boot Peugeot 208 2017 Owner's Manual

2
.
Instrument panels 7
W arning and indicator lamps 1 0
Indicators
23
Trip computer

3
0
Date and time adjustment

3
3
Lighting dimmer

3
4Remote control

3
6
Doors
3
6
Locking – Key
3
7
Central locking
4
0
Boot
4
0
Alarm

41
Electric windows
4
3
PE UGEOT i- Cockpit 4 5
Steering wheel adjustment 4 6
Mirrors
46
Front seats

4
8
One-piece bench seat
5

3
2/3 – 1/3 split rear bench seat

5
3
Head restraints

5
4
Recommendations for ventilation
and air conditioning

5
5
Heating
5

6
Manual air conditioning
5

6
Dual-zone automatic air conditioning
5

7
Recirculation of interior air

6
0
Demisting – defrosting

6
0
Courtesy lamp

6
1
Interior ambient lighting
6

2
Sunroof blind

6
3
Interior fittings

6
3
Boot fittings

6
5
Rear shelf
6 5 L

ighting control stalk
6
7
Direction indicators
6
8
Automatic illumination of headlamps
6
9
Daytime running lamps/Sidelamps
7
1
Headlamp adjustment
7
1
Cornering lighting
7
1
Wiper control stalk
7
2
General safety recommendations 7 5
Hazard warning lamps 7 6
Emergency or assistance call
7

6
Electronic stability control (ESC)

7
8
Seat belts
8

1
Airbags


84
Child seats

8
8
Deactivating the passenger's front airbag
8

9
ISOFIX mountings and child seats
9

7
Child lock

1
03
Dashboard instrumentsAccess
Over view
Ease of use and comfort Lighting and visibility
Safety
Instruments and controls 4
Contents

12
Warning / indicator lampStateCause Action / Observations
Door(s) open Fixed and associated
with a message
identifying the door. Speed below 6
mph (10 km/h), a
door or the boot is not properly
closed. Close the door or boot.
Fixed, associated with
a message identifying
the door, together with
an audible signal. Speed above 6
mph (10 km/h), a
door or the boot is not properly
closed.
Seat belt(s) not
fastened/
unfastened Fixed or flashing
accompanied by an
audible signal. A belt has not been fastened or
has been unfastened.
Pull the strap then insert the tongue into the buckle.
Battery charge Fixed. The battery charging circuit has
a fault (dirty or loose terminals,
slack or cut alternator belt, etc.). The warning lamp should go off when the engine is
started.
If it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
Engine oil
pressure Fixed.
The engine lubrication system
has a fault. You must stop as soon as it is safe to do so.
Park, switch off the ignition and contact a PEUGEOT
dealer or a qualified workshop.
Maximum
coolant
temperature Fixed, with the needle
in the red zone.
The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up to the required level, if necessary.
If the problem persists, contact a PEUGEOT dealer or
a qualified workshop.
Dashboard instruments

36
Remote control
A.Unfolding / Folding.
B. Unlocking.
Disarming the alarm.
C. Locking.
Locating the vehicle.
Arming the alarm.
Doors
Complete unlocking
With the key
F Turn the key towards the front of the
vehicle.
Using the remote control
F Press.
Selective unlocking
Complete unlocking is selected by default.
It is possible to activate or
deactivate the selective unlocking
with the touch screen from the menu
Driving / Vehicle .
With the remote control
F To unlock the driver's door only,
press this button once.
F

T
o unlock the other doors and
the boot, press this button
briefly twice. Unlocking is confirmed by rapid flashing
of the direction indicators for around
2


seconds.
According to the version you have, the
electric door mirrors fold at the same time.
Locating your vehicle
F A press switches on the vehicle's lighting and flashes
the direction indicators for a few
seconds to help you locate your
vehicle in a car park.
Guide-me-home lighting
Make a long press on this button to
operate the guide-me-home lighting
(switching on the sidelamps, dipped
beams and number plate lamps).
A second press before the end of the timed
period cancels the guide-me-home lighting.
Access

