warning SSANGYONG NEW ACTYON SPORTS 2013 Owner's Manual
[x] Cancel search | Manufacturer: SSANGYONG, Model Year: 2013, Model line: NEW ACTYON SPORTS, Model: SSANGYONG NEW ACTYON SPORTS 2013Pages: 751, PDF Size: 72.63 MB
Page 359 of 751

02-498710-01
▶Specifications of Remote Control Key
When any of switches on remote control key is pressed, the integrated CP\
U in remote control key sends
the coded control message to the CPU in receiver to control the vehicle.\
Door Unlock and Panic Function Breifly press (below 0.5 sec): Door unlock and theft deterrent mode is\
deactivated
Press and hold (over 2 sec): Panic function
Door unlock (Briefly press)
1.
If you send the door unlock signal using the remote control key, with al\
l the doors locked, the
door will be opened and the theft deterrent mode will be deactivated. If\
the door coupled switch
of front room lamp is pressed, the lamp will come on for 30 seconds. It \
will turn off immediately
after the lock button of the remote control is pressed.
·
Panic function: activated in the theft deterrent mode
2.
If you press and hold the door unlock and panic buttons, the buzzer will\
sound for 27 seconds
and the hazard warning flasher blinks.
The function is inactivated if any button of remote control is pressed.
* For the previous model, only the theft deterrent horn has been activat\
ed.
·
·
LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock Function
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is a\
ctivated
Door unlock (Briefly press)
1.
Pressing this button locks all doors and activates the theft deterrent m\
ode.
·
Page 361 of 751

02-518710-01
Specification of Receiver
▶
Operating requirements
1.
You should remove the ignition key.
-
Code registration requirement
2.
You can register the code only using the diagnostic device.
-
Transmitter code registration
3.
You can register up to 5 transmission codes to the remote control key.
The receiver does not output the received code during registration.
Connect the device to the diagnostic terminal.
The code can be registered only by the panic signal from the transmitter\
.
(Other switches (LOCK/UNLOCK) can't code.)
a.
b.
c.
Remote Door Lock
▶
All doors are locked when briefly pressing the door LOCK burron on remot\
e control key (less than
0.5 seconds).
The system outputs LOCK signal immediately a fter receiving the door lock message from the
remote control key. The system activates the theft deterrent mode when a\
ll doors are locked while
they are fully closed (the hazard warning lamps blink twice.).
1.
2.
Page 362 of 751

02-52
Door Unlock
▶
The door unlock operates when pressing the door switch on the remote con\
trol key for longer than
0.5 seconds.
The door unlock relay is "ON" for 0.5 seconds when receiving the door un\
lock message from the
remote control key.
The hazard warning lamps blink once only when all the doors unlocked suc\
cessfuly.
1.
2.
3.
Page 365 of 751

02-558710-01
STICS Outside Rearview Mirror Folding/Unfolding Control Circuit
▶
If you remove the ignition switch and open the driver's door with the su\
nroof open, the chime buzzer
sounds.
As soon as you close the driver's door or the sunrooof, the chime buzzer\
output stops.
However, when operating conditions in step (1) are met after the opera\
tion in step (2), the chime
buzzer will not sound again. If you turn the ignition swtich to the "ON"\
position again and the
operating contions in step (1) are met, the chime buzzer sounds again.\
If the operating condtions for door ajar warning and sunroof open warnin\
g are met at the same time,
the sunroof open warning is activated preferentially.
1.
2.
3.
4.
In order to prevent the driver from getting off the
vehicle with the sunroof open, the reminder function for
the driver is added. This function is activated as follows: Sunroof open warning
▶
Page 367 of 751

02-578710-01
Central Door Lock Circuit
▶
The door ajar warning lamp in the instrument cluster does not come on ev\
en though the tailgate is
opened.
Page 375 of 751

03-37010-06
ECUREKES keyDiagnostic connector
1. SYSTEM CONFIGURATION
1) Components and Locations
Immobilizer warning lamp in instrument panelImmobilizer unit
Page 378 of 751

03-6
3. FUNCTIONS OF IMMOBILIZER
The functions of the immobilizer are similar to that of the normal REKES key. But, there are the
immobilizer function that permits the engine to start only after confirming the encrypted coding.
The followings are common functions of the normal REKES key and the immobilizer.
Door Unlock and Panic Function
Breifly press (below 0.5 sec): Door unlock and
theft deterrent
mode deactivated
Press and hold (over 2 sec): Panic function
1. Door unlock (Briefly press)
If you send the door unlock signal using the
remote control key, with all the doors locked, the
door will be opened and the theft deterrent mode
will be deactivated. If the door coupled switch o
f
front room lamp is pressed, the lamp will come
on for 30 seconds. It will turn off immediately
after the lock button of the remote control is
pressed.
2. Panic function: activated in the theft deterrent mode
When pressing the door UNLOCK and PANIC button for approx.
2 seconds or longer, the warning alarm sounds and the hazard
warning lamp blinks for approx. 27 seconds.
The function is inactivated if any button of remote control is
pressed. ·
·
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is activated
1. Door unlock (Briefly press)
If you press this button briefly, all doors and the tailgate are locked and the theft deterrent mode is
activated.When the theft deterrent mode is activated, the hazard warning flashers blink twice.LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock
Page 381 of 751

03-97010-06
Immobilizer and Warning Lamp ▶
This indicator comes on when the ignition key is
communicating with the engine control unit
(during engine starting) and goes out after
starting the engine.
When turning the ignition key to the "ON"
position, the ECU (engine control unit) transmits
the challenge message to the immobilizer unit.
(This is to verify whether the key is valid. If the
verification fails, it transmits re-verification signals
3 times for 2 seconds. If three re-verifications fail,
it stops verification and starts re-verification after
10 seconds.) (1)
ECUOnly when the two signals are identical, it recognizes the
key as the authorized one and transmits the positive
message to the ECU. (6)
The ECU enable the engine to be started. (7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer system. ·
·
·
·
·ON: In communication
Blinks twice at one second intervals: Immobilizer
system fault
Blinks once at 2 second intervals: Immobilizer unit
not coded
The immobilizer indicator does not come on if
the communication time between immobilizer
key and ECU is too short.
Instrument
panel
Page 383 of 751

03-117010-06
5. REKES OPERATION LOGIC
1) Remote Door Lock
When briefly pressing the door lock switch on the remote control key for less than 0.5 seconds, all
doors are locked.
The system outputs the "LOCK" signal immediately after receiving the door lock message from the
remote control key. If the vehicle is locked while all doors including engine hood are closed, the theft
deterrent mode is activated (hazard warning lamps are blinking twice). 1.
2.
Page 384 of 751

03-12
2) Door Unlock
When briefly pressing the door unlock switch on the remote control key for less than 0.5 seconds, all
doors are unlocked.
When receiving the DOOR UNLOCK message from the remote control key, the door unlock relay is
turned on for 0.5 seconds.
The hazard warning lamps blink once only when all the doors unlocked successfuly. 1.
2.
3.