ignition Peugeot Partner VU 2001 Owner's Manual

AB
Remote controls
The remote control uses a high-frequency transmitter, which has the following advantages :
- it is not necessary to aim directly at the receiver in the vehicle.
- it operates through all materials (panels, load)
- it has a very long range. Central locking by remote control. The remote control locks and unlocks the doors and tailgate. Press once on but- ton Ato lock, or on button Bto unlock.
If this does not work the first time, press again. Locking or unlocking is confirmed by the direction indicators :- Locking = Indicators light up for approx. two seconds.
- Unlocking = Indicators flash rapidly.
If a door is open or incorrectly closed, the central locking will not operate. I
t is not necessary to keep the button pressed.
If the remote control does not function, reinitialise it. See the paragraph below on ÒChanging the remote control batteriesÓ.
If the remote control is lost or should fail, it is still possible to open the doors using the key.
The remote control key has been designed with a snap-off key. In an accident, the key will snap off to prevent knee injury.Unlocking also switches on the interior lamps.
Electronic engine immobiliser The ELECTRONIC ENGINE IMMOBILISER locks the engine control system. The system is automatically activated when the key is taken out of the ignition.All the keys contain an electronic device.Only your keys can start your vehicle.Insert your key in the ignitionAfter switching on the ignition, a dialogue is established between the key and the
electronic engine immobiliser. If the key is not recognised, starting is not possible.
NOTE : simultaneous use of other high frequency equipment (mobile telephones, domestic alarms
etc.) may interfere with the operation of the remote control. If it entirely ceases to function, it needs to be reinitialised. See ÒChanging the remote control batteryÓ.
* According to specification or country
5I-1KEYS, REMOTE CONTROL *

Anti-theft precautions Before leaving your vehicle :
- Completely close all windows and do not leave objects visible from the outside.
- Remove the ignition key, engage the steering lock and lock all doors. Changing the remote control batteries Unclip to access the batteries.
Two batteries, ref.: CR 1620 3V.
After changing a battery, it is necessary to reinitialisethe remote control.
Do this by switching on the ignition and then operating your remote control.
* According to specification
7I-1KEYS, REMOTE CONTROL *
DO NOT DISCARD USED BATTERIES.
RETURN THEM TO AN APPROVED DEALER OR TO APPROVED COLLECTION CENTRES.
(photographic shops, etc.)

Main key
Operates door locks and filler cap, activates or deactivates the passengerÕs airbag *, unlocks the steering, switches on ignition and starts the engine. Central locking using the key* All doors can be locked and unlocked from the front doors using the key in the remote control. The central locking will not operate if one of the front doors is open or not properly closed.
4I-1KEYS, REMOTE CONTROL *
CAUTION
The remote control has a considerable operating range which allows you to lock or
unlock your vehicle from a distance. Handling the remote control, for example in your pocket, could accidentally open the doors.
* According to specification.

De-activating the passengerÕs airbag *
- With the ignition switched off, insert the key into the switch A.
- Turn the key to the Ò OFFÓ position. The passengerÕs airbag is now de-activated.
- The warning lamp, on the instrument panel, lights up when the ignition is switched on (if it flashes, there is a problem).
To re-activate the passengerÕs airbag
- Do not forget to re-activate the passengerÕs airbag. To do so, with the ignition switched off :
- Insert the key into the switch and turn to the Ò ONÓ position. The passengerÕs
airbag is now re-activated.
- The warning light in the instrument panel lights for six seconds on switching on the ignition.
* According to specification.
19I-8THE AIRBAG SYSTEM*
Never place a rearwards facing child seat on the front passenger seat when the vehicle is fitted with an airbag.
Depending on the vehicleÕs equipment, it may be possible to de-activate the
front passengerÕs airbag (see below).
The wearing of seat belts is compulsory in conjunction with the front airbags.Never deactivate the passenger's airbag when the front passenger is present
(with the exception of the use of a rear- facing child seat).
A

