brake sensor RENAULT KANGOO 1997 KC / 1.G Transmission Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 22, PDF Size: 0.17 MB
Page 12 of 22
MANUAL GEARBOX
Gearbox (removal - refitting)
21
SPECIAL TOOLING REQUIRED
B. Vi. 31-01Set of punches
Mot. 1040-01Engine sub-frame carrier
T. Av. 476Ball joint extractor
Brake calliper bolt 4
Driveshaft gaiter bolt 2.5
Lower ball joint nut 5.5
Shock absorber base bolt 18
Engine tie-bar bolt 6.5
Gearbox edge and starter motor bolt 4.5
Suspended mounting bolt on gearbox 4
Wheel bolts 9
Track rod end nut 4
TIGHTENING TORQUES (In daN.m)
REMOVAL
Place the vehicle onto a two post lift.
Disconnect the battery.
Remove :
- the engine cover,
- the battery.
Disconnect the connectors on:
- the injection computer (petrol version),
- the preheating unit (diesel version),
_ the diesel fuel filter (diesel version),
- the impact sensor.
Remove the air filter sleeve.
13083S
EQUIPMENT REQUIRED
Engine support tool
Component jack
Remove the bolts (A) of the battery protective
screen.
13088R
21-5
Page 13 of 22
MANUAL GEARBOX
Gearbox (Removal - Refitting)
21
Remove :
- the two mounting bolts (B),
13119R
Disconnect the clutch cable.
Remove :
- the upper bolts at the gearbox edge and on
the starter motor (slacken the bolt (D) as far
as possible)
- the earth strap bolts on the gearbox,
- the two bolts of the
TDC sensor.
13097-2R
- the front wheels,
- the oil collector under the gearbox.
On the right-hand side of the vehicle, remove the
driveshaft pins using tool B. Vi. 31-01.
91755-1R2
Remove on both sides :
- the brake callipers and attach them together
- the mudguards,
- the track rod ends (T. Av. 476),
- the shock absorber base bolts,
- the sub-frame side member tie-rods (A),
- the stub axle carrier-driveshaft by disconnec-
ting it from the lower ball joint
99070R1
21-6