transmission RENAULT KANGOO 1997 KC / 1.G Sheet Metal Work Workshop Manual

GENERAL
Means of lifting
40
SAFETY SYMBOL
There are several examples :
1 - WHEN REMOVING PARTS
Generally speaking, never use a 2 post lift if a
four post lift would be more suitable.
If this is not possible, position the lifting pads
below the body flange at the jacking points for
the jack supplied with the vehicle.
98703S
FRONT
98704S
REAR
These absolutely MUST be placed to the right of
the jacking points. They must be clipped into the
sill panel flange openings.
2 -
SPECIAL CASE OF THE REMOVAL - REFITTING
OF THE ENGINE AND TRANSMISSION
ASSEMBLY
In this specific case, the body of the vehicle must
be attached to the arms of the two post lift with
special pads.
FOG Company
Part number FOG 449 8111 - 449 8411
or
CHEMICO Company
Part number 39 2550 0001
or
SCHENCH Company
Part number 776 684
40-7

GENERAL
Repair Bench
40
12668R1
The bracket helps with the fitting of the cross
member and rests vertically against the front end
cross member, then it is centred by a centring bolt
at (K).
1 - Front mechanical units removed
It is used for replacing the front end cross mem-
ber, with or without mechanical units.
NOTE : The operation for replacing the front end
cross member can be carried out without the re-
moval of the engine and transmission assembly,
but requires the removal of the radiator.
2 - Front mechanical units in place
The bracket helps with fault finding on the front
cross member.
III - REFERENCE POINTS FOR POSITIONING REPLACED PARTS (cont)
L - REAR END CROSS MEMBER (REAR END)
12667R1
The bracket helps with the fitting of the cross
member and rests vertically against the rear end
cross member, then centres itself in the mounting
hole of the absorber mounting.
It is used for replacing the whole rear end, with or
without mechanical units.
K - FRONT END CROSS MEMBER
40-34