display Peugeot 208 2015 User Guide

33
208_en_Chap01_instruments-bord_ed01-2016
Date and time
Press MENU to display the " MAIN
MENU ".
Select "Adjust time " or "Adjust date".
Touch screen
Select " Settings ".
In the secondary page, select " Time/
Date ".
Select "
Secondary page ".
Modify the setting using the virtual keypad then
confirm.Press "Confirm " to save and quit.
Instrument panel
F Each press of this button moves between
the following settings:
-
hours,
-


minutes,
-

1
2 or 24 hour format.
1
Instruments

34
208_en_Chap01_instruments-bord_ed01-2016
Lighting dimmer
Tw o b u t t o n s
With the exterior lighting on:
One button
F Press this button to increase the brightness. F
P ress this button to
adjust the brightness,
F

P
ress this button to
reduce the brightness. F

r
elease the button when the desired level is
reached.
As soon as the lighting reaches the required
level of brightness, release the button. System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
With the vehicle lighting off or in day
mode (daytime running lamps on),
pressing the button has no effect.
Touch screen
F Select " Screen settings" .
F Press
MENU

to display the "MAIN
MENU" .
F Select
"Settings" .
F Select
"Secondary page" .
Adjustment
F

A

djust the brightness by moving the cursor.
Instruments

Access43
208_en_Chap02_ouvertures_ed01-2016
Boot
Using the key.
Using the remote control.
Opening Closing
F Lower the tailgate using the interior grab
handle.
F

I
f necessary, press down on the tailgate to
fully close it.
With the engine running , this is
signalled by:
-

t
his warning lamp coming on,
-

a
n alert message displayed for a
few seconds.
With the vehicle moving (speed higher than
6 mph (10 km/h)), this is signalled by:
-

t
his warning lamp coming on,
-

a
n alert message displayed for a
few


seconds,
-
an

audible signal.
Boot still open
F After unlocking the boot or the vehicle, press the opening control which releases
the tailgate, and then guide it open.
Tailgate release
System for mechanical unlocking of the boot in
the event of a central locking malfunction.
Unlocking
F Fold back the rear seats to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
Advice
2

Ease of use and comfort
64
208_en_Chap03_ergonomie-confort_ed01-2016
On entering the vehicle, if the interior
temperature is much colder or warmer
than the comfort value, there is no need
to alter the value displayed in order to
obtain the required level of comfort.
The system corrects the temperature
difference automatically and as quickly
as possible.
Auto - Visibility programme
F Press the "visibility" button for
faster demisting or defrosting
of the windscreen and side
windows.
Switching off Switching on The air conditioning is designed to operate
efficiently in all seasons, with the windows
closed.
It allows you:
-

i
n summer, to lower the temperature,
-
i
n winter, above 3 °C, to improve demisting.
Air conditioning
Switching on
Switching off
F

P

ress the "visibility" button
again or the "AUTO" button, the
indicator lamp in the button goes
off and the indicator lamp in the
"AUTO" button comes on.
The system reverts to the previous settings
used. F

P

ress the "AUTO"
button again
to return to the automatic comfort
programme.
The system automatically manages the air
conditioning, and the air intake, flow and
distribution to the windscreen and side
windows to the best effect. For maximum cooling or heating of
the passenger compartment, you can
exceed the minimum value of 14 or the
maximum value of 28.
F

P

ush the button down
until "LO" is displayed or
up until "HI" is displayed. F

P
ress the "A/C" button, the
associated indicator lamp comes
on.
The air conditioning cannot operate when the
air flow is set to off.
F

P
ress the "A /C " button again;
the associated indicator lamp
goes off.
Switching off may cause some problems
(humidity, misting).

Ease of use and comfort65
208_en_Chap03_ergonomie-confort_ed01-2016
Avoid prolonged operation in interior air
recirculation mode (risk of misting and
of deterioration of the air quality).
Switching the system off
Air intake/Air recirculation
F Press this "full fan" button to
increase the air flow.
Air distribution
F Press the "empty fan" air flow
button until the fan symbol
disappears and "---" appears.
This action switches off all of the functions of
the air conditioning system.
The temperature is no longer maintained at a
comfortable level. However, a slight flow of air,
due to the movement of the vehicle, can still
be felt.
F

P

ress this button to recirculate
the interior air. The indicator
lamp in the button comes on and
the air recirculation symbol is
displayed.
Air recirculation prevents exterior odours
and fumes from entering the passenger
compartment. It is activated automatically when
operating the screen wash.
F

P

ress this button several times in
succession to direct the air flow
in turn towards:
-

t

he windscreen, the side windows and the
footwells,
-

t

he windscreen and side windows
(demisting or defrosting),
-
t
he central and side vents,
-

t

he central vents, the side vents and the
footwells,
-

t

he footwells.
Air flow
The air flow symbol (a fan) appears in the
screen. It is filled in progressively in relation to
the value required. F

P
ress this "empty fan" button to
reduce the air flow. Avoid driving for too long with the
system switched off (risk of misting and
of deterioration of the air quality).
Switching on
Switching off
Manual mode
Depending on your requirements, you can
make a different selection from that offered by
the system by changing a setting. The other
functions will still be controlled automatically.
F

