key Peugeot 208 2015 User Guide

Access
40
208_en_Chap02_ouvertures_ed01-2016
From the inside
Locking
Driving with the doors locked may make
access to the passenger compartment
by the emergency services more
difficult in an emergency.
If one of the doors is open, locking of
the doors from the inside does not take
place. When locking / deadlocking from
outside
When the vehicle is locked or
deadlocked from outside, the switch
does not operate.
F
A
fter normal locking, pull the
interior door lever to unlock the
vehicle.
F

A

fter deadlocking, you have to use
the remote control or the key to
unlock the vehicle.
Automatic central locking
The doors can lock automatically while driving
(speed above 6 mph [10 km/h]).
To turn this function on or off (on by default).
F

P

ress the button.
This allows the doors and the boot to be locked.
The indicator lamp in the button comes on.
Unlocking
F Press the button again.
The indicator lamp in the button goes off. F

p
ress and hold the button until
there is an audible signal and/or
a message in the screen.

Access
42
208_en_Chap02_ouvertures_ed01-2016
Deactivation of the volumetric monitoring
Tilt monitoring is deactivated, if fitted to your
vehicle.
F
S
witch off the ignition.F

W
ithin ten seconds, press the
button until the indicator lamp is
on continuously.
F

G
et out of the vehicle.
F

P
ress the locking button on the
remote control immediately.
To be effective, the deactivation must
be carried out each time the ignition is
switched off. F

L
ock or deadlock the vehicle using
the key in the driver's door lock.
Locking the vehicle without
activating the alarm
Triggering of the alarm
When the alarm is triggered the siren sounds and
the direction indicators flash for thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.
When the vehicle is unlocked using
the remote control, rapid flashing
of the indicator lamp in the button
informs you that the alarm was
triggered during your absence.
When the ignition is switched on, this
flashing stops immediately.
Advice
Remote control fault
To deactivate the monitoring functions:
F U nlock the vehicle using the key in the
driver's door lock.
F

O
pen the door; the alarm is triggered.
F

S
witch on the ignition; the alarm stops. The
indicator lamp in the button goes off.
Alarm fault
When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second.
Protection - perimeter
monitoring only
Deactivate the interior volumetric monitoring
(and tilt monitoring, if fitted to your vehicle)
to avoid unwanted triggering of the alarm in
certain cases such as:
-
t
he presence of a pet in the vehicle,
-

a w
indow partially open,
-
w

ashing your vehicle.

Access43
208_en_Chap02_ouvertures_ed01-2016
Boot
Using the key.
Using the remote control.
Opening Closing
F Lower the tailgate using the interior grab
handle.
F

I
f necessary, press down on the tailgate to
fully close it.
With the engine running , this is
signalled by:
-

t
his warning lamp coming on,
-

a
n alert message displayed for a
few seconds.
With the vehicle moving (speed higher than
6 mph (10 km/h)), this is signalled by:
-

t
his warning lamp coming on,
-

a
n alert message displayed for a
few


seconds,
-
an

audible signal.
Boot still open
F After unlocking the boot or the vehicle, press the opening control which releases
the tailgate, and then guide it open.
Tailgate release
System for mechanical unlocking of the boot in
the event of a central locking malfunction.
Unlocking
F Fold back the rear seats to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
Advice
2

Access
44
208_en_Chap02_ouvertures_ed01-2016
Changing the battery
Battery ref.: CR1620 / 3 volts. If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.
F

U
nclip the cover using a screwdriver in the
cutout.
F

R
emove the cover.
F

E
xtract the flat battery from its location.
F

P
lace the new battery into its location
observing the original direction.
F

C
lip the cover in place.
Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Remote control problem
Reinitialisation
F Switch off the ignition.
F
T urn the key to position 2 (Ignition) .
F

P
ress the closed padlock immediately for a
few seconds.
F

S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again.
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F

F

irst of all, use the key in the lock to unlock
or lock your vehicle.
F

T

hen, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.

Access45
208_en_Chap02_ouvertures_ed01-2016
Lost keys
Go to a PEUGEOT dealer with the vehicle's
registration document, your personal
identification documents and if possible the
key code label.
The PEUGEOT dealer will be able to look
up the key code and the transponder code
required to order a new key.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while it is
in your pocket as there is a possibility that
it may unlock the vehicle, without you being
aware of it.
Do not repeatedly press the buttons of your
remote control out of range and out of sight
of your vehicle. You run the risk of stopping
it from working and the remote control
would have to be reinitialised.
No remote control can operate when the
key is in the ignition switch, even when
the ignition is switched off, except for
reinitialisation.
Anti-theft protection
Do not make any modifications to the
electronic engine immobiliser system; this
could cause malfunctions.
Locked vehicle
Driving with the doors locked may make
access to the passenger compartment by
the emergency services more difficult in an
emergency.
As a safety precaution, never leave children
alone in the vehicle, except for a very short
period.
In all cases, it is essential to remove the key
from the ignition switch when leaving the
vehicle.
Second-hand vehicle
Have the pairing of all of the keys in your
possession checked by a PEUGEOT dealer,
to ensure that only your keys can be used to
open and start the vehicle.
2

