warning Peugeot RCZ 2015 User Guide

19
RCZ_en_Chap01_controle-de-marche_ed01-2015
Warning/indicator lamp is on CauseAction / Observations
Rear foglamp fixed.The rear foglamp has been
switched on using the ring on the
lighting control stalk. Turn the ring on the lighting control stalk to the rear to
switch off the rear foglamp.
d

iesel engine
pre-heating fixed.The key is at position 2
(ignition on) in the ignition switch. Wait until the warning lamp goes off before starting.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about thirty
seconds in very low temperatures).
If the engine does not start, switch the ignition off and then
on, wait until the warning lamp goes off again, then start
the engine.
Parking brake fixed.The parking brake is applied or
not properly released. Release the parking brake to switch off the warning lamp,
keeping your foot on the brake pedal.
Observe the safety recommendations.
For more information on the parking brake, refer to the
corresponding section.
Passenger's
front airbag fixed
on the
seat belt and
passenger's front
airbag warning
lamps display

.The control switch, located on
the passenger's side of the
dashboard, has been placed in
the "ON" position.
The passenger's front airbag is
activated.
In this case, do not install
a
"rearward facing" child seat. While
you do not have a rearward facing child seat fitted
to the front passenger seat, it is recommended that the
passenger's front airbag be activated.
On

the other hand, before fitting a rearward facing child
seat, you must turn the control switch to the

"OFF"
position.
1/
MONITORING

20
RCZ_en_Chap01_controle-de-marche_ed01-2015
deactivation warning lamps
The other deactivation indicators appear in the form of symbols in the
large screen, located in the centre of the instrument panel.
Their display may be accompanied by an audible signal and a message
in the screen.Warning/indicator lamp is on CauseAction / Observations
Passenger's
front airbag fixed,
in the seat
belt and front
passenger's
airbag warning
lamps display

.The control switch, located
on the passenger's end of
the dashboard, is set to the
OFF


position.
The passenger's front airbag is
deactivated.
You can install a "rearward
facing" child seat on the front
seat. Before installing a rearward facing child seat on the front
seat, it is essential to deactivate the passenger's front
airbag.
On the other hand, where no rearward facing child seat is
present, it is recommended that the airbag be reactivated:
set the control to the ON position.

21
RCZ_en_Chap01_controle-de-marche_ed01-2015
COOLANT TEMPERATURE IN d ICATOR
With the engine running, when the needle is:
-

in zone
A, the temperature is correct,
-

in zone
B, the temperature is too high; the maximum temperature
warning lamp and the central STOP warning lamp come on,
accompanied by an audible signal and the display of an alert
message.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact
a PEUGEOT

dealer or a qualified workshop.
ENGINE OIL LEVEL IN d ICATOR
This information is displayed for a few seconds when the ignition is
switched on, at the same time as the service information.
The check of this level is only valid if the vehicle is on a level
surface, with the engine having been off for more than 30 minutes.
After driving for a few minutes, the temperature and pressure in the
cooling system increase.
To top up the level:
F

wait for the engine to cool,
F

unscrew the cap by two turns to allow the pressure to drop,
F

when the pressure has dropped, remove the cap,
F

top up the level to the "MA
x " mark.
1/
MONITORING

22
RCZ_en_Chap01_controle-de-marche_ed01-2015
Oil level correct
This is indicated by the flashing of "OIL" or an alert message in the
instrument panel, accompanied by illumination of the service warning
lamp and an audible signal.
If
the lack of oil is confirmed by a check using the dipstick, it is essential
that the level is topped up to prevent damage to the engine.
Refer to the "Checking levels" section. This

is indicated by the flashing of
"OIL--"
or the appearance of an alert
message in the instrument panel.
Contact a PEUGEOT

dealer or a qualified workshop.
In the event of a fault with the electric gauge, the oil level is no lon\
ger
monitored.
If the system is faulty, you should check the engine oil level using the
dipstick under the bonnet.
Refer to the "Checking levels" section.
Lack of oil Indicator fault

25
RCZ_en_Chap01_controle-de-marche_ed01-2015
MANUAL CHECK
This function allows you to check the status of the vehicle (reminder o\
f
the active alert warnings) and the service information.
F With
the engine running, to start a manual check, briefly press the
"CHECK/000" button on the instrument panel.
If no faults have been detected,

"CHECK OK" appears in the
instrument panel central screen.
If a "minor" fault has been detected, the warning lamp concerned then
"CHECK OK" appear in the instrument panel central screen. Contact a
PEUGEOT


or a qualified workshop.
If a "major" fault has been detected, only the warning lamps concerned
appear in the instrument panel central screen. Have it checked by a
PEUGEOT


dealer or a qualified workshop.
dISTANCE RECORdERS
The total and trip distances are displayed for thirty seconds when the
ignition is switched off, when the driver's door is opened and when the
vehicle is locked or unlocked.
Measures the total distance travelled by the vehicle since its first
registration.
Total distance recorder
F With the ignition on, press and hold this button until zeros appear .
Trip distance recorder
Measures the distance travelled since it was last reset to zero by the
driver.
1/
MONITORING

