display Peugeot RCZ 2015 Owner's Manual

6
RCZ_en_Chap00b_vue-ensemble_ed01-2015
Instrument panels 12-13
W arning lamps 14-20
Indicators
21-24
Buttons
25-26
-

Check / service indicator / trip distance
recorder
-


lighting dimmer
Headlamp height adjustment


81
Door mirrors


55-56
Electric windows


44-45
Dashboard fuses


177-180
Opening the bonnet


141Courtesy lamps

64
Seat belt / passenger's front airbag warning lamps display
96-97
Rear view mirror

57
Sun visor


68
Parking brake


1
19
Active spoiler control

93-94Ignition switch / Steering lock / Starting


1
16-118
Multifunction screens

30-36
Clock


26
P

EUGEOT
Connect Navigation (R
T6)
2
03-258
P
EUGEOT
Connect Sound (RD5)

259-278
V

entilation 59-60
Dual zone digital air conditioning

61-63
Automatic gearbox


122-125
Manual gearbox


121
Gear shift indicator


126
Hill start assist


120
INSTRUMENTS AND CONTROLS

10
RCZ_en_Chap00c_eco-conduite_ed01-2015
OPTIMISE THE USE OF YOUR GEARBOX
With a manual gearbox, move off gently and change up without
waiting. During acceleration change up early.
With an automatic or electronic gearbox, give preference to automatic
mode and avoid pressing the accelerator pedal heavily or suddenly.
The gear shift indicator invites you engage the most suitable gear: as
soon as the indication is displayed in the instrument panel, follow it
straight away.
For
vehicles fitted with an electronic or automatic gearbox, this
indicator appears only in manual mode.
dRIVE SMOOTHLY
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and
CO
2 emissions and also helps reduce the background traffic noise.
CONTROL THE USE OF YOUR ELECTRICAL
EQUIPMENT
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember
to make use of equipment that can help keep the temperature
in the passenger compartment down (sunroof and window blinds...).
Switch of

f the air conditioning, unless it has automatic regulation, as soon
as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the level of light
does
not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices
(film,
music, video game...), you will contribute towards limiting the
consumption of electrical energy

, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
ECO-DRIVING
Eco-driving is a range of everyday practices that allow the motorist to \
optimise their fuel consumption and CO2 emissions.
If your vehicle has cruise control, make use of the system at speeds
above

25

mph

(40

km/h)

when

the

traffic

is

flowing

well.

12
RCZ_en_Chap01_controle-de-marche_ed01-2015
INSTRUMENT PANELS : PETROL OR
D IESEL , MANUAL

OR
AUT
OMATIC
GEARBO

x
dIALS
1. Rev counter .
Indicates the speed of rotation of the engine (x 1 000 rpm).
2.


Coolant temperature
gauge.
Indicates the temperature of the engine coolant (°Celsius).
3.


Fuel
gauge.
Indicates
the quantity of fuel remaining in the tank.
4.

Speedometer
.
Indicates the current speed of the moving vehicle (mph or km/h).
5.


Small display screen.
6.


Central display screen.
7.

d
isplay management button.
Starts a manual CHECK.
Recalls the service information.
Resets the selected function to zero (trip distance recorder or
service indicator).
8.


Lighting dimmer button.
Adjusts the brightness of the lighting of the instruments and
controls.
With large central display screen
Panel grouping together the vehicle operation indication dials and
warning lamps, with permanent back-lighting.
For more information, refer to the section relating to the button or
function and its associated display.
With small central display screen

13
RCZ_en_Chap01_controle-de-marche_ed01-2015
dISPLAYS
* According to engine.
** Only with the large central display screen.
Small display screen
A. Trip distance recorder.
(miles or km)
B.

d
istance recorder.
(miles or km)
C.


Service spanner
, if a service is due shortly or is overdue.
Central display screen
d. Speed limiter
(mph or km/h) or



Cruise control.
E.


Indication of:
-


a gear change*,



or
-

the programme or gear (automatic gearbox).
F

.
Engine oil level indicator
,
service indicator

.
(miles or km)
These two functions are displayed when the ignition is switched on,
then disappear after a few seconds.



W
arning and status indicator lamps / CHECK.


T
rip computer.


Alert messages**.



V
ehicle speed repeat**.


Navigation - Guidance**.
These functions are displayed according to the selection.
1/
MONITORING

14
RCZ_en_Chap01_controle-de-marche_ed01-2015
WARNING AN d IN d ICATOR LAMPS
Visual indicators which inform the driver of the occurrence of a
fault (warning lamp) or of the operation of a system (operation or
deactivation indicator lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is
switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the
warning lamp concerned.
Associated warnings
The illumination, fixed or flashing, of certain warning lamps may be accompanied by an audible signal and a message in the screen.
Depending on your version of instrument panel, illumination of the
warning lamp is also accompanied by:
-

a symbol in the central instrument panel screen and a message in
the multi-function screen,


or
-

a symbol and a message in the central instrument panel screen.
Warning lamps
When the engine is running or the vehicle is being driven, the
illumination of one of the following warning lamps indicates a fault whi\
ch
requires action on the part of the driver.
The illumination of a warning lamp is always accompanied by the
display of an additional message, to assist you in identifying the
fault.
If you encounter any problems, contact a PEUGEOT dealer or a
qualified
workshop.

