosol (See also the instructions on the aerosols). 
If possible remove the foreign body which caused the puncture.
 Position the wheel so that thevalve is at the 2 o'clock or 10o'clock position.
 Shake the aerosol vigorously
before use. (In very cold weather,warm the aerosol for a few min-utes in your hands).
 In one hand hold the valve.
 With the other, firmly push thespray end of the aerosol onto thevalve, keeping it centralised.
 Maintain the pressure firmly forone minute, then immediatelydrive at moderate speed to the
nearest garage. Aersosols enable a tem-porary repair to be car-ried out (maximum speed50 mph (80 km/h)).
After use, it is necessary toreplace the tyre. Because the aerosols are pres- surised, they must not be exposedto a temperature higher than
50 ¡C. Keep them away from heat in their insulated storage box.

30-06-2003
PRACTICAL INFORMATION101
CHANGING A WHEEL 
Park the vehicle on level, stable
ground which is not slippery.
 Apply the handbrake, engage first
gear or reverse (position Pon the
automatic gearbox) and switch offthe ignition.
 Chock the rear of the wheel withshim 2diagonally opposite the
wheel to be changed.
Tools for changing a wheel 1 - Wheelbrace fitted to the lining of the boot on the rear right side.
2 - Shim stored in the jack bag.
3 - Jack (in a bag secured by twostraps, on the right-hand side ofthe boot).
4 - Tool for removing wheel bolttrims (located on the boot rearright inner panel). Removing the wheel 
Remove the wheel trim using the wheelbrace 1by pulling next to the valve.
 Loosen the wheel bolts (for vehicles fitted with alloy wheels, remove the chrome wheel bolts first; see "Features of alloy wheels", following page).
 Position the jack 3at one of the four locations Aunderneath the vehicle, as
close as possible to the wheel to be changed. Ensure that the entire surfaceof the jack base plate is in contact with the ground.
 Extend the jack 3.
 Remove the bolts and release the wheel.

30-06-2003
PRACTICAL INFORMATION
102
Refitting the wheel 
After positioning the wheel, pre-tighten the bolts using the wheelbrace 1.
 Compress the jack 3and release it.
 Fully tighten the bolts using the wheelbrace 1.
 Replace the wheel trim, starting at the valve passage hole, and press on it using the palm of the hand.
Replace the shim and the jack in their bag, then store the tools in the boot.For your safety, always change the wheel:
- on level, stable and non-slippery ground,
- with the handbrake applied and the ignition switched off,
- with the first or reverse gear engaged (position Pfor the auto-
matic gearbox),
- with the vehicle chocked using a shim.
Never go underneath a vehiclewhich is supported only by a
jack (use an axle stand) .
After changing the wheel:
- As soon as possible contact a PEUGEOT dealer to check that the wheel bolts are tight.

30-06-2003
PRACTICAL INFORMATION103
SPECIAL FEATURES OF
ALLOY WHEELS Bolt covers The bolts on the alloy wheels are covered with chrome-plated trimcaps. Remove them using the yellow tool 4
before slackening the bolts. Refitting the spare wheel* If your vehicle is fitted with a steel spare wheel, when fitting the wheelit is
normal to notice that the bolt
washers do not come into contact
with the wheel. The spare wheel isheld in place by the conical supportof each bolt. Fitting snow tyres If you fit snow tyres mounted on steel rims onto your vehicle, it isessential to use special bolts avail-
able from a PEUGEOT dealer. Wheel anti-theft bolts* If your wheels are fitted with anti- theft bolts (one per wheel), thechrome-plated trim cap and then theplastic cover on the wheel must beremoved, using tool
4, before slack-
ening the bolt using one of the anti-theft sockets (handed to you alongwith the duplicate keys and the con-fidential card on delivery of yourvehicle) and the wheelbrace 1.
Note: take a careful note of the code
number engraved on the head of the
anti-theft socket. This will enableyou to obtain a duplicate anti-theft
socket from a PEUGEOT dealer.
* According to model and destination.

30-06-2003
PRACTICAL INFORMATION109
Fuse Rating
Functions
1 15 A Alarm siren
4 20 A Multifunction display - Navigation control unit - Boot lighting - Radio - Retractable roof control unit
5 15 A Automatic gearbox diagnosis
6 10 A Coolant level - Automatic gearbox - Radio - Steering wheel angle sensor (ESP)
7 15 A Driving school accessories - Alarm - Rain sensor
9 30 A Hydraulic pump
10 40 A Exterior mirror demisting 11 15 A Wiper
12 30 A Front windows
14 10 A Engine fuse box - Air bags - Steering wheel stalks
15 15 A Instrument panel - Multifunction display - Navigation control unit - Air conditioning - Radio
16 30 A Door locking / unlocking controls - Deadlocking controls
20 10 A Right brake light
21 15 A Left brake light - 3rd brake light
22 20 A Front courtesy light - Glove box lighting - Cigarette lighter
S1 Shunt PARC shunt

30-06-2003
PRACTICAL INFORMATION
114
Without lifting (four wheels on the ground)
You must always use a tow bar. From the front or the rear Attach the tow bar to the towing eye. By lifting (two wheels only on the ground) It is preferable to lift the vehicle by the wheels. Special features of the automatic gearboxes When towing with all four wheels on the ground, the following rules mustbe adhered to:
- gear lever in position
N,
- tow the vehicle at a speed less than 30 mph (50 km/h) over a dis- tance of not more than 30 miles(50 km),
- do not add oil to the gearbox. BOOT LUGGAGE CARRIER*
A boot luggage carrier is available
from your PEUGEOT dealer. This equipment is not compatible
with the fitting of a rear spoiler. When it is used, take care not to conceal the third brake light. Follow the manufacturer's recom- mendations.
* Available as an accessory.
TOWING YOUR VEHICLE
Never use the radiator crossmember.

30-06-2003
PRACTICAL INFORMATION123
206 CC ACCESSORIES
For your PEUGEOT only use accessories and original parts approved by the manufacturer.
These accessories and parts are all adapted to your PEUGEOT, after being tested and approved for reliability and
safety, which PEUGEOT cannot guarantee for other products.
A wide choice of original accessories, approved by PEUGEOT, is available through the dealer network. They all carry
the PEUGEOT guarantee. Safety:
Anti-theft alarms, lift detection alarm, window engraving, wheel locks, warning triangle, first aid kit, ...
Protection: Covers suitable for side air bags, mats, boot storage tray, É
Communication: Telephone, satellite navigation system, CD changers, audio systems, speakers, audio trim, ...
Personalisation: Alloy wheels, trims, mud flaps, aluminium and wood panel trim, ...
Comfort: Centre armrest, can holder, CD or cassette storage, telephone console, anti-air swirl net, ....
Leisure: Towbar, boot luggage-rack , snow chains, ...
Children: Booster seats and child seats, Kiddy Isofix seat, ...
Maintenance products: Screenwash, interior and exterior maintenance and cleaning products.
Before fitting an electrical accessory to your vehicle, consult a PEUGEOT dealer.

30-06-2003
TECHNICAL DATA127
IDENTIFICATION FEATURES OF YOUR 206 CC
A. Manufacturer's plate.
B. Serial number on the bodywork (in the boot).
C. Serial number on the fascia.
D. Tyres.
The label Don the pillar of the driver's door, near the hinges, gives:
- the wheel and tyre sizes,
- the brands of tyres* approved by the manufacturer,- the tyre pressures (the tyre pressure must be checked when the tyre is cold, at least once a month) ,
- the paint colour reference*.
E. Fuel consumption* in the corner of the windscreen. * According to destination.