check engine Peugeot RCZ 2015 Owner's Manual

3
RCZ_en_Chap00a_sommaire_ed01-2015
Driving recommendations 115
Starting-switching off the engine 1 16
Parking brake

1
19
Hill start assist

120Manual gearbox

121
Automatic gearbox 122
Gear shift indicator

126
T

yre under-inflation detection
127Speed limiter

129
Cruise control 132
Parking sensors

135
Fuel tank


139
Bonnet


141
Petrol engines


142Diesel engine


143
Running out of fuel (Diesel)


144
Checking levels


145Checks


148
T

emporary puncture repair kit
150
Changing a wheel


157
Snow chains


162
Changing a wiper blade


163Energy economy mode


164
12 V battery


165
Changing a bulb


169
Changing a fuse


177
T

owing a vehicle
184T

owing a trailer
186
Cleaning and maintenance


188
Accessories

190
6/ 115-137dRIVING
7/ 138-149CHECKS
8/ 150-191PRACTICAL INFORMATION
279-283
ALPHABETICAL INdEX
Petrol engines 192
W eights (petrol) 193Diesel engine
195
W eights (Diesel) 196Dimensions
197
Identification markings 199
9/ 192-200TECHNICAL dATA
Emergency or assistance 201P EUGEOT Connect Navigation (R T6) 203P EUGEOT Connect Sound (RD5) 259
10/ 201-278AUdIO EQUIPMENT ANd TELEMATICS
CONTENTS

9
RCZ_en_Chap00b_vue-ensemble_ed01-2015
Running out of fuel, Diesel 144
Checking levels
145-147
-

oil
- brake
fluid
- power
steering fluid
-
coolant
- screenwash/headlamp
wash fluid
- additive
(Diesel with particle filter)
Changing bulbs

169-176
-

front
-
rear
Cleaning and maintenance

188-189
-

interior
-
exterior Opening the bonnet

141
Under the bonnet, petrol


142
Under the bonnet, Diesel


143Energy economy mode


164
Battery

165-168
Engine compartment fuses

177-178, 181-183
Checking components


148-149
-

battery
- air
filter and passenger compartment filter
- oil
filter
- particle
filter (Diesel)
-
gearboxes
-

brake pads / discs
TECHNICAL DATA - M AINTENANCE
Petrol engines 192
Petrol weights 193-194
Diesel engine

195
Diesel weights


196
Dimensions


197-198
Identification

markings 199
OVERVIEW

11
RCZ_en_Chap00c_eco-conduite_ed01-2015
LIMIT THE CAUSES OF EXCESS
CONSUMPTION
Spread loads throughout the vehicle; place the heaviest items in the
bottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof\

bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.
Remove roof bars and roof racks after use.
At
the end of winter, remove snow tyres and refit your summer tyres.
OBSERVE THE RECOMMENdATIONS ON
MAINTENANCE
Check the tyre pressures regularly, when cold, referring to the label in
the door aperture, driver's side.
Carry out this check in particular:
-

before a long journey
,
-

at each change of season,
-


after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have

your vehicle serviced regularly (engine oil, oil filter, air filter,
passenger

compartment filter...) and observe the schedule of
operations recommended in the warranty and maintenance record.
When refuelling, do not continue after the third cut-of

f of the nozzle to
avoid
any overflow.
At
the wheel of your new vehicle, it is only after the first 1 800 miles

(3 000 kilometres) that you will see the fuel consumption settle down \
to a consistent average.
ECO-DRIVING

12
RCZ_en_Chap01_controle-de-marche_ed01-2015
INSTRUMENT PANELS : PETROL OR
D IESEL , MANUAL

OR
AUT
OMATIC
GEARBO

x
dIALS
1. Rev counter .
Indicates the speed of rotation of the engine (x 1 000 rpm).
2.


Coolant temperature
gauge.
Indicates the temperature of the engine coolant (°Celsius).
3.


