ECU RENAULT SCENIC 2008 J84 / 2.G Electrical Equipment - Multiplexing Workshop Manual

88B - 3
MULTIPLEXING
Fault finding - Introduction
88B
V4 MR-372-J84-88B050$100_eng.mif
MULTIPLEX NETWORK OPERATION TEST
This step is the essential starting point for any computer fault finding procedure.
It ensures that the network is correctly connected at the terminals of each computer and that the signal is correctly
sent to it and received by it. On the Scénic II ph2, this function also reads the number of faults present on the
computers.
The multiplex network test function is executed automatically after vehicle selection by the user.
After the network check, the other functions become accessible.
MULTIPLEX NETWORK TEST PROCEDURE
–Establish dialogue with the computers storing the vehicle configuration (read identification).
–Vehicle configuration read on the two computers that hold the multiplex network configuration (airbag and UCH
on the SCENIC II ph2).
–List of computers that can support fault finding read from the two computers that hold the multiplex network
configuration.
–Computer interrogation.
–Physical (electronic) measurements on the multiplex line network. Vehicle computer power supply for fault finding:
insert the vehicle card in the card reader.
Press and hold (over 5 seconds) the Start button in the absence of start conditions (for example: selecting a gear).
Connect the diagnostic tool and perform the required operations.
IMPORTANT
To supply the discharge bulb computer, switch on the dipped headlights.