maintenance Peugeot RCZ 2014 Owner's Manual

CONTENTS
RCZ_EN_CHAP00A_SOMMAIRE_ED02-2013
Steering lock - Starting 129Parking brake 130Hill start assist 131Manual gearbox 132
Automatic gearbox 133Gear shift indicator 137Tyre under-inflation detection 138Speed limiter 140
Cruise control 143Parking sensors 146
Fuel tank 150Bonnet 152Petrol engines 153
Diesel engine 154Running out of fuel (Diesel) 155Checking levels 156
Checks 159
Temporary puncture repair kit 161Changing a wheel 168Snow chains 173Changing a wiper blade 174
Energy economy mode 175Battery 176Changing a bulb 178Changing a fuse 186
Towing a vehicle 193Towing a trailer 195Cleaning and maintenance 197Accessories 199
6/DRIVING 129-148
7/CHECKS 149-160
8/PRACTICAL INFORMATION 161-200
ALPHABETICAL INDEX 329-333
VISUAL SEARCH 334-340
Petrol engines 201Weights (petrol) 202Diesel engine 203Weights (Diesel) 204Dimensions 205Identification markings 206
9/TECHNICAL DATA 201-206
Emergency or assistance 207PEUGEOT Connect Media Navigation (NG4 3D) PEUGEOT Connect Media Navigation (NG4 3D) PEUGEOT2 11PEUGEOT Connect Navigation (RT6) 255PEUGEOT Connect Sound (RD5) 309
10/AUDIO EQUIPMENT and TELEMATICS 207-328

79
96107 161
146
4
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
EXTERIOR
1. Welcome lighting
This additional exterior and
interior lighting, controlled
remotely, makes your approach to
the vehicle easier when the light
is poor.
2. Directional lighting
This lighting automatically
provides additional visibility when
cornering.
5. Temporary tyre repair kit
This kit is a complete system,
consisting of a compressor
and a sealant cartridge, for the
temporary repair of a tyre.
3. Spoiler
This system improves the
aerodynamics of the vehicle.
4. Front and rear parking
sensors
This system warns you of any
obstacles detected in front of or
behind the vehicle when parking.
Aluminium arches
For maintenance of these
arches, do not use a dry
cloth with an abrasive
product. Use a sponge and
soapy water.

79
2 11
255107
75
309
FAMILIARISATION
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
INTERIOR
1. Interior mood lighting
This dimmed lighting of the passenger
compartment facilitates visibility inside the
vehicle when the light is poor.
2. Audio and telematic systems
This equipment benefi ts from the latest technology:
MP3 compatible PEUGEOT Connect Sound (RD5),
PEUGEOT Connect Navigation (RT6) or PEUGEOT
Connect Media Navigation (NG4 3D) with 16/9 retractable
colour screen, JBL audio system, auxiliary sockets.
PEUGEOT Connect Media Navigation (NG4 3D)

PEUGEOT Connect Navigation (RT6)
4. Active spoiler control
(except 1.6 litre THP 270 hp version)
This automatic system can be controlled
manually by means of this control on the
centre console.
3. Dual-zone digital air conditioning
This systems allows different levels of comfort
to be set for the driver and front passenger.
It then controls these levels automatically
according to the ambient conditions. PEUGEOT Techno PVC
For maintenance of this trim, do not use
solvent or detergent with a dry cloth.
Remove dust fi rst, then use a soft cloth
and soapy water. Dry using another soft
cloth.
PEUGEOT Connect Sound (RD5)

RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
LIMIT THE CAUSES OF EXCESS
CONSUMPTION
Spread loads throughout the vehicle; place the heaviest items in the
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof\

bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refi t your summer tyres.
OBSERVE THE RECOMMENDATIONS ON
MAINTENANCE
Check the tyre pressures regularly, when cold, referring to the label in
the door aperture, driver's side.
Carry out this check in particular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle serviced regularly (engine oil, oil fi lter, air fi lter,
passenger compartment fi lter...) and observe the schedule of
operations recommended in the warranty and maintenance record.
When refuelling, do not continue after the third cut-off of the nozzle to
avoid any overfl ow.
At the wheel of your new vehicle, it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see the fuel consumption settle down \
to a consistent average.

