check oil RENAULT KANGOO 1997 KC / 1.G Chassis Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 105
Page 30 of 105
REAR AXLE
Brake cylinder
REFITTING
Remove all dust from the drums and the linings
using brake cleaner.
Refitting is the reverse of removal.
Bleed the braking circuit (see section 38).
Adjust the linings by repeatedly pressing the
brake pedal.
Check the cut-out pressure (see section 37
"Controls").
TIGHTENING TORQUES (in daN.m)
Wheel bolts 9
Hub nut 17.5
Bleed screw 0.5 to 0.8
Pipe bolt 1.7
REMOVAL
Remove:
- the drum (see corresponding section),
- the upper return spring (see paragraph
"Brake linings").
Separate the shoes.
Slacken:
- the rigid pipe union on the wheel cylinder
using a pipe wrench,
- the two cylinder mounting bolts on the
backing plate and remove it.
Check the condition of the shoes. If they have
traces of oil on them, renew them.
33
33-4
Page 57 of 105
STEERING ASSEMBLY
Power assisted steering rack
36
Disconnect the high and low pressure pipes on the
steering rack (take precautions to catch the oil)
and the nut on the pipe retaining bracket.
Remove:
- the two nuts on the heat shield for the right
hand steering rack bearing,
- the steering rack mounting nuts and remove it
from the timing side.
NOTE :
- do not remove the pipes between the valve
and cylinder,
- fit plugs to the steering rack openings to
prevent the introduction of impurities.
12997R
REFITTING
Refitting is the reverse of removal. Observe the
recommended tightening torques.
Fill the circuit with oil.
Turn the wheels from left to right (engine not
running) to distribute the oil in the circuit.
Repeat the operation with the engine running
then top up the level.
If a new steering rack is being fitted, fit the track
rod ends in the position noted on removal.
To do this, slacken the bolt on the parallelism
adjustment sleeve and slacken the track rod end
while holding the axial ball joint using an open
wrench.
Make a mark or count the number of turns of
thread taken up so the parallelism can be pre-
adjusted on refitting.
Check the parallelism.
36-5