37
Locking – Key
Locking
With the key
F Turn the key towards the rear of the vehicle.
With the remote control
F Press.
M aintaining the lock (key or remote
control) automatically closes the
windows.
Locking is confirmed by fixed lighting of
the direction indicators for approximately
2


seconds.
According the version you have, the
electric door mirrors fold at the same time.
The automatic folding and unfolding of
the door mirrors can be deactivated by a
PEUGEOT dealer or a qualified workshop. If one of the doors or the boot is still open,
the central locking does not take place.
When the vehicle is locked, if it is unlocked
inadvertently, it will lock itself again
automatically after about 30
seconds
unless a door is opened.
As a safety measure (children on board),
never leave the vehicle without taking your
key, even for a short period.
Folding the key
F Press this button before folding the key. If you do not press the button, you risk
damaging the remote control.
Back-up door locking
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a battery failure.
Driver’s side
Insert the key in the door lock to lock or unlock
the door.
Passenger side
F On the rear doors, check that the child lock
is not on.
2
Access

40
Central locking
This function allows the doors and boot to be
locked or unlocked simultaneously from inside
the vehicle.
Locking
F Press this button.
This locks the doors and the boot.The indicator lamp comes on.
If one of the doors is open, the central
locking from the inside does not take
place.
Release
F Press this button again. The indicator lamp goes off. When locking / deadlocking from the
outside
When the vehicle is locked or deadlocked
from outside, the switch does not operate.
F

A
fter normal locking, pull one of the
interior door levers to unlock the
vehicle.
F
A
fter deadlocking, it is necessary to
use the remote control, or the key to
unlock the vehicle.
Automatic central locking
The doors lock automatically while driving
(speed above 6 mph [10 km/h]).
F

T
o activate or deactivate this
function (activated by default),
press this button until a buzzer
sounds and/or a message
appears in the screen.
Driving with the doors locked may render
access by the emergency services to the
interior difficult in an emergency.
Boot
Opening
Unlock the vehicle.
F

P

ress the tailgate opening button to
release it, and then guide it open.
Closing
F Lower the tailgate using the interior grab handle.
F

I
f necessary, press down on the tailgate to
fully close it.
Access

41
Boot still open
With the engine running, this is
signalled by:
-

t
his warning lamp coming on,
-

a
n alert message displayed for
a few seconds.
Vehicle moving (speed above 6
mph
(10

km/h)), this is signalled by:
-

t

his warning lamp coming on,
-

a

n alert message displayed for a few
seconds,
-
an

audible signal.
Back-up release
System for mechanically unlocking the boot in
the event of a battery or central locking fault.
Release
F Fold back the rear seats to gain access to the lock from inside the boot. F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
F
M
ove the latch to the left.
Alarm
The alarm provides the following types of
monitoring:
- Perimeter monitoring
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet, etc.
- Volumetric monitoring
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compartment or
moves inside the vehicle.
- Anti-tilt (GTi version)
The system checks for any change in the
attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.
2
Access

42
Self-protection function
The alarm is triggered if the battery, the
central control or the siren wiring are put
out of ser vice or damaged.
For all work on the alarm system, contact a
PEUGEOT dealer or a qualified workshop.
Total protection
Switching on
F S witch off the ignition and get out of the
vehicle.
F

P
ress the locking button on the
remote control.
The exterior perimeter monitoring is activated
after 5


seconds.
Interior volumetric monitoring is activated after
45


seconds.
If an opening (door, boot, etc.) is incorrectly
closed, the vehicle is not locked but the exterior
perimeter monitoring will be activated after
45
seconds at the same time as the interior
volumetric monitoring. Deactivation
F
P
ress the unlocking button on
the remote control.
Automatic activation (depending on
version)
The system is activated automatically 2 minutes
after the last door or the boot is closed.
Protection – exterior
perimeter monitoring alone
Deactivate the interior volumetric monitoring
(and anti-tilt monitoring if your vehicle has it)
to avoid unwanted triggering of the alarm in
certain cases such as:
-

w
hen a pet is in the vehicle,
-

a w
indow is open,
-
w

ashing your vehicle. Deactivating the volumetric monitoring
The anti-tilt alarm is also deactivated, if your
vehicle has one.
F

S
witch the ignition off.
F
W
ithin ten seconds, press the
button until the indicator lamp is
on fixed.
F
G
et out of the vehicle.
F
I
mmediately press the locking
button on the remote control.
The exterior perimeter monitoring
alone is activated: the indicator lamp
flashes once per second.
To be effective, the deactivation must
be carried out each time the ignition is
switched off.
The alarm monitoring system is
activated (armed): the indicator
lamp in the button flashes once per
second. The alarm system is deactivated: the
indicator lamp in the button goes off.
To avoid triggering the alarm on
entering the vehicle, first press the
unlocking button on the remote
control before opening.
Access