36
Service overdue
For 7 seconds after the ignition is switched on, the spanner fl ashes to
indicate that the service must be carried out as soon as possible.
Example: the service is overdue by 300 miles.
For 7 seconds after the ignition is switched on, the central screen
indicates:
The spanner remains on in the small screen
to indicate that a service should have been
carried out.
The distance remaining may be weighted by the time factor,
depending on the type of motoring the vehicle is used for.
Therefore, the spanner may also come on if you have exceeded
the period since the last service specifi ed in the warranty and
maintenance record.
Service indicator zero reset
Retrieving the service information
You can access the service information at any time.
This information appears when running through the manual check
procedure.
 Briefl y press the "CHECK/000" button.
The service information is displayed for a few seconds on the instrument panel central screen, then disappears.
Following this operation, if you wish to disconnect the battery, lock
the vehicle and wait at least fi ve minutes for the zero reset to be
registered.
After each service, the service indicator must be reset to zero.
The procedure for resetting to zero is as follows:
 switch off the ignition,
 press and hold the
"CHECK/000" button,
 switch on the ignition; the distance recorder display begins a countdown,
 when the instrument panel central screen indicates "=0" , release
the button; the spanner disappears from the small screen.

74
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
 To obtain an even air distribution, take care not to obstruct the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
 Do not cover the sunshine sensor, located on the dashboard; this is used for regulation of the air conditioning system.
 Operate the air conditioning system for at least 5 to 10 minutes, once or twice a month to keep it in good working order.
 Ensure that the passenger compartment fi lter is in good condition and have the fi lter elements replaced regularly (refer
to the "Checks" section).
We recommend the use of a combined passenger compartment fi lter. Thanks to its special active additive,
it contributes to the purifi cation of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
 To ensure correct operation of the air conditioning system, you are also advised to refer to the warranty and maintenance
record for information on when it should be checked.
 If the system does not produce cold air, switch it off and contact a PEUGEOT dealer or a qualifi ed workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance. The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal. If after an extended stop in sunshine, the interior temperature is
very high, fi rst ventilate the cabin for a few moments.
Put the air fl ow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING

108
RCZ_EN_CHAP05_SECURITE_ED02-2013
Before operating the spoiler, ensure that no one is in the proximity
of the moving parts to avoid any risk of injury.
Nevertheless, in the event of pinching, you must reverse the
movement of the spoiler. To do this, release the control button
then press it again to raise the spoiler.
MAINTENANCE
To maintain the spoiler, with the vehicle stationary, ignition on:
 raise the spoiler to the maximum position B by pressing the
button briefl y,
 once the cleaning is complete, retract the spoiler: press and hold the button until the end of the manoeuvre.
The keep this system in good working order, check the spoiler and its
housing periodically preventing the unwanted accumulation of leaves,
ice or snow.
OPERATING FAULT
If the control system fails, the indicator lamp in the control button
fl ashes, accompanied by an audible signal and a message in the
screen. As a safety precaution, the spoiler rises to the maximum
position, regardless of the speed of the vehicle.
If the problem persists and you wish to retract the spoiler:
 stop where it is safe to do so,
 switch off the ignition,
 switch the ignition on again.
If the indicator lamp no longer fl ashes, the failure was temporary, the
system has resumed normal operation. To retract the spoiler, refer to
the paragraph "To exit from manual mode".
If the indicator lamp fl ashes again and the spoiler is still raised, the
system is still faulty.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
In the event of a system operating fault (e.g. jamming of the spoiler)\
, the
indicator lamp in the control button fl ashes, accompanied by an audible
signal and a message in the screen. For safety reasons, do not exceed
a speed of 85 mph (140 km/h).
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
Before washing the vehicle, always retract the spoiler into its
housing.
Keep the end of the high-pressure nozzle at least 1 metre from the
spoiler housing. Never press on the spoiler to close the boot or push the vehicle as
this may damage it.
The installation of load-carrying accessories on the vehicle limits
the effectiveness of the spoiler.
Do not install load carrying accessories which are not
recommended by PEUGEOT.
To exit from manual mode:
 press the button briefl y: the indicator lamp on the button goes off
(return to automatic mode).
At speeds below 6 mph (10 km/h), the spoiler stays in the open
position. It retracts automatically as soon as the vehicle exceeds
this speed threshold.

