Peugeot 307 2007.5 Owner's Manual
Manufacturer: PEUGEOT, Model Year: 2007.5, Model line: 307, Model: Peugeot 307 2007.5Pages: 212, PDF Size: 7.59 MB
Page 121 of 212
CHECKS
109
Tilt the handle on the left-hand side
under the fascia to the right.
Lift the catch and raise the bonnet. Secure the strut
to hold the bonnet
open.
Before closing the
bonnet, replace the
strut in its housing.
RUNNING OUT OF FUEL
(DIESEL)
If you should run out of fuel, it is nec-
essary to re-prime the circuit.
The repriming pump, the degas
screw and the transparent pipe are
located under the bonnet (see corre-
sponding drawing):
OPENING THE BONNET
From inside
From outside
Bonnet strut
To close
Lower the bonnet and release it at
the end of its travel.
Check that the bonnet is properly
locked.
1.6 litre HDI 16V engine
- i l l t h e f u e l t a n k w i t h a t l e a s t i v e
litres of diesel,
- unclip the style cover to access the repriming pump,
- squeeze and release the manual repriming pump until fuel appears
in the transparent pipe with the
green connector,
- operate the starter until the engine starts.
2 litre HDI 16V engine
- i l l t h e f u e l t a n k w i t h a t l e a s t i v e litres of diesel,
- unclip the style cover to access the repriming pump,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is
seen escaping via the degas
screw,
- retighten the degas screw,
- operate the starter until the engine starts.
Page 122 of 212
CHECKS
110
1. Power steering reservoir.
2. Windscreen and headlamp wash
reservoir.
3. Coolant reservoir.
4. B r a k e l u i d r e s e r v o i r .
5. Battery.
6. Fuse box.
7. A i r i l t e r .
8. Dipstick.
9. Engine oil reservoir.
1.4 LITRE 16V PETROL ENGINE
Page 123 of 212
CHECKS
111
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir.
4. B r a k e l u i d r e s e r v o i r .
5. Battery.
6. Fuse box.
7. A i r i l t e r .
8. Dipstick.
9. Engine oil reservoir.
1.6 LITRE 16V PETROL AND 1.6 LITRE 16V BIOFLEX ENGINE
Page 124 of 212
CHECKS
112
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir.
4. B r a k e l u i d r e s e r v o i r .
5. Battery.
6. Fuse box.
7. A i r i l t e r .
8. Dipstick.
9. Engine oil reservoir.
2 LITRE 16V PETROL ENGINE
Page 125 of 212
CHECKS
113
1. Power steering reservoir.
2. Windscreen /headlamp wash
reservoir.
3. Coolant reservoir .
4. B r a k e l u i d r e s e r v o i r .
5. Battery .
6. Fuse box.
7. Dipstick .
8. Engine oil reservoir.
9. Priming pump.
1.6 LITRE 16V TURBO DIESEL HDI ENGINE (90 BHP/110 BHP)
Page 126 of 212
CHECKS
114
1. Power steering reservoir.
2. Windscreen/headlamp wash
reservoir.
3. Coolant reservoir.
4. B r a k e l u i d r e s e r v o i r .
5. Battery.
6. Fuse box.
7. A i r i l t e r .
8. Engine oil reservoir.
9. Dipstick.
10. Priming pump.
11. Degas screw.
2 LITRE 16V TURBO DIESEL HDI ENGINE (136 BHP)
Page 127 of 212
CHECKS
115
CHECKING THE LEVELS
There are two marks on
the dipstick:
A = maximum
N e v e r i l l p a s t t h i s m a r k .
B = minimum
Oil change
According to the information given in
the servicing booklet.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer’s require-
ments.
Note: the coolant does not need to
be changed.
Dipstick
Cooling system
U s e t h e l u i d r e c o m m e n d e d b y t h e
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can oper-
ate with the ignition off.
I n t h e c a s e o f v e h i c l e s i t t e d w i t h
a p a r t i c l e e m i s s i o n i l t e r , t h e f a n
can operate after the vehicle has
s t o p p e d , e v e n w h e n t h e e n g i n e i s
cold.
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level.
Windscreen and headlamp
w a s h l e v e l
Diesel additive level (Diesel
w i t h p a r t i c l e e m i s s i o n f i l t e r )
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
diesel additive level.
This additive must be topped up.
Contact a PEUGEOT dealer as soon
as possible.
Brake fluid level
* According to engine.
Oil level
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
The level should always be
above the MIN mark and
close to the MAX mark.
P o w e r s t e e r i n g r e s e r v o i r
Remove the style trim * (see §
"Changing a bulb - Front lights").
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning and
for your safety, we would ad-
vise that you use products
recommended by PEUGEOT.
Check the level regularly and
top up between changes. The
maximum consumption is 0.5 l
per 600 miles (1 000 km).
Check the level with the ve-
hicle level, engine cold, using the oil
level gauge on the instrument panel
or the dipstick. Replacement must be car-
ried out according to the
manufacturer’s servicing
schedule.
U s e l u i d s r e c o m m e n d e d b y
t h e m a n u f a c t u r e r , w h i c h f u l i l D O T 4
standards.
Page 128 of 212
CHECKS
116
CHECKS
Where the handbrake travel
is too great or there is a re-
duction in the performance
of the system, the hand-
brake should be adjusted,
even between services.