A

s soon as possible, press
this button again to permit the
intake of exterior air and prevent
misting. The indicator lamp in the
button goes off. When you modify a setting, the indicator lamp
in the "AUTO"
button goes off.
Pressing the "full fan"
button reactivates the system
with the settings prior to
deactivation.
3

Ease of use and comfort
72
208_en_Chap03_ergonomie-confort_ed01-2016
Ports and sockets - Connectivity
12 V socket
F To connect a 12 V accessory (maximum power: 120 Watts), lift the cover and
connect a suitable adaptor.
Do not exceed the maximum power
rating of the socket (otherwise there is a
risk of damaging your portable device).
USB port / Jack auxiliary socket
This connection box, consisting of an USB port
and a JACK auxiliary socket is located on the
centre console.
It allows the connection of portable device,
such as a digital audio player of the iPod
® type
or a USB memory stick.
It reads the audio files which are transmitted to
your audio system and played via the vehicle's
speakers.
You can manage these files using the steering
mounted controls or the audio system control
panel and display them in the instrument panel
screen. For more information on the use of this
system, refer to the "Audio equipment
and telematics" section.
When the USB port is used, the portable device
charges automatically.
While charging, a message is displayed if the
current drawn by the portable device exceeds
the power rating of the vehicle's port.
The connection of an electrical device
not approved by PEUGEOT, such as a
USB charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor telephone
reception or inter ference with displays
in the screens.

78
Manual mode
Lighting off (ignition off) / Daytime
running lamps (engine running).
Sidelamps only.
Dipped or main beam headlamps.
Dipping the headlamps
Pull the stalk to switch the lighting between
dipped / main beam headlamps.
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining a
pull on the stalk.
Display
Illumination of the corresponding indicator lamp
in the instrument panel confirms the lighting
switched on.
Place the desired symbol against the marking.
Lighting and visibility

79
The sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver, when a low level of
ambient light is detected or in certain cases of
activation of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.
AUTO mode
On
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied
by a message in the screen.
Off
F Turn the ring to another position. Deactivation of the function is
accompanied by a message in the screen.
Automatic guide-me-home
lighting
Association with the automatic lighting provides
the guide-me-home lighting with the following
additional options:
-

s
election of the lighting duration of 15, 30
or 60 seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation. In the event of a fault with the
sunshine sensor, the lighting comes
In fog or snow, the sunshine sensor
may detect sufficient light. In this
case, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind the rear view mirror; the
associated functions would no longer
be controlled.
Configuration
Press "MENU" to display the "MAIN
MENU" .
Select "Driving" .
Select "Secondary page" .
Select the "Driving assistance" tab.
Activate the "Guide me home"
function. Select "Vehicle settings" .Switching off
Switching on Deactivate the "Guide me home"

function.
on, this warning lamp is displayed in the
instrument panel and/or a message appears in
the screen, accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualified
workshop.
4
Lighting and visibility

87
Wipers
Manual mode
The wipers are controlled directly by the driver.
Front
Wipe
Fast (heavy rain).
Normal (moderate rain).
Intermittent (proportional to the
speed of the vehicle).
Park.
Single wipe (press down and
release).
Switching on
Briefly push the control stalk downwards.
A wiping cycle confirms that the instruction has
been accepted.This warning lamp comes on in the
instrument panel and a message is
displayed. This warning lamp goes off in the
instrument panel and a message is
displayed.
Switching off
Briefly push the control stalk downwards again,
or place the control stalk in another position
(Int, 1 or 2).
AUTO mode
The windscreen wipers operate
automatically, without any action
on the part of the driver, when rain
is detected (sensor behind the rear
view mirror), adapting their speed to
the intensity of the rainfall.
4
Lighting and visibility

88
Rear
If a significant accumulation of snow or
ice is present, or when using a bicycle
carrier on the boot, deactivate the
automatic rear wiper via the vehicle
configuration menu.Park.
Intermittent wipe.
Wash-wipe (set duration).
Reverse gear
When reverse gear is engaged, the rear wiper
will come into operation if the windscreen
wipers are operating. On
Press "MENU" to display the " MAIN
MENU ".
Select "Driving" .
Select "Secondary page" .
Select "Vehicle settings" .
Select the "Driving assistance" tab.
Activate the "Auto rear wiper in
reverse" function.
Configuration
This function is activated by default.
Off
Deactivate the "Auto rear wiper in reverse"
function.
The automatic rain sensitive windscreen
wipers must be reactivated by pushing
the control stalk downwards, if the
ignition has been off for more than
1


minute.
Do not cover the rain sensor, linked with
the sunshine sensor, located at the top
of the windscreen behind the rear view
m i r r o r.
Switch off the automatic rain sensitive
wipers when using an automatic car wash.
In winter, it is advisable to wait until the
windscreen is completely clear of ice
before activating the automatic rain
sensitive wipers.
Single wipe
Pull the stalk briefly towards you.
Unusual operation
If the wipers operate in intermittent mode when
in AUTO mode, have the system checked by a
PEUGEOT dealer or a qualified workshop.
Lighting and visibility