diagram SSANGYONG NEW ACTYON SPORTS 2012 User Guide

13-6
2. OPERATING PROCESS
1) Schematic Diagram

14-172412-02
6. ELECTRIC CIRCUIT DIAGRAM

15-6
2. SYSTEM OPERATION
1) Input/Output of ECU
(1) ECU Block diagram

15-42
D. Control conditions
Operation Operating condition PTC Heater
HI
(PTC2)- Coolant temperature < 15℃PTC HI ON
LO
(PTC1)- Coolant temperature 15℃ ≤ 65℃, intake air
temperature ≤ -10℃
- Coolant temperature 15℃ < 65 to 60℃, intake air
temperature <-10℃ to 0℃
- Coolant temperature 15℃ ≤ 60℃, intake air
temperature ≤ 0℃ to 5℃PTC LO ON
Stop- A/C blower switch OFF
- Defective ambient air temperature sensor
(including open or short circuit)
- Engine cranking
- Low battery voltage (below 11V)
- During pre-glow process (glow indicator ON)
Operation diagram for PTC heater LO (step 2) ▶

01-111113-01
2) Compression Pressure Test
Standard Service Data ▶
A9912 0012B (001 589 76 21 00) Compression Pressure Tester -
Measuring Procedure ▶
Warm the engine up to normal operating temperature.
Remove the spark plugs using the spark plug wrench.
Place the diagram sheet to compression pressure tester A9912 0012B (001 589 76 21 00).
Connect the adaptor to compression pressure tester A9912 0012B (001 589 76 21 00)
and install it into the spark plug hole.
Crank the engine approx. eight revolutions by using the start motor.
Compare the measurements of compression pressure tester A9912 0012B (001 589 76 21
00) with the specifications.
Measure the compression pressure of the other cylinders in the same way.
If measured value is not within the specifications, perform the cylinder pressure leakage
test. -
-
-
-
-
-
-
-
Discharge the combustion residues in the cylinders before testing the compression
pressure.
Apply the parking brake before cranking the engine. -
-

12-58510-23
2. CONFIGURATION
1) Circuit Diagram
The engine ECU detects the operating conditions of cruise control system, and monitors the
braking performance, vehicle speed, road conditions and ESP system operation. If the engine
ECU determines that there are not any problem to drive in cruise control mode, the vehicle can be
operated by cruise switch signals (decelerating, accelerating, cruising).

01-4
3. CAPACITY AND NAME OF FUSE AND RELAY IN ENGINE
COMPARTMENT
The label attached on each fuse
box indicates only major fuses and
relays. Therefore, there are more
fuses and relays than indicated.
For details about the connection
of fuses and relays, refer to the
power distribution circuit diagram
on the following pages. *

02-58
Circuit Diagram for Wiper ▶
4. CIRCUIT DIAGRAM

02-598710-01
Circuit Diagram for Door Lock Control ▶
The door ajar warning lamp in the instrument cluster does not come on even though the
tailgate is opened.

03-4
2) System Diagram
The certification for the immobilizer is performed when turning the ignition switch to the "ON" position
after the CAN communication between the ECU and immobilizer is established.