open bonnet RENAULT KANGOO 1997 KC / 1.G Electrical Equipment Workshop Manual

WIPERS
Front windscreen wiper
REMOVAL OF THE WIPER MECHANISM WITH
MOTOR
Make sure that the wiper motor is in the park
position.
Disconnect the battery.
Note the position of the wiper arms.
Open the bonnet.
Remove:
- the wiper arms using tool Elé. 1294-01,
- the scuttle panel grille seal,
- the scuttle panel grille after removing the two
side covers and the two bolts and disconnecting
the washer pipe.
85
13069R
Remove the three mechanism mounting bolts (A).
Disconnect the motor and release the assembly.
SPECIAL TOOLING REQUIRED
Elé. 1294-01 Wiper arm removing tool
Special notes for refitting
Check that the motor is in the park position be-
fore refitting the wiper arms.
Clean the splines on the wiper arm pins using a
metal brush.
Refit the wiper arms, locating the blade on the
marks made on removal.
Fit new nuts and torque tighten to 1.8 daN.m (±
15 %) using a torque wrench.
85-1

WIPERS
Front windscreen wiper
85
13069R1
Remove:
- the motor shaft nut (B) and release the linkage
after noting its position,
- the three motor mountings.
Release the motor after disconnecting it.
Special notes for refitting
Refit the linkage to the motor on the mark made
during removal.
Check that the motor is in the park position be-
fore refitting the wiper arms.
Clean the splines on the wiper arm pins using a
metal brush.
Refit the wiper arms, locating the blade on the
marks made on removal.
Fit new nuts and torque tighten to 1.8 daN.m (±
15 %) using a torque wrench.REMOVING THE MOTOR ALONE
Make sure that the wiper motor is in the park po-
sition.
Disconnect the battery.
Note the position of the wiper arms.
Open the bonnet.
Remove:
- the wiper arms using tool Elé. 1294-01,
- the scuttle panel grille seal,
- the scuttle panel grille after removing the two
side covers and the two bolts and disconnecting
the washer pipe.
85-2