steering wheel adjustment RENAULT KANGOO 1997 KC / 1.G Electrical Equipment Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 83
Page 3 of 83
81-1
81-2
Contents
BATTERIE PROJECTEURS
Battery
Special notes
Headlights
Lens units and indicators
Remote adjustment
80-1
80-3
80-4
ECLAIRAGE ARRIERE
Courtesy light
Fuses
PagePage
Electrical
Equipment
WIPERS
Front windscreen wiper
Rear screen wiper
Electric washer pump
85-1
85-3
85-4
85
Coded key immobiliser system82-1
IMMOBILISER82
Relay plate87-1
ELECTRICAL ASSISTANCE EQUIPMENT
REAR AND INTERIOR LIGHTS
BATTERY - HEADLIGHTS80
81
87
Dashboard
Instrument panel
Fuel level sensor
Oil level sensor
Coolant temperature sensor83-1
83-6
83-10
83-12
83-13
INSTRUMENT PANEL83
Windscreen wiper stalk
Lights stalk
Stalk mounting
Rotary switch under steering
wheel
Ignition switch84-1
84-2
84-3
84-4
84-6
CONTROLS - SIGNALS84
WIRING
Heated rear screen
Remote control for door locking
Airbags and seat belt pretensioners
88-1
88-3
88-8
88
Page 32 of 83
INSTRUMENT PANEL
Dashboard
83
- the loud speaker grilles,
- the dashboard mountings.
Gently pull the dashboard.
Release the wiring retaining clips.
Disconnect:
- the headlight remote adjustment control
connector and hazard warning light connector,
- the remaining connectors (example : decoder
unit).
Remove the dashboard.REFITTING
When refitting, it is important to ensure the va-
rious wires are correctly routed and have suffi-
cient space so that the dashboard can be correctly
centred.
SPECIAL NOTES FOR REFITTING THE STEERING
WHEEL WITH AIRBAG
Ensure the rotary switch under the steering wheel
is correctly positioned.
If there is any doubt that this switch is correctly
centred follow the method for centring described
in section 88 "driver’s airbag".
Renew the steering wheel bolt each time it is re-
moved (pre-bonded bolt) for a steering wheel
with airbag.
Observe the correct tightening torque (4.5
daN.m).
IMPORTANT
Before reconnecting the driver’s airbag cushion,
check to see if the system is operating correctly as
follows:
•check the airbag warning light on the
instrument panel is illuminated when the
ignition is on,
•connect a dummy ignition module to the
driver’s airbag connector and check that the
warning light extinguishes,
•switch the ignition off, connect the airbag
cushion in place of the dummy ignition module
and secure the cushion to the steering wheel,
•switch the ignition on. Check the warning light
illuminates for three seconds when the ignition
is switched on then extinguishes and remains
extinguished.
If the warning light does not operate exactly as
described above, refer to the fault finding section
and test the system using the XRBAG (Elé. 1288)
(see section 88).
12964R
83-5