automatic transmission RENAULT KANGOO 1997 KC / 1.G Engine And Peripherals Workshop Manual

INJECTION
General
17
SPECIAL NOTES FOR MULTIPOINT INJECTION
• 35 track SAGEM or MAGNETI MARELLI computer for vehicles without options.
• 55 track SAGEM computer ,
SAFIR or MAGNETI MARELLI type for versions with air conditioning.
•Semi-sequential multipoint injection. Injectors controlled two by two (injectors for cylinders 1 and 4 fol-
lowed by injectors for cylinders 2 and 3).
•Semi-static ignition with dual single unit coils.
•Canister bleed solenoid valve controlled by RCO signal.
•Computer configuration depending on gearbox type (manual gearbox or automatic transmission).
•The maximum engine speed permitted is 6 200 rpm.
•Idle speed correction depending on :
- battery voltage,
- air conditioning
- power assisted steering pressostat.
•Injection warning light on instrument panel not operational.
•Use fault finding fiche n° 27. D7F Engine
FITTING A 2ND GENERATION ENGINE IMMOBILISER REQUIRES A SPECIAL PROCEDURE FOR REPLACING THE
COMPUTER.
17-4

INJECTION
General
17
SPECIAL NOTES FOR MULTIPOINT INJECTION
• 55 track SIEMENS FENIX 5 computer.
•Semi-sequential multipoint injection. Injectors are controlled two by two (injectors for cylinders 1 and 4
followed by cylinders 2 and 3).
•Semi-static ignition with dual coils.
•Canister bleed solenoid controlled by RCO signal.
•Computer configuration depending on gearbox type (manual gearbox or automatic transmission)
•Idle speed correction depending on :
- air conditioning,
- power assisted steering pressostat,
- battery voltage.
•Injection warning light on instrument panel operational.
•Use fault finding fiche n° 27.
•Maximum speed :
-6 200 rpm if 1st , 2nd or 3rd gears
-6 000 rpm if 4th,or 5th gears. E7J Engine
FITTING A 2ND GENERATION ENGINE IMMOBILISER REQUIRES A SPECIAL PROCEDURE FOR REPLACING THE
COMPUTER.
17-5

INJECTION

Computer configuration depending on gearbox type17
The screen will display :
COMPUTER CONFIGURATION DEPENDING ON GEARBOX TYPE (MANUAL GEARBOX OR AUTOMATIC
TRANSMISSION)
Each time the injection computer is replaced, it must be programmed with the type of gearbox (manual or
automatic) which is fitted in the vehicle. The computers are designed to function with either type of gearbox.
Method for configuring the computer
Connect the
XR25
Select S8
Switch on the ignition
Enter D13 then
For vehicles fitted with manual gearbox :
Enter G50* 2*
For vehicles fitted with automatic transmission :
Enter G50* 1*
if the configuration has not been made
To ensure that the computer has memorised the data correctly, switch the ignition back on , using fault fin-
ding fiche n° 27; the fault bargraph
20 LH should be extinguished, whilst the 19 LH or RH status bargraph
should be illuminated.
then if the configuration is complete
17-16