Fuel
gauge.
Indicates
the quantity of fuel remaining in the tank.
4.

Speedometer
.
Indicates the current speed of the moving vehicle (mph or km/h).
5.


Small display screen.
6.


Central display screen.
7.

d
isplay management button.
Starts a manual CHECK.
Recalls the service information.
Resets the selected function to zero (trip distance recorder or
service indicator).
8.


Lighting dimmer button.
Adjusts the brightness of the lighting of the instruments and
controls.
With large central display screen
Panel grouping together the vehicle operation indication dials and
warning lamps, with permanent back-lighting.
For more information, refer to the section relating to the button or
function and its associated display.
With small central display screen

13
RCZ_en_Chap01_controle-de-marche_ed01-2015
dISPLAYS
* According to engine.
** Only with the large central display screen.
Small display screen
A. Trip distance recorder.
(miles or km)
B.

d
istance recorder.
(miles or km)
C.


Service spanner
, if a service is due shortly or is overdue.
Central display screen
d. Speed limiter
(mph or km/h) or



Cruise control.
E.


Indication of:
-


a gear change*,



or
-

the programme or gear (automatic gearbox).
F

.
Engine oil level indicator
,
service indicator

.
(miles or km)
These two functions are displayed when the ignition is switched on,
then disappear after a few seconds.



W
arning and status indicator lamps / CHECK.


T
rip computer.


Alert messages**.



V
ehicle speed repeat**.


Navigation - Guidance**.
These functions are displayed according to the selection.
1/
MONITORING

15
RCZ_en_Chap01_controle-de-marche_ed01-2015
Warning/indicator lamp is on CauseAction / Observations
STOP fixed,
alone
or associated
with another
warning lamp,
accompanied by
an audible signal
and a message
in the screen.Illumination of this warning lamp
is associated with a serious fault
with the braking system, power
steering, engine lubrication
system or cooling system.
Stop as soon as it is safe to do so as there is a risk that the
engine will cut out while driving.
Park, switch of

f the ignition and contact a PEUGEOT
dealer
or a qualified workshop.
Maximum
coolant
temperature fixed
with the
needle in the red
zone.The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
W

ait until the engine has cooled down before topping up
the level, if necessary.
If the problem persists, contact a PEUGEOT dealer or a
qualified
workshop.
Braking
fixed,
associated
with the ST

OP
warning lamp. The
braking system fluid level is
too low

.You must stop as soon as it is safe to do so.
Top
up with brake fluid recommended by PEUGEOT.
If the problem persists, have the system checked by a
PEUGEOT


dealer or a qualified workshop.
+ fixed,
associated
with the ST

OP
and ABS warning
lamps. The electronic brake force
distribution (EBFD) system has
a fault.
You must stop as soon as it is safe to do so.
Have
it checked by a PEUGEOT

dealer or a qualified
workshop.
1/
MONITORING

16
RCZ_en_Chap01_controle-de-marche_ed01-2015
Engine
autodiagnosis
systemflashing.
The engine management system
has a fault. Risk of destruction of the catalytic converter.
Have
it checked by a PEUGEOT dealer or a qualified workshop.
fixed. The emission control system has
a fault. The warning lamp should go of
f when the engine is started.
If
it does not go off, contact a PEUGEOT

dealer or qualified
workshop without delay

.
Low fuel level fixed
with the
needle in the
red zone,
accompanied by
an audible signal
and a message.When

it first comes on there
remains approximately 5 litres

of
fuel in the tank.
At this point, you begin to use the
fuel reserve. Refuel as soon as possible to avoid running out of fuel.
Until
sufficient fuel has been added, this warning lamp
will come on every time the ignition is switched on,
accompanied by an audible signal and a message.
The audible signal and message are repeated with
increasing

frequency as the fuel level drops towards
"0"
.
Fuel tank capacity: approximately 55 litres.
Never continue to drive until you run out of fuel, as this
could damage the emission control and injection systems.
Warning/indicator
lamp is on CauseAction / Observations
Service on temporarily.
A minor fault has occurred for
which there is no specific warning
lamp.
Identify the fault by reading the message shown in the
screen, such as, for example:
-