Have the system checked by a
PEUGEOT dealer.
Particle emission filter
(Diesel)
It is imperative that the particle emis-
s i o n i l t e r i s m a i n t a i n e d i n a c c o r d a n c e
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer.
Note: following prolonged operation
of the vehicle at very low speed or at
idle, you may, in exceptional cases,
notice discharges of water vapour
at the exhaust on acceleration. This
has no effect on the behaviour of the
vehicle or on the environment. Brake pad wear depends
on the style of driving, in
particular for vehicles which
are used in town, over short
distances.
D i s c a n d d r u m w e a r s t a t u s
For any information relating to the wear
status of the surfaces of the discs and
drums, contact a PEUGEOT dealer
.
Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and characteristics.
To ensure best performance
from components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
q u i t e s p e c i i c p r o d u c t s .
To prevent damage to the electrical
units, high pressure washing to clean
the engine compartment is strictly
prohibited .
Oil filter
Used products
Avoid all prolonged contact of the
used oil with the skin.
B r a k e l u i d i s h a r m f u l t o h e a l t h a n d
very corrosive.
Air filter and passenger
compartment filter
Do not dispose of used oil,
b r a k e l u i d o r c o o l a n t i n t o
drains or onto the ground.
Empty the used oil into the
containers provided for this
purpose in the PEUGEOT network.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Brake pads
It may be necessary to
check the thickness of the
pads, even between ser-
vices.
Handbrake
C h a n g e t h e i l t e r r e g u l a r l y ,
in accordance with the ser-
vicing schedule.
Manual gearbox
This does not require an oil
change. Have the level checked
in accordance with the manu-
facturer’s servicing schedule.
To check the main levels
a n d c e r t a i n c o m p o n e n t s ,
i n a c c o r d a n c e w i t h t h e
manufacturer’s servicing
s c h e d u l e , r e f e r t o t h e
pages of the servicing booklet
w h i c h c o r r e s p o n d t o y o u r v e h i -
cle’s engine.
H a v e t h e i l t e r e l e m e n t s r e -
placed regularly.
If you drive
i n d u s t y c o n d i t i o n s , c h a n g e
t h e m t w i c e a s o f t e n .
Page 129 of 212
CHECKS
116
CHECKS
Where the handbrake travel
is too great or there is a re-
duction in the performance
of the system, the hand-
brake should be adjusted,
even between services.
Have the system checked by a
PEUGEOT dealer.
Particle emission filter
(Diesel)
It is imperative that the particle emis-
s i o n i l t e r i s m a i n t a i n e d i n a c c o r d a n c e
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer.
Note: following prolonged operation
of the vehicle at very low speed or at
idle, you may, in exceptional cases,
notice discharges of water vapour
at the exhaust on acceleration. This
has no effect on the behaviour of the
vehicle or on the environment. Brake pad wear depends
on the style of driving, in
particular for vehicles which
are used in town, over short
distances.
D i s c a n d d r u m w e a r s t a t u s
For any information relating to the wear
status of the surfaces of the discs and
drums, contact a PEUGEOT dealer
.
Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and characteristics.
To ensure best performance
from components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
q u i t e s p e c i i c p r o d u c t s .
To prevent damage to the electrical
units, high pressure washing to clean
the engine compartment is strictly
prohibited .
Oil filter
Used products
Avoid all prolonged contact of the
used oil with the skin.
B r a k e l u i d i s h a r m f u l t o h e a l t h a n d
very corrosive.
Air filter and passenger
compartment filter
Do not dispose of used oil,
b r a k e l u i d o r c o o l a n t i n t o
drains or onto the ground.
Empty the used oil into the
containers provided for this
purpose in the PEUGEOT network.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Brake pads
It may be necessary to
check the thickness of the
pads, even between ser-
vices.
Handbrake
C h a n g e t h e i l t e r r e g u l a r l y ,
in accordance with the ser-
vicing schedule.
Manual gearbox
This does not require an oil
change. Have the level checked
in accordance with the manu-
facturer’s servicing schedule.
To check the main levels
a n d c e r t a i n c o m p o n e n t s ,
i n a c c o r d a n c e w i t h t h e
manufacturer’s servicing
s c h e d u l e , r e f e r t o t h e
pages of the servicing booklet
w h i c h c o r r e s p o n d t o y o u r v e h i -
cle’s engine.
H a v e t h e i l t e r e l e m e n t s r e -
placed regularly.
If you drive
i n d u s t y c o n d i t i o n s , c h a n g e
t h e m t w i c e a s o f t e n .
Page 130 of 212
10PRACTICAL INFORMATION
117
1. Wheelbrace.
2. Jack with handle.
3. Centralising tool.
4. Socket for anti-theft bolt.
5. Removable towing eye.
6. Alloy wheel bolt trim remover.
7.
Alloy wheel trim remover.
Parking the vehicle
If possible, park the vehicle on
level, stable and non-slippery
ground.
Apply the handbrake, switch off
t h e i g n i t i o n a n d e n g a g e i r s t o r
reverse gear (position P for the
automatic gearbox).
To gain access to the spare wheel
a n d t h e j a c k i n t h e b o o t , l i f t t h e l o o r
using the handle.
CHANGING A WHEEL (SALOON)
Tools
The following tools are located in a holder in the cent re of the spare wheel:
A diagram on the holder indicates the location of the to ols.