Pre-heat Peugeot 508 RXH 2012 Owner's Manual

.
29
!
Hybrid system














Ready lamp

With the gear lever in position N, press the
brake pedal and star t the hybrid system.
This lamp comes on when the vehicle is read
y
to move off ("Auto" mode is on by default) andso the driver can press the accelerator.
This lamp comes on more or less instantly but may take a few seconds in some cases (inparticular, the time needed for pre-heating the
Diesel engine in cold weather).









HYbrid4 mode selector
AUTOmode, for normal use and optimised fuelconsumption.
ZEVmode, to force electric runnin
g.S
portmode, to make use of the maximum
per formance of the vehicle.
4WDmode, to force the vehicle into 4x4 mode.



When stationary, switch off the hybridsystem and check that the Readylamp is off when you leave the vehicle.Other wise the hybrid system will remainactive. See paragraph "Underbonnet precautions/warnings". Th
e selector allows the user to choose between
4 drive modes for the vehicle.
Turn the dial to the right or left; the mode
selected is confirmed by illumination of thecorresponding indicator.

48
Instruments and controls
StateCauseAction/Observations


Diesel engine pre-heatingfixed. The START/STOPswitch has been
pressed (ignition on). Wait until the warning lamp goes off before star ting.
The period of illumination of the warning lamp is determined bythe ambient conditions (up to about thir ty seconds in extreme
conditions).
If the engine does not star t, switch the ignition off and then on,
wait until the warning lamp goes off again, then start the engine.


Parking brakefixed. The parking brake is applied or not
properly released. Release the parking brake to switch off the warning lamp,keeping your foot on the brake pedal.
Obser ve the safety recommendations.
For fur ther information on the parking brake, refer to the "Driving"section.

Deactivation of the automatic functions of the electric parkingbrake
fixed. The "automatic application" (on switching off the engine) and"automatic release" functions are
deactivated or faulty. Activate the function
(according to country) via the vehicle configuration menu or contact a PEUGEOT dealer or a qualified
workshop if automatic application/release is not possible.
The parking brake can be released manually using theemergency release procedure.
For more information on the electric parking brake, refer to the "Driving" section.



Foot on thebrake pedalfixed. The brake pedal is not pressed. Press the brake pedal to star t the hybrid system (lever in position N).
If you wish to release the parking brake without pressing thebrake pedal, this warning lamp will remain on.
flashin
g. If you hold the vehicle on an incline using the accelerator for too long, the clutch overheats. Use the brake pedal and/or the electric parkin
g brake.

3
117
i
Comfort
Programmable heating mode
This is an additional and separate system
which heats the engine hot water circuit
to improve defrosting and to preheat thepassenger compartment.
This indicator lam
p comes on if the
system is programmed in preheatingmode.With the i
gnition on, press the left hand
steering mounted thumb wheel for access to
the main menu:
Programming
) In the "Main menu", select "Pre-heating/Pre-ventilation",
)
Select "Activation" and if necessary for programming, "Parameters",
)
Select "Heating" to preheat the engine or passenger compar tment or "Ventilation" to
ventilate the passenger compartment,
) Select:
- immediate to star t the heating ("OK"
once),
- the first clock to programme/store astar ting time,
- the second clock to programme/storeanother starting time.










Programmable Heating/ Ventilation


Programmable Ventilation
mode

This mode allows ventilation of the passenger compartment to improve the temperatureexperienced on entering the vehicle in summer.

Using these two clocks and according to season you can, for example, selectone or the other star ting time. A message in the instrument panel
screen confirms your choice.