boot Peugeot 508 RXH 2012 User Guide

66
i
!
Access
Selective unlocking
)To unlock the driver's door onlypress the open padlock once.

Using the remote control
This is set via the instrument panelscreen configuration menu.
Complete unlocking is activated by default.

Using the electronic key
)To unlock only the driver's door with theelectronic key on your person, pass your hand behind the driver's door handle thenpull the handle to open the door.)To unlock the vehicle completely, pass your hand behind one of the passenger door
handles, on the side of the vehicle where
the electronic key is located, then pull the door handle.



Each unlocking is confirmed by rapid flashing of the direction indicators for approximately two seconds.
According to version, the door mirrors unfold at the same time as the first unlocking action.
)
To unlock the other doors and the boot,press the open padlock again.
The accumulation of deposits (dust, grime, salt...) on the inner surface if the door handle may affect detection.
If cleaning the inner sur face of the door handle using a cloth does not resolve
the problem, contact a PEUGEOTdealer or a qualified workshop. A sudden splash of water (stream of water, high pressure jet washer, …) may be identified by the system as the desireto open the vehicle.

2
67
!
Access
Unlocking the boot

Using the remote control
)
Press this button to unlock thevehicle and open the boot.


Using the electronic key
)With the electronic key in the defined zone,
lift lever 1 to unlock the vehicle and open
the boot.
Boot only function activated
This is set in the instrument panelconfiguration menu.
This function is deactivated b
y default. )Use of the remote control or the electronickey then unlocks and/or opens only the boot.
Don't forget to lock your boot afterwards.

68
i
!
i
i
Access

As a safety measure (children on board), never leave the vehicle without taking your key, even for a shor t period.
Guard against theft when the electronickey is in the defined zone with thevehicle unlocked.


Locking is confirmed by fixedlighting of the direction indicators for approximately two seconds. According to version, the door mirrors fold at the same time.
It is not possible to lock the vehicle if an electronic key is left inside the vehicleor if the ignition is on.


If one of the doors or the boot is stillopen or if an electronic key has been left inside the vehicle, the centrallocking does not take place.
When the vehicle is locked, if it isunlocked inadvertently, it will relock automatically after about thir ty seconds unless a door is opened.
The folding and unfolding of the door mirrors by the remote control can be deactivated by a PEUGEOT dealer.
Locking the vehicle
Normal locking
Using the key
)Turn the key towards the rear of the vehicle
to lock the vehicle completely.

Using the remote control
)Press the closed padlock to lock
the vehicle completely.


Using the electronic key
)
With the electronic key in the defined zone,
press with a finger on the door handle(at the markings) to lock the vehicle.) From the boot, with the electronic key in
the defined zone, press a button to lock the
v
ehicle.

Maintaining the locking action (remotecontrol or manual key) automaticallycloses the windows and sunroof.

70
!
!
i
Access
Locking/unlocking from the inside

Automatic central locking
of the doors
The doors can lock automatically while driving (speed above 6 mph (10 km/h)).
To activate or deactivate this function, press
and hold the button until a message appears in
the screen.
If the vehicle is deadlocked, the button is not active. In this case, use the key or the remote control to unlock.
Driving with the doors locked may makeaccess to the passenger compartmentby the emergency services moredifficult in an emergency.

Folding the key
)First press this button to fold the key.
If you do not press the button when foldingthe key, there is a risk of damage to the mechanism.

)
Press the closed padlock to
locate your locked vehicle in acar park.
Locating your vehicle
)
Press the button.
This allows the doors and the boot to be lockedor unlocked.
This is indicated b
y lighting of the cour tesylamps and flashing of the direction indicators for a few seconds.
When carrying large objects with theboot open, you can press this button to inhibit the boot open aler t signal. Whenlocking from inside, the door mirrors donot fold.

74
!
Access
System which protects and provides a deterrentagainst theft and break-ins. It provides the
following types of monitoring:






Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...


- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.

- Tilt

The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.


Self-protection function
The system checks for the putting out of ser vice of its components. The alarm is triggered if the battery,the central control unit or the wires of the siren are put out of ser vice or damaged.
For all work on the alarm system,contact a PEUGEOT dealer or aqualified workshop.


Locking the vehicle with full
alarm system


Activation
)Switch off the ignition and get out of the vehicle.
)
Press the locking button on theremote control or lock the vehicle
using the Keyless Entry and Starting system. The monitorin
g system is active: the indicator
lamp on the button flashes once per second.

After the locking button on the remote controlis pressed or the vehicle locked using the
Ke
yless Entry and Starting system, the exterior perimeter monitoring is activated after a delay
of 5 seconds, the interior volumetric monitoring
after 45 seconds and anti-tilt monitoring after 90 seconds.
If an opening (door, boot...) is not closed
fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a
delay of 45 seconds.
) Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entryand Star ting system.

Deactivation of the volumetric monitoring

The volumetric protection system is
deactivated: the indicator lamp in the
button
goes off.