3
3
134
DISPLAYS IN THE INSTRUMENT PANEL
When you move the lever in the gate to select a position, the
corresponding symbol is displayed in the instrument panel.
P. Park
R. Reverse
N. Neutral
D1... D6. Drive (Automatic driving)
S. Sport programme
 . Snow programme
M1... M6. Manual (Sequential driving)
-. Invalid value during manual operation
MOVING OFF
 Apply the parking brake.
 Select position P or N .
 Start the engine.
If this procedure is not followed, there is an audible signal, accompanied
by a message in the screen.
 With the engine running, press the brake pedal.
 Release the parking brake.
 Select position R , D or M ,
 Gradually release the brake pedal.
The vehicle then moves off.
If position N is engaged inadvertently while driving, allow the
engine to return to idle then engage position D to accelerate.
When the engine is running at idle, with the brakes released, if
position R , D or M is selected, the vehicle moves even without the
accelerator being pressed.
When the engine is running, never leave children in the vehicle
without supervision.
When carrying out maintenance with the engine running, apply the
parking brake and select position P .
A message is displayed if you try to move the gear lever from
position
P without pressing the brake pedal.

156
CHECKING LEVELS
ENGINE OIL LEVEL
The check is carried out either when the ignition is switched
on using the oil level indicator in the instrument panel, or using
the dipstick.
Take care when working under the bonnet, as certain areas of the engine m\
ay be extremely hot (risk of burns) and the cooling fan could start
at any time (even with the ignition off).
Check all of these levels regularly, in line with the warranty and maintenance record. Top them up if necessary, unless otherwise indicated.
If a level drops signifi cantly, have the corresponding system checked by a PEUGEOT dealer or a qualifi ed workshop.
To ensure that the reading is correct, your vehicle must be on
level ground and the engine must have been off for more than
30 minutes.
It is normal to top up the oil level between two services (or oil chang\
es).
PEUGEOT recommends that you check the level, and top up if
necessary, every 3 000 miles (5 000 kms).
Checking using the dipstick
Refer to the "Petrol engine" or "Diesel engine" section for the location\
of
the dipstick in the engine compartment of your vehicle.
- Take the dipstick by its coloured grip and remove it completely.
- Wipe the end of the dipstick using a clean non-fl uffy cloth.
- Refi t the dipstick and push fully down, then pull it out again to make the visual check: the correct level is between the marks A and B . A = MAX
B = MIN
If you fi nd that the level is above the A mark or below the B mark, do
not start the engine .
- If the level is above the MAX mark (risk of damage to the engine),
contact a PEUGEOT dealer or a qualifi ed workshop.
- If the level is below the MIN mark, you must top up the engine oil.

7/
CHECKS
BRAKE FLUID LEVEL
The brake fl uid level should be close to the "MAX" mark. If it is
not, check the brake pad wear.
Changing the fluid
Refer to the warranty and maintenance record for details of the interval\

for this operation.
Fluid specification
The brake fl uid must conform to the manufacturer's recommendations.
POWER STEERING FLUID LEVEL
The power steering fl uid level should be close to the "MAX"
mark. With the engine cold, unscrew the cap to check the level.
Topping up the engine oil level
Oil grade
The oil must be the correct grade for your engine and conform to the
manufacturer's recommendations.
Refer to the "Petrol engine" or "Diesel engine" section to identify the \
location of the oil fi ller cap in the engine compartment of your vehicle.
- Unscrew the oil fi ller cap to reveal the fi ller aperture.
- Add oil in small quantities, avoiding any spills on engine components (risk of fi re).
- Wait a few minutes before checking the level again using the dipstick.
- Add more oil if necessary.
- After checking the level, carefully refi t the oil fi ller cap and the dipstick in its tube.
After topping up the oil, the check when switching on the ignition with \
the oil level indicator in the instrument panel is not valid during the \
30 minutes after topping up.
Engine oil change
Refer to the warranty and maintenance record for details of the interval\

for this operation.
In order to maintain the reliability of the engine and emission control \
system, the use of additives in the engine oil is prohibited.