31
RCZ_en_Chap01_controle-de-marche_ed01-2015
MAIN MENU
F Press the "MENU" button to gain access to the main menu:
-
audio functions,
-


vehicle diagnostics,
-

personalisation-configuration,
-

telephone (Bluetooth system).
F


Press the "
5" or "6" buttons to select the menu required, then
confirm

by pressing the
"OK"
button.
"AUdIO FUNCTIONS" MENU
With the PEUGEOT Connect Sound (RD5) switched on, once this menu
has been selected you can activate or deactivate the functions linked
with use of the radio (RDS, REG, RadioText) or the CD (introscan,
shuffle, CD repeat).
For more information on the "Audio functions" application, refer to the \
"PEUGEOT


Connect Sound (RD5)" part of the "Audio equipment and
telematics" section.
"dIAGNOSIS VEHICLE" MENU
Once this menu has been selected, you can consult information
concerning the status of the vehicle.
Alert log
This summarises the active warning messages, displaying them in
succession on the multifunction screen.
F

On the "
d iagnosis vehicle" menu, select the following application:
F

Press the
"MENU" button to gain access to the main menu.
F

Press the arrows, then the
"OK" button to select the " d iagnosis
vehicle" menu.
1/
MONITORING

36
RCZ_en_Chap01_controle-de-marche_ed01-2015
You can adjust the angle of the screen to one of four defined positions, by repeated presses on the front or back of the control B
. The position
of the screen is memorised on closing.
Adjusting the angle of the screen
The screen opens automatically when the ignition is switched on. It
closes automatically three seconds after switching off the ignition if the
audio and telematics system is switched off.
ACCESS TO THE RETRACTABLE SCREEN
You can open or close the screen at any time, with the ignition on, using\

control A.
-

Press button
A: the screen folds.
-

Press button
A again: the screen opens again.
If you have closed the screen, it will open again automatically:
-

on switching on the audio and navigation system (unless it
had been closed manually while the system was in operation),
-


when an outgoing telephone call is made,
-


when a voice command is given,
-


when a warning message linked with the ST
OP warning lamp
is displayed (P
EUGEOT
Connect Navigation (R
T6)).

39
RCZ_en_Chap02_ouvertures_ed01-2015
Folding the key
F First press this button to fold the key.
LOCATING YOUR VEHICLE
R

EMOTE
CONTROL
PROBLEM
Following disconnection of the vehicle battery, replacement of the
remote control battery or in the event of a remote control malfunction, \
you can no longer unlock, lock or locate your vehicle.
F
First of all, use the key in the lock to unlock or lock your vehicle.
F


Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT

dealer as soon as
possible.
Reinitialisation
F Switch of f the ignition.
F
T
urn the key to position 2 (Ignition on) .
F

Press the closed padlock immediately for a few seconds.
F


Switch of
f the ignition and remove the key from the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR1620 / 3 volts.
If the battery is flat, you are informed by illumination of this
warning lamp, accompanied by an audible signal and an alert
message in the screen.
F


Unclip the casing using a coin at the notch.
F

Slide the flat battery out of its location.
F

Slide the new battery into its location observing the original
direction.
F


Clip the casing.
F


Reinitialise the remote control.
This function allows you to identify your vehicle from a
distance, particularly in poor light.

Your vehicle must be
locked.
F
Press the closed padlock on the remote control.
This will switch on the courtesy lamps and the direction indicators will\

flash

for

around

ten

seconds.
If you do not press the button when folding the key, there is a risk
of damage to the mechanism.
2/
ACCESS

47
RCZ_en_Chap02_ouvertures_ed01-2015
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.-

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot
lid and fuel filler flap from inside the vehicle.
Locking
F Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
F Press this button again to unlock the vehicle.
The red indicator lamp on the button goes of f.
Locking / deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp flashes and the button is inactive.
F

With normal locking, pull on the interior door control lever to
unlock the vehicle.
F


With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
-

first

lock

the

vehicle

using

the

remote

control

or

the

key,
-

avoid spraying the upper part of the windows,
-


keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly:
Be aware of the risk of pinching when the window rises
automatically on closing the door

.
-

when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
2/
ACCESS

49
RCZ_en_Chap02_ouvertures_ed01-2015
BOOT
OPENING
F Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
F

Lift the boot lid.
This


action
also unlocks the doors and the fuel filler flap.
Using the manual control; vehicle unlocked
F Press the opening control above the number plate.
F
Lift the boot lid.
CLOSING
F Lower the boot lid using one of the interior grab handles.
F
If necessary
, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly: -

when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.
Using the remote control
Emergency locking
If the central locking system fails (flat battery), you are advised to disconnect the battery.
-

when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Never grasp the boot lid by the active spoiler
.
2/
ACCESS