dashboard RENAULT SCENIC 2008 J84 / 2.G Parking Distance Control Workshop Manual

PARKING DISTANCE CONTROL
Fault finding - System operation
87F
87F - 7V4 MR-372-J84-87F000$132_eng.mif
Vdiag No: 04-08PARKING DISTANCE CONTROL
Fault finding - System operation
Description of operation
The system consists of four sensors built into the rear bumper, a computer and a buzzer.
The system assists the driver during parking manoeuvres by warning of any obstacles to the rear of the vehicle.
–The sensors and the computer calculate the distance between the vehicle and any obstacles. The sensors operate
over a distance range from 20 - 30 cm minimum to 150 cm maximum.
–The driver is informed of the distances by a buzzer.
–The system only works when the vehicle is in reverse gear. Activation is indicated by a brief 0.5 second
activation sound.
The buzzer is activated when the vehicle is 150 cm from the obstacle. As the distance diminishes, the frequency of
the buzzer increases. When the distance reaches 20 - 30 cm, the buzzer becomes continuous.
–The system can only be activated in + after ignition feed.
DEACTIVATING THE SYSTEM:
–The parking distance control can be deactivated in two ways:
–Temporary deactivation: briefly pressing (1 second) the parking distance control switch on the dashboard
deactivates the system (the red warning light on the switch comes on). The function can be switched on again by
pressing briefly for a second time (the red indicator light on the switch goes out) or by switching the ignition off and
back on.
–Permanent deactivation: the parking distance control system can be deactivated for a longer period by pressing
and holding (for approximately 3 seconds) the parking distance control switch on the dashboard (the red warning
light on the switch comes on). The function can be switched on again only by pressing and holding the switch
again (the red warning light on the switch goes out).
Fault finding:
A low pitched, 5-second continuous warning sound upon switching on the ignition informs the driver that a
system fault has occurred.Note:
Using the diagnostic tool statuses, it is possible to find out the function status (ready, detecting, suspended or
disabled) by using status ET003 Parking distance control function (see conformity check or the relevant
status interpretation).
MR-372-J84-87F000$132_eng.mif