Access
46
208_en_Chap02_ouvertures_ed01-2016
Window controls
Manual mode
Open
Close
Inhibit the rear controls.
Automatic mode
(depending on version)
Open
The electric window controls remain
operational for approximately 1 minute
after the key has been removed.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Anti-pinch
(depending on version)
Close
Press the control without going past
the point of resistance. The window
stops as soon as the control is
released.
Pull the control without going past the
point of resistance. The window stops
as soon as the control is released. Press the control, going past the
point of resistance. The window
opens completely after releasing the
control. Pressing again stops the
movement of the window.
Pull the control, going past the
point of resistance. The window
closes completely after releasing
the control. Pulling again stops the
movement of the window.
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening
of the window when closing
automatically, press the control
until the window opens completely,
then pull the control immediately until the
window closes. Continue to hold the control for
approximately 1 second after the window has
closed.
The safety anti-pinch function is not active
during this operation.

Access47
208_en_Chap02_ouvertures_ed01-2016
Reinitialisation
Always remove the key when leaving
the vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When operating the passenger electric
window controls, the driver must ensure
that no one prevents the correct closing
of the windows.
The driver must ensure that passengers
use the electric windows correctly.
Be aware of children when operating
the windows.Advice
Inhibition
For the safety of your children, press
the control to prevent operation
of the windows of the rear doors,
irrespective of their position.
With the warning lamp on, the rear switches
are deactivated. With the warning lamp off, the
switches are active. Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-
l

ower the window completely, then raise
it; it will rise in steps of a few centimetres
each time the switch is pressed. Repeat
the operation until the window closes
completely,
-

p
ress and hold the switch upwards for at
least 1 second after reaching this position,
window closed.
2

Ease of use and comfort
68
208_en_Chap03_ergonomie-confort_ed01-2016
Courtesy lamp
In this position, the lighting
comes on gradually:
-

w

hen the vehicle is unlocked,
-

w

hen the key is removed from the ignition,
-
w

hen opening a door,
-

w

hen unlocking with the remote control.
It goes off gradually:
-

w

hen the vehicle is locked,
-

w

hen the ignition is switched on,
-

3

0 seconds after the last door is closed. Permanently off.
Permanent lighting. F
W ith the ignition on, press
the corresponding switch.
1.
C

ourtesy lamp
2.
M

ap reading lamp s
With the "permanent lighting" mode, the lighting
time varies according to the circumstances:
- with the ignition off, approximately
10
minutes,
- in energy economy mode, approximately
30 seconds,
- with the engine running, unlimited.
Map reading lamps
Take care to avoid leaving anything in
contact with the courtesy lamp.

Safety97
208_en_Chap05_securite_ed01-2015
Deactivation
When the ignition is on, this warning
lamp comes on in the instrument
panel while the airbag is deactivated.
To assure your child's safety, you
must deactivate the passenger's front
airbag when you install a rear ward
facing child seat on the front passenger
seat. Otherwise, the child risks being
seriously injured or killed if the airbag is
deployed.
Reactivation
When you remove the rear ward facing child
seat, with the ignition on , turn the switch to
the "ON" position to reactivate the airbag and
so assure the safety of your front passenger in
the event of an impact.
Operating fault
If this warning lamp comes on in the
instrument panel, you must contact
a PEUGEOT dealer or a qualified
workshop without delay to have the
system checked. The airbags may no
longer be deployed in the event of a
serious impact.
Only the passenger's front airbag can be
deactivated.
F

W

ith the ignition off
, insert the key into
the passenger airbag deactivation switch.
F

T

urn it to the "OFF"
position,
F

R

emove the key keeping the switch in the
new position.
5

Safety
102
208_en_Chap05_securite_ed01-2015
Deactivating the passenger's
front airbag
Never install a rear ward facing child
restraint system on a seat protected by
an active front airbag. This could cause
the death of the child or serious injury.Passenger airbag OFF
The warning label present on both sides of the
passenger's sun visor repeats this advice. In
line with current legislation, the following tables
contain this warning in all of the languages
required. Only the passenger's front airbag can be
deactivated.
F

W
ith the ignition off, introduce the key into
the passenger airbag deactivation switch.
F
T
urn it to the "OFF" position.
F R emove the key, leaving the switch in this
position.
When the ignition is on, this warning
lamp comes on in the instrument
panel and stays on while the airbag is
deactivated.