cooling RENAULT SCENIC 2008 J84 / 2.G Electrical Equipment -Battery Workshop Manual

80A-6V4 MR-372-J84-80A000$040.mif
BATTERY
Battery – Check80A
Mode (test on vehicle)
–Connect the tool directly to the battery terminals, without disconnecting the vehicle battery, as close as possible to
the battery terminal but ensuring it is not after the fuse (on-vehicle test) or carry out the battery test after
disconnecting the two terminals if necessary,
–check that the vehicle ignition is switched off,
–select the "battery connected to the vehicle" or "battery disconnected" test type using buttons and
Confirm using the green button
–The test is carried out to the EN standard by default. Confirm using the green button .
–Select the starting power on the battery label (see page 3) using buttons and .
–Confirm using the green button .
–The tool displays: TEST IN PROGRESS.
–The MIDTRONICS tool carries out the test and gives the results of the fault finding procedure.
To set the tool language, carry out the following operations:
–before connecting the tool, simultaneously press buttons and
–connect the device to the battery,
–release the buttons,
–scroll through the languages using buttons and ,
–confirm using the green button .
Note:
The battery must always be disconnected in the following order:
–Wait for at least 1 minute between switching the ignition off and disconnecting the battery, to enable the
computer systems to go on standby.
–Wait for the engine cooling fan to stop completely.
–Disconnect the negative terminal first.