RENAULT KANGOO 1998 KC / 1.G Heating And Ventilation Manual PDF

AIR CONDITIONING
Electrical control
62
13827R
• EVAPORATOR SENSOR (depending on assem-
bly)
REMOVAL
Disconnect the battery.
Remove:
- the windscreen wiper arms,
- the air inlet grille,
- the evaporator protector in the plenum cham-
ber.
Disconnect the evaporator sensor connector and
the air recirculation motor connector.
Free the wiring from its fasteners.
Remove the evaporator sensor.
REFITTING
Proceed in the reverse order to removal.
Ensure that the sensor is correctly positioned on
its seat on the evaporator.
•0.28 Ω
FAN ASSEMBLY SPEED RESISTOR (2)
This is secured to the engine cooling fan support.
•
RECIRCULATION MOTOR
It is only possible to gain access to the recircula-
tion motor following removal of the air blower
unit (refer to the relevant section) and therefore
the evaporator assembly. •
PRESSURE SENSOR
The pressure sensor (1) is located next to the
condenser on the pressure relief valve-
dehydration canister high pressure pipe.
All work on the pressure sensor can be carried out
without draining the coolant circuit. It is secured
to a "SKRADER" valve.
Tightening torque: 0.8 daN.m.
This pressure sensor is fitted with seal. Check that
it is in good condition on refitting and lubricate it
using
P.A.G. SP 10 oil.
62-60

AIR CONDITIONING
Computer
62
15-way connector (A)
13825R
Track Description
1 Not used
2 AC operating information
3 Recirculation on/off
4 AC computer earth
5 + 12 V accessories (fan assembly fuse)
6 + 12 V after ignition (brake fuse)
7 Not used
8 Not used
9 Not used
10 Not used
11 Not used
12 Not used
13 Not used
14 Not used
15 Not used
62-61

AIR CONDITIONING
Computer
62
30-way connector (B)
Track Description
1 + 12 V after ignition (brake fuse)
2 Compressor control
3 L diagnostic information
4 Fan assembly voltage information
5 Not used
6 K diagnostic information
7 Not used
8 TDC information
9 Coolant pressure sensor
10 Coolant pressure sensor
11 Coolant pressure sensor signal
12Evaporator sensor (depending on
assembly)
13Power absorbed information (when the
compressor cuts in)
14 Not used
15 Not used
16 + 12 V after ignition (brake fuse)
17 Compressor control
18 AC cut off information
19 Not used
20 AC fast idle information
21 Not used
22 Fan assembly low speed control
23 Fan assembly high speed control
24 Not used
25 Not used
26 AC recirculation motor
27 AC recirculation motor
28 Not used
29Evaporator sensor (depending on
assembly)
30 Not used
62-62