1Left air vent
2 Left speaker
3 Upper glove box or passenger's airbag
4 Location of radio or glove compartment
5 Controls :
¥ Electric windows
¥ Rear screen /exterior mirror
demister
¥ Air-conditioning
¥ Hazard warning lights
¥ Heated seats
6 Location of radio / CB, car phone
7 Central air vents
8 Controls :
¥ Horn
¥ Headlamps
¥ Direction indicators
¥ Rear fog lamp
9 Instrument panel
10 Controls :
¥ Windscreen wipers
¥ Rear screen wiper
¥ Windscreen wash 11
Right speaker
12 Right air vent
13 Key-operated switch :
¥ Activation/de-activation of
the passengerÕs airbag
14 Controls :
¥ Passenger's side electric mirror
¥ Headlamp angle adjuster
15 Fusebox access flap
16 Ignition lock
17 Driver's airbag
18 Steering wheel adjustment
19 Heating controls
20 Handbrake
21 Ashtray
22 Gear lever
23 Lighter
24 Lower glove box
25 Courtesy light
* According to specification.
25I-13INSTRUMENTS AND CONTROLS *

27I-14
Coolant temperature gauge Under normal operating conditions, the gauge may indicate a temperature of up to 100¡C. Under severe operating conditions, such as in high temperatures, the needle may approach the red zones.
If the needle enters the red zone and the STOP warning lamp flashes, stop
immediately, switch off ignition, the cooling fan may continue to operate for
a certain time , let the engine cool down and take the precautions indicated in
chapter ÒMAINTENANCEÓ - Levels and Checks. This over-heating may be due to a number of causes, contact the nearest
approved dealer. Fuel gauge When the low level warning lamp comes on continuously with the vehicle on level ground, there remain approximately 7 litres of fuel in the tank. Reservoir capacity (in litres) :
Petrol : 55
Diesel : 60
INSTRUMENT PANEL*
* According to model or country

- Maintenance indicator. The maintenance indicator displays the number of miles to be coveredbefore the next service (in accor-dance with the servicing scheduleswhich appear in the MaintenanceGuide). Operation :On switching on the ignition, the maintenance indicator spannerappears in the display for severalseconds ; the mileage recorder dis-play indicates how many milesremain to be travelled before thenext service is due.
For example :: you have thefol-
lowing distance left to travel before the next service :Five seconds after switching onthe ignition, the total mileagerecorder reverts to normal opera-tion and the total or trip mileages
appear on the display.
Distance to be covered before the next service is less than 1000 miles
For example : 900 miles remain
before the next service is due. For five seconds on switching on the ignition, the display shows : Five seconds after switching on ignition, the total mileage counterresumes its normal function and thespanner symbol remains lit. This signifies that the vehicle will be
due for a service shortly. The total or trip mileages appear on
the display.
The pre-set service distance has been exceeded. The spanner and total number of miles exceeded flash in the displayfor five seconds after the ignition isswitched on. For example : the pre-set service
distance has been exceeded by 300 miles.
Your vehicle must be serviced assoon as possible. Five seconds after switching on ignition, the total mileage counterresumes its normal function andthe spanner symbol remains lit.
28I-14INSTRUMENT PANEL*
Multifunction display
On switching on ignition, the display indicates in succession :

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

Engine oil level indicator (Diesel)
When the ignition is switched on, the maintenance indicator is displayed for several seconds followed by the engine oil level for approximately 10 seconds. Max Min Check using the oil dipstick.
Check with the vehicle on level ground, and the engine off for at least 10 minutes. Lack of oil (flashing of the lines) The oil level must be topped up. If it is not, the engine may be destroyed.
A flashing of the indicator informs you there is an operating fault .
Contact your network dealer.
30I-14INSTRUMENT PANEL*
Multifunction Display
On switching the ignition on, the display shows in turn :
- Maintenance indicator.- Engine oil level indicator (Diesel).
- Total mileage recorder.
- Indication of the time.
* According to model or country

B
1 - The clockcan be set, with the ignition on and the engine not running , by pressing button B for more than three
seconds; the hour will start to flash.
Changing the time 2 - Short press on B, allows the time to be changed slowly.
If the button is not pressed for five seconds : The hour is memorised, the minutes flash. Long press, rapid scrolling
Changing the minutes 3 - Short press on B, allows the time to be changed slowly.
If the button is not pressed for five seconds : The minutes are set. Long press, rapid scrolling
Note : the clock display comes on when the driverÕs door is opened and goes out one minute after it is shut. The
clock display goes off after 10 minutes if the driverÕs door remains open.
32I-14INSTRUMENT PANEL*
Digital clock
* According to model or country