2
75
Access

Locking the vehicle
w
ith exterior perimeter
monitoring only
Deactivate the interior volumetric and anti-liftmonitoring to avoid unwanted triggering of the alarm in certain cases such as:


- leaving a window par tially open,

- washing your vehicle,

- changing a wheel,

- having your vehicle towed,

- transportation by sea.


Deactivation of the interior volumetric and anti-tilt monitoring
)
Switch of the ignition and within
ten seconds, press this button
until the indicator lamp is on
continuously.) Get out of the vehicle.
)
Press the locking button on the
remote control immediately or lock the vehicle using the KeylessEntry and Starting system.
The exterior perimeter monitorin
g alone is
activated: the indicator lamp in the button
flashes once per second.
To be effective
, this deactivation must be carried
out each time the ignition is switched off.
Reactivation of the interior volumetric and anti-tilt monitoring
Tr iggering of the alarm
This is indicated by sounding of the siren and flashing of the direction indicators for thirty seconds.The monitoring functions remain active until
the alarm has been triggered eleven times in succession.
) Press the unlocking button on
the remote control or unlock thevehicle using the Keyless Entry
and Starting system to deactivate
the exterior perimeter monitoring.
) Press the locking button on the
remote control or lock the vehicleusing the Keyless Entry and Starting system to activate all the monitoring functions.

The indicator lamp in the button
again flashes once per second.


When the vehicle is unlocked usingthe remote control or unlocked
using the Keyless Entry and Starting system, rapid flashing of the indicator lamp in the button informs you that the alarmwas triggered during your absence. When
the ignition is switched on, this flashing stopsimmediately.

Failure of the remote control

To deactivate the monitoring functions:
)
Unlock the vehicle using the key in thedriver's door lock. )
Open the door; the alarm is triggered. )
Switch on the ignition; the alarm stops.
The indicator lamp in the button switches off.




Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key
in the driver's door lock.




Operating fault


When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault in the system.
Have it checked by a PEUGEOT dealer or a qualified workshop.


*

According to country.


Automatic activation *


2 minutes after the last door or the boot is closed, the system is activated automatically. )
To avoid triggering the alarm on enteringthe vehicle, first press the unlocking button on the remote control or unlock the vehicleusing the Keyless Entry and Starting system.

78
Access











Boot
)After unlocking the vehicle completely using the remote control or the key, pressat the top (on lever A), and raise the Atailgate.



From the inside

Hold this button down until unlocking of the boot is heard.

)Lower the tailgate using the interior grabhandle.
Opening


If the tailgate is not closed correctly, with
the hybrid system active
or the vehicle moving
(speed above 6 mph (10 km/h)),
a message appears in the instrument panel screen for a few seconds.


Closing

80
!
Access
) Press this button C
to close thetailgate electrically.
Do not hinder closin
g of the tailgate: any
obstacle to closing causes the tailgate to stopand rise a few centimetres automatically.
To close the tailgate manually: move the
tailgate slightly up then down to disengage it
from its drive then lower it until closed.
To avoid the risk of injury, ensurethat no one is close to the rear of thevehicle when opening or closing the tailgate.

While electric opening or closing of the tailgate
is in progress, you can stop its movement at
any time: ) press the interior button or button A
on
the remote control or button Bor C on thetailgate.


Stopping the opening
or closing
Ad
justing the opening
hei
ght
"Boot open" warning
With the hybrid system active or when the
vehicle is moving, if the tailgate is not properly closed, a message accompanied by an audiblesignal (from 6 mph (10 km/h)) is displayed in the
instrument panel screen.
The maximum openin
g height of the tailgate can be set and memorised (restricted overheadclearance, ...).
This memorisation is done in two steps,
b
y successive presses on button C:

- during opening, a first press stops the
tailgate at the desired height,

- a second maintained press memorises theposition of the tailgate; an audible signal confirms the memorisation.
To delete this memorisation, make a new
maintained press until the audible signal isheard.

2
81
Access
Tailgate release
System allowing the mechanical unlocking of
the boot in the event of a battery or central
locking system malfunction.
Unlocking
)Fold back the rear seats to gain access to
the lock from inside the boot.)Insert a small screwdriver into hole Aof the
lock to unlock the tailgate. )Move the latch to the left.



Locking after closing

If the fault persists after closing again, the boot
will r
emain locked.

90
!
Comfort











Rear seats Bench seat the left-hand (1/3) or right-hand (2/3) section of which can be folded to adapt the boot load space.
Outer rear seat head restraints
These have a high position (comfor t and safety), a low position (rear visibility) and canalso be removed.
T
o remove a head restraint:)pull the head restraint fully upwards, )then, press the lug A.
Never drive with rear passengers whenthe head restraints are removed; thehead restraints must be in place and in
the high position.


Folding the seat from the
boot
Each section of the bench seat (1/3 or 2/3) has
its own control to release the seat back and its seat cushion from the boot.
) Check that nothing is preventing the seat
back from foldin
g (head restraint, seat
belts, ...),) check also that no object on or under theseat could hinder its movement,
)pull the control from the boot and push the
seat backrest.