53
One-piece rear bench
Bench seat with fixed one-piece cushion and
folding one-piece backrest.
Folding the backrest
F Move the front seats for ward if necessary.
F
P
osition the outer seat belts on the backrest
and buckle them.
F

L
ower the head restraints to the lowest
position. F

R
elease the seat backrest 2 by pressing
controls 1 simultaneously.
F

F
old the seat backrest 2 on to the fixed
cushion.
Raising the seat backrest
F Raise the seat backrest 2 .
F L atch the backrest in place, the red
indicators on each control 1 are no longer
visible.
F

U
nbuckle and return the outer seat belts to
their normal positions ready for use.
2/3 – 1/3 split rear bench
seat
Bench seat with fixed one-piece cushion and
split backrest (left-hand 2/3, right-hand 1/3)
which can be folded individually to adapt the
load space in the boot.
Folding the backrest
F Move the corresponding front seat for wards if necessary.
F

P
osition the corresponding outer seat belt
against the backrest and buckle it.
F

F
ully lower or remove the head restraint.
3
Ease of use and comfort

54
F Release the backrest by pressing control 1 of backrest 2 .
F

F
old the seat backrest 2 on to the fixed
cushion.
The rear cushion is not removable.
Returning the backrest to
the normal position
F Raise the seat backrest 2 .
F S ecure it, the red indicator in the control 1 is
no longer visible. F

U
nbuckle and reposition the seat belts
ready for use.
F
R
efit the head restraint(s).
When folding the seat, the centre seat belt
should not be fastened but laid out flat
along the seat.
When repositioning the seat backrest,
take care not to trap the seat belts.
The rear seat cushion does not fold, only
the seat backrest can be folded in order to
increase the boot loading space.
Head restraints
These have one position for use (up) and a
stowed position (down).
They can be removed and are interchangeable
side to side.
F

p
ull the head restraint fully upwards,
F

t
hen, press the lug A .
Never drive with the head restraints
removed; they must be fitted and correctly
adjusted.
To remove a head restraint:
Ease of use and comfort

55
Recommendations for ventilation and air conditioning
In order for these systems to be fully effective,
follow the operation and maintenance
guidelines below:
F
T
o ensure that the air is distributed evenly,
keep the external air intake grilles at the
base of the windscreen, the nozzles, the
vents, the air outlets and the air extractor
in the boot free from obstructions.
F

D
o not cover the sunshine sensor,
located on the dashboard; this is used for
regulation of the automatic air conditioning
system.
F

O
perate the air conditioning system for
at least 5 to 10
minutes, once or twice a
month to keep it in per fect working order.
F

E
nsure that the passenger compartment
filter is in good condition and replace
the filter elements periodically. We
recommend the use of a combined
passenger compartment filter. Thanks to
its special active additive, it helps both to
purify the air breathed by the occupants
and to keep the passenger compartment
clean (reduction of allergic symptoms, bad
odours and greasy deposits). F
T o ensure correct operation of the
air conditioning system, you are also
advised to have it checked regularly
as recommended in the Warranty and
Maintenance Record.
F

I
f the system does not produce cold air,
switch it off and contact a PEUGEOT
dealer or a qualified workshop.
When towing the maximum load on a steep
gradient in high temperatures, switching off
the air conditioning increases the available
engine power and so improves the towing
ability.
To avoid the windows misting up and
deterioration in the quality of the air:
-

d
o not drive for too long with the
ventilation switched off.
-

d
o not keep air recirculation set for an
extended period. If after an extended stop in sunshine,
the interior temperature is very high, first
ventilate the passenger compartment for
a few moments.
Put the air flow control at a setting high
enough to quickly change the air in the
passenger compartment.
The condensation created by the air
conditioning results in a discharge of
water under the vehicle which is per fectly
normal.
Stop & Star t
The heating and air conditioning systems
only work when the engine is running.
To maintain a comfortable temperature
in the passenger compartment, you may
temporarily deactivate the Stop & Start
system.
For more information on Stop & Star t ,
refer to the corresponding section.
3
Ease of use and comfort