SSANGYONG NEW ACTYON SPORTS 2013 Service Manual

02-610000-00
5) How to Register Transponder
Insert the ignition key into the key cylinder and turn it to the "ON" po\
sition.
Select the vehicle type and system (immobilizer) on the diagnosis program.
Select the Transponder registration menu and enter the password. (initi\
al value is "0000") Select "Next".
1.
2.
3.
Press "Next" with the first key in key box.
4.

02-62
Check the progress.
5.
If another key should be registered additionally, insert the second key \
into the key cylinder and press
"Next" within 10 seconds since the first transponder coding is complete.\
6.

02-630000-00
Press "OK" button when the registration is complete.
7.
If the registration fails, press "Previous" button and perform the regis\
tration procedures again.

02-64
6) Pin Arrangement of Diagnostic Connector
Diagnosis connector is installed at the lower driver side instrument pan\
el and it consists of 16 pins.
REKES key coding should be done using the diagnostic device. ▶Fuction For Each Terminal
Pin No. Function Pin No.Function
1 -9Air bag
2-1 0-
3 STICS "C1" 11TCU(6AT)
4 Ground 12SSPS Unit
5 Signal ground 13TCCU
6 CAN - HIGH 14CAN - LOW
7 GSL ECU 15STICS "B21"
8 -16Battery +
The REKES key coding is not performed by connecting the REKES coding ter\
minal (No. 15) of the
diagnostic connector to the jump wire between the ground terminals.
(possible only diagnostic device)

03-37010-06
ECUREKES keyDiagnostic connector
1. SYSTEM CONFIGURATION
1) Components and Locations
Immobilizer warning lamp in instrument panelImmobilizer unit

03-4
2) System Diagram
The certification for the immobilizer is performed when turning the ignition switch to the "ON" position after
the CAN communication between the ECU and immobilizer is established.

03-57010-06
Item Front view Rear view Internal structure
RKSTICS key
2. OVERVIEW
The Immobilizer System provides an additional theft deterrent to the vehicle in which it is installed and
prevents it from being started by unauthorized persons. The transponder integrated in the key and the
engine control unit has the same code. When the ignition key with the integrated transponder is turned to
the ON position, the ECU (Engine Control Unit) checks the crypto code of the key and, if correct, allows
your vehicle to start the engine.
Immobilizer unit
RKSTICS Key ▶

03-6
3. FUNCTIONS OF IMMOBILIZER
The functions of the immobilizer are similar to that of the normal REKES key. But, there are the
immobilizer function that permits the engine to start only after confirming the encrypted coding.
The followings are common functions of the normal REKES key and the immobilizer.
Door Unlock and Panic Function
Breifly press (below 0.5 sec): Door unlock and
　　　　　　　　　　　　 theft deterrent
mode deactivated
Press and hold (over 2 sec): Panic function
1. Door unlock (Briefly press)
If you send the door unlock signal using the
remote control key, with all the doors locked, the
door will be opened and the theft deterrent mode
will be deactivated. If the door coupled switch o
f
front room lamp is pressed, the lamp will come
on for 30 seconds. It will turn off immediately
after the lock button of the remote control is
pressed.
2. Panic function: activated in the theft deterrent mode
When pressing the door UNLOCK and PANIC button for approx.
2 seconds or longer, the warning alarm sounds and the hazard
warning lamp blinks for approx. 27 seconds.
The function is inactivated if any button of remote control is
pressed. ·
·
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is activated
1. Door unlock (Briefly press)
If you press this button briefly, all doors and the tailgate are locked and the theft deterrent mode is
activated.When the theft deterrent mode is activated, the hazard warning flashers blink twice.LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock

03-8
4. START FUNCTION
1) Immobilizer Function
The immobilizer system prevents the vehicle theft by allowing only the authorized key to start the engine.
The transponder inside the key communicates with the immobilizer installed in the key box, and the
system permits the engine to start after confirming the encrypted coding from the engine ECU.
For the vehicle with the immobilizer, there can be a problem in starting the vehicle or the system
error:Immobilizer unit sends
encrypted code to
transponder (2)
Sends an encrypted signal to
unit as a response (3) Randomly transmitted code is changed to
an encrypted signal in immobilizer unit (4)
System compares signal from transponder and
encrypted signal in immobilizer unit (5)
When two or more immobilizer keys come into contact with (each) other(s).
When the key is close to any device sending or receiving electromagnetic fields or waves other
than Ssangyong products.
When the key is close to any electronic or electric devices such as lighting equipment, security
keys or security cards.
When the key is close to a magnetic or metal object or a battery. a.
b.
c.
d.
Immobilizer unitTransponder