opening of the doors, boot or bonnet,
-

low engine oil level,
-

low screenwash level,
-
flat remote control battery,
- saturation of the particle emission filter (Diesel)
As soon as traffic conditions permit, regenerate the
filter

by driving at a speed of at least 36 mph (60 km/h)
until the service warning lamp goes of

f.
- a fault with the tyre under-inflation detection system,
- ...
For any other faults, contact a PEUGEOT dealer or a
qualified workshop.
fixed. A major fault has occurred for
which there is no specific warning
lamp.
Identify the fault by reading the message shown on the
screen
and contact a PEUGEOT

dealer or a qualified
workshop.

21
RCZ_en_Chap01_controle-de-marche_ed01-2015
COOLANT TEMPERATURE IN d ICATOR
With the engine running, when the needle is:
-

in zone
A, the temperature is correct,
-

in zone
B, the temperature is too high; the maximum temperature
warning lamp and the central STOP warning lamp come on,
accompanied by an audible signal and the display of an alert
message.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact
a PEUGEOT

dealer or a qualified workshop.
ENGINE OIL LEVEL IN d ICATOR
This information is displayed for a few seconds when the ignition is
switched on, at the same time as the service information.
The check of this level is only valid if the vehicle is on a level
surface, with the engine having been off for more than 30 minutes.
After driving for a few minutes, the temperature and pressure in the
cooling system increase.
To top up the level:
F

wait for the engine to cool,
F

unscrew the cap by two turns to allow the pressure to drop,
F

when the pressure has dropped, remove the cap,
F

top up the level to the "MA
x " mark.
1/
MONITORING

22
RCZ_en_Chap01_controle-de-marche_ed01-2015
Oil level correct
This is indicated by the flashing of "OIL" or an alert message in the
instrument panel, accompanied by illumination of the service warning
lamp and an audible signal.
If
the lack of oil is confirmed by a check using the dipstick, it is essential
that the level is topped up to prevent damage to the engine.
Refer to the "Checking levels" section. This

is indicated by the flashing of
"OIL--"
or the appearance of an alert
message in the instrument panel.
Contact a PEUGEOT

dealer or a qualified workshop.
In the event of a fault with the electric gauge, the oil level is no lon\
ger
monitored.
If the system is faulty, you should check the engine oil level using the
dipstick under the bonnet.
Refer to the "Checking levels" section.
Lack of oil Indicator fault

24
RCZ_en_Chap01_controle-de-marche_ed01-2015
Service overdue
For a few seconds after the ignition is switched on, the spanner
flashes to indicate that the service must be carried out as soon as
possible.
Example: the service is overdue by 300 miles (300
km).
For a few seconds after the ignition is switched on, the central screen \
indicates:
The spanner remains on in the small screen
to indicate that a service should have been
carried out.
The distance remaining may be weighted by the time factor,
depending on the type of motoring the vehicle is used for.
Therefore, the spanner may also come on if you have exceeded
the
period since the last service specified in the manufacturer's
service schedule.
This indication applies only to HDi Diesel engines.
Service indicator reset
Retrieving the service information
You can access the service information at any time.
This information appears when running through the manual check
procedure.
F Briefly press the "CHECK/000" button.
The service information is displayed for a few seconds on the
instrument panel central screen, then disappears.
Following this operation, if you wish to disconnect the battery

,
lock the vehicle and wait at least five minutes for the reset to be
registered.
After each service, the service indicator must be reset.
If you have carried out the service on your vehicle yourself:
F

switch of
f the ignition,
F
press and hold the
"CHECK/000" button,
F

switch on the ignition; the distance recorder display begins a
countdown,
F

when the instrument panel central screen indicates
"=0"
, release
the button; the spanner disappears from the small screen.