ECU RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual KANGOO 1997 KC / 1.G RENAULT RENAULT https://www.carmanualsonline.info/img/7/1731/w960_1731-0.png RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual

Page 13 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual ENGINE AND ENGINE PERIPHERALS
Engine and transmission assembly
10
REMOVAL
Put the vehicle on a 2 post lift.
Disconnect:
- the battery,
- the electrical connectors from the engine
connection unit and i

Page 36 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual TIGHTENING TORQUES  (in daN.m)
TOP AND FRONT OF ENGINE
Timing belt
REMOVAL
Place the vehicle on a two post lift.
Disconnect the battery.
Remove :
- the front right hand wheel,
- the  belt from the alt

Page 46 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual 12mm torx  socket  
Angular  tightening wrench
TOP AND FRONT OF ENGINE
Cylinder head gasket
11
SPECIAL TOOLING REQUIRED
Mot. 591-04 Angle wrench for  tightening
cylinder head  and index
Mot. 1202 Hose

Page 75 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual FUEL MIXTURE
Inlet manifold
12
Inlet manifold bolt and nut 2
TIGHTENING TORQUES (in daN.m)
REMOVAL
Remove:
- the air filter,
- the injector gallery (see section 13).
Lift the vehicle.
Remove the strut

Page 79 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual FUEL MIXTURE
Inlet/Exhaust manifolds
12F8Q engine
Manifold mounting studs on cylinder head  1
Manifold mounting nuts on cylinder head 2.7
Inlet manifold strut mounting bolt 2.5
Cylinder block strut mo

Page 100 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual DIESEL EQUIPMENT
Advance solenoid valve
13
13342R
To remove the terminals from the pump
connector :
1) Pull the yellow guide to release the terminal
connectors,  then press on the two tabs on
each sid

Page 107 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual DIESEL EQUIPMENT 
Coded solenoid valve
13
On this type of vehicle,   the replacement of the
solenoid valve and of the coded electronic unit (A)
requires the removal of the injection pump from
the engi

Page 120 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual DIESEL EQUIPMENT 
Pump
13
Remove :
- the fuel supply pipe (A),
- the fuel return pipe (B),
- the pump connector (C),
- the accelerator cable (D),
- the vacuum pipe (E) connected  to the  fast
idle spe

Page 125 of 208

RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual DIESEL EQUIPMENT
Pump - Timing
13
DI1303-1
- Fit pin  Mot. 1054.
12419R
- Keep a constant  pressure on the pin.
- Turn the engine slowly until the pin
penetrates in the slot in  the crankshaft. 
-   U