manual radio set RENAULT SCENIC 2008 J84 / 2.G LPN Radio Workshop Manual

86A-12
MR-372-J84-86A050$354.mif
V3
86A
RADIO
Fault finding - Configurations and programming
SETTINGS
VP001: Write VIN
This command permits manual entry of the vehicle's VIN into the computer. Use this command each time
the computer is replaced. The VIN number is inscribed on the manufacturer's plate.
Procedure for writing the VIN
–Establish dialogue with the navigation computer.
–Select the Repair mode menu.
–Select the Other parameters menu.
–Select line VP001 Write VIN.
–Enter the VIN.
–Exit fault finding mode.
–Switch off the ignition.
–Wait for the end of power latch.
–Reread the VIN in the Identification menu for confirmation (ID014 VIN code).
VP003: "Enter After-Sales operation date"
This command is used to enter the date of the last After-Sales operation on the LPN* radio navigation
system.
VP005: Computer calibration and commissioning
This command is used to configure the LPN* radio navigation computer following its replacement. When
the command is complete, switch off the ignition, wait 2 minutes and switch on the ignition again. Check
that the configuration has registered correctly by re-reading the following configuration readings:
–LC008 "Vehicle configuration",
–LC012 "CD changer",
–LC015 "Vehicle type",
–LC016 "Distance units".
The radio is in factory mode after configuration (FM 87.5 MHz in scrambled mode for 2 minutes).
CONFIGURATIONS
CF013: CD changer
This command is used to indicate whether or not a CD changer is present under the front left-hand seat.
CF018: Distance units
This command is used to change the measurement unit for the distances displayed on the radio navigation
screen.
PROGRAMMING
There is no programming on the navigation system.
Important: After activating the system, the delay before establishing dialogue can last 20 seconds.
*LPN: Low Price NavigationNote:
Use the following commands if the configurations are incorrect after having used VP005 Computer calibration
and commissioning.
MR-372-J84-86A050$354.mif
LPN RADIO
Vdiag No.: C4

86A-86
MR-372-J84-86A050$944.mif
V3
LPN RADIO
Vdiag No.: C4RADIO
Fault finding - Fault Finding Chart86A
ALP 18 Telephone cannot be used with the Bluetooth function
NOTESOnly consult this customer complaint after a complete check with the diagnostic
tool.
Ensure there are no present or stored faults.
Check that Bluetooth mode is activated in the navigation and communication system.
Press the SET button and select the Telephone, Bluetooth option and Bluetooth connection menus.
Has the telephone been researched by Renault?
YES
Check that the telephone software on the telephone
is compatible with the vehicle's navigation and
communication system.
Consult the list of compatible phones on the
"RENAULT.net intranet" site.
Is the telephone software compatible with the
vehicle's navigation and communication
system?
YES
Activate the telephone's Bluetooth mode.
NOSuggest that the customer buy a telephone
approved by Renault.
List of compatible phones on the
"RENAULT.net intranet" site.
NOAsk the customer to contact the teleph one
vendor in order to install a software version
into the telephone that would be compatible
with the navigation and communication
system.
Refer to the phone's manual to activate its
Bluetooth mode.
AFTER REPAIRCarry out a complete check with the diagnostic tool.
LPN_VC4_ALP18