17
RCZ_en_Chap01_controle-de-marche_ed01-2015
Anti-lock
Braking
System (ABS)fixed.
The anti-lock braking system has
a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a PEUGEOT
dealer
or a qualified workshop without delay.
d

ynamic
stability control
(
d SC/ASR) flashing.
The DSC/ASR regulation is
operating. The system optimises traction and improves the directional
stability of the vehicle in the event of loss of grip or trajectory.
fixed. The DSC/ASR system has a
fault. Have
it checked by a PEUGEOT

dealer or a qualified
workshop.
d

irectional
headlamps flashing.The directional headlamps
system has a fault. Have
it checked by a PEUGEOT

dealer or a qualified
workshop.
W

arning/indicator
lamp is on CauseAction / Observations
Seat belt not
fastened /
unfastened fixed,
then
flashing

in the
passenger's seat
belt and front
airbag warning
lamp display

.The driver or front passenger has
not fastened or has unfastened
their seat belt.
Pull
on the belt in question and insert the tongue in the
buckle.
For more information, refer to the "Seat belts" section.
At least one rear passenger has
unfastened their seat belt.
Under-inflation fixed.
The pressure in one or more
wheels is too low

.Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the tyres
are cold.
+ flashing
then fixed,
accompanied


by the Service
warning lamp. The tyre pressure monitoring
system has a fault or no sensor is
detected on one of the wheels.
Under-inflation
detection is not assured.
Have the system checked by a PEUGEOT dealer or a
qualified
workshop.
1/
MONITORING

19
RCZ_en_Chap01_controle-de-marche_ed01-2015
Warning/indicator lamp is on CauseAction / Observations
Rear foglamp fixed.The rear foglamp has been
switched on using the ring on the
lighting control stalk. Turn the ring on the lighting control stalk to the rear to
switch off the rear foglamp.
d

iesel engine
pre-heating fixed.The key is at position 2
(ignition on) in the ignition switch. Wait until the warning lamp goes off before starting.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about thirty
seconds in very low temperatures).
If the engine does not start, switch the ignition off and then
on, wait until the warning lamp goes off again, then start
the engine.
Parking brake fixed.The parking brake is applied or
not properly released. Release the parking brake to switch off the warning lamp,
keeping your foot on the brake pedal.
Observe the safety recommendations.
For more information on the parking brake, refer to the
corresponding section.
Passenger's
front airbag fixed
on the
seat belt and
passenger's front
airbag warning
lamps display

.The control switch, located on
the passenger's side of the
dashboard, has been placed in
the "ON" position.
The passenger's front airbag is
activated.
In this case, do not install
a
"rearward facing" child seat. While
you do not have a rearward facing child seat fitted
to the front passenger seat, it is recommended that the
passenger's front airbag be activated.
On

the other hand, before fitting a rearward facing child
seat, you must turn the control switch to the

"OFF"
position.
1/
MONITORING

20
RCZ_en_Chap01_controle-de-marche_ed01-2015
deactivation warning lamps
The other deactivation indicators appear in the form of symbols in the
large screen, located in the centre of the instrument panel.
Their display may be accompanied by an audible signal and a message
in the screen.Warning/indicator lamp is on CauseAction / Observations
Passenger's
front airbag fixed,
in the seat
belt and front
passenger's
airbag warning
lamps display

.The control switch, located
on the passenger's end of
the dashboard, is set to the
OFF


position.
The passenger's front airbag is
deactivated.
You can install a "rearward
facing" child seat on the front
seat. Before installing a rearward facing child seat on the front
seat, it is essential to deactivate the passenger's front
airbag.
On the other hand, where no rearward facing child seat is
present, it is recommended that the airbag be reactivated:
set the control to the ON position.

21
RCZ_en_Chap01_controle-de-marche_ed01-2015
COOLANT TEMPERATURE IN d ICATOR
With the engine running, when the needle is:
-

in zone
A, the temperature is correct,
-

in zone
B, the temperature is too high; the maximum temperature
warning lamp and the central STOP warning lamp come on,
accompanied by an audible signal and the display of an alert
message.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact
a PEUGEOT

dealer or a qualified workshop.
ENGINE OIL LEVEL IN d ICATOR
This information is displayed for a few seconds when the ignition is
switched on, at the same time as the service information.
The check of this level is only valid if the vehicle is on a level
surface, with the engine having been off for more than 30 minutes.
After driving for a few minutes, the temperature and pressure in the
cooling system increase.
To top up the level:
F

wait for the engine to cool,
F

unscrew the cap by two turns to allow the pressure to drop,
F

when the pressure has dropped, remove the cap,
F

top up the level to the "MA
x " mark.
1/
MONITORING

23
RCZ_en_Chap01_controle-de-marche_ed01-2015
SERVICE INdICATOR
This information is displayed for a few seconds when the ignition is
switched on. It informs the driver when the next service is due, in
accordance with the manufacturer's service schedule.
The point at which the service is due is calculated from the last indica\
tor
zero reset. It is determined by two parameters:
-
the distance travelled,
-


the time elapsed since the last service (only on HDi Diesel
versions).
More than 1 800 miles (3 000 km) remain before the next service is due\
When the ignition is switched on, no service information appears on the \
instrument panel central screen.
Between 600 miles (1 000 km) and 1 800 miles (3 000 km)
remain before the next service is due
For a few seconds after the ignition is switched on, the spanner
symbolising the service operations comes on. The instrument panel central
screen indicates the distance remaining before the next service is due.
Example: 1 700 miles (2 800 km) remain before the next service is due.
For a few seconds after the ignition is switched on, the central screen
indicates:
Less than 600 miles (1 000 km) remain before the next service is due
Example: 500 miles (900 km) remain before the next service is due.
For a few seconds after the ignition is switched on, the central screen \
indicates:
The spanner remains on in the small screen
to indicate that a service must be carried out
soon.
1/
MONITORING