ignition SSANGYONG NEW ACTYON SPORTS 2013 Workshop Manual

02-28
▶Seat Belt WarningThe seat belt warning light comes on and the chime buzzer sounds for 6 secon\
ds when turning
the ignition key to "ON" from "OFF".
If the seat belt is fastened before turning the ignition key to the the "ON" position, the warning light
blinks, however, the chime buzzer does not sound.
The seat belt warning light goes off and the chime buzzer stops when turning the ignition switch to
the "OFF" position during the warning operation.
The chime buzzer stops and the seat belt warning light stays on for the remainig time when
fastening the seat belt.
The seat belt warning light comes on and the chime buzzer sounds for 6 s\
econds again when
unfastening the seat belt during fastening operation while the ignition \
key is "ON" position.
1.
2.
3.
4.
The seat belt warning light blinks and the chime buzzer sounds for 6 seconds\
when turning the ignition
key to "ON" without fastening the seat belt. After fastening the seat be\
lt, the chime buzzer stops.
Seat Belt Warning LightChime Buzzer

02-298710-01
▶Parking Brake WarningThe parking brake warning light comes on for approx. 4 seconds when turning the ignition key
from the "OFF" to the "ON" position regardless of the vehicle speed and the parking brake switch
position. After this 4 seconds, the warning light comes on, goes off or blinks according to the
vehicle speed and the parking brake switch position.
The warning light comes on when the parking brake is applied and the veh\
icle speed is below 10
km/h.
The warning light goes off when releasing the parking brake under step (\
2).
The warning light blinks and the chime buzzer sounds for 2.5 seconds and stops for 1.5 seconds
when the vehicle speed is over 10 km/h for more than 2 seconds while the parking brake is
applied.
The warning light goes off and the chime buzzer stops when releasing the\
parking brake unde
r
step (4).
The warning light comes on and the chime buzzer stops when the vehicle speed goes down
below 10 km/h under step (4).
This function does not work when the ignition switch is in "OFF" positio\
n.
1.
2.
3.
4.
5.
6.
7.

02-30
▶Center Room Lamp Control
The overhead console lamp (front room lamp) and the center room lamp come on at 100% when
opening the door (driver's/passenger's/rear) while the center room lamp switch\
is at the doo
r
coupled/tailgate coupled operating position and the key reminder switch \
is "OFF".
When the door (driver's/passenger's/rear) is opened, the front and center room lamps come on at
100% and automatically go off after 30 seconds.
The room lamp stays on for 2 seconds and then dims through 3 seconds whe\
n closing the doors
within 30 seconds.
The dimming operation must have greater than 32 steps per one second.
The room lamp output should stop immediately after turning on the ignition key during the
dimming operation.
The front room lamp and the center room lamp come on for 30 seconds when\
receiving the
unlock signal from the remote control key while the doors are closed.
The front room lamp and the center room lamp output period is extended b\
y 30 seconds when
receiving the unlock signal from the remote control key again during output under step (5). (The
lamp stays on when unlocked by the remote control key.)
When a door is opened during its extended period, the lamp stays on. If closed, operates as in
step (2).
The room lamp output stops immediately after receiving the lock signal from door lock switches
while all doors are closed or entering into the anti-theft mode by pushi\
ng LOCK button on the
remote control key.
1.
2.
3.
4.
5.
6.
7.
8.

02-32
▶Ignition Key Hole IlluminationThe ignition key hole illumination comes on when opening the driver's door or passenger's doo
r
while the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing \
the door after step (1).
The output stops when the ignition key is turned to the "ON" position.
The output stops when receiving the lock signal from the remote control key and entering armed
mode.
1.
2.
3.
4.
▶Key cylinder with key hole illumination With diesel and gasoline engine With diesel engine With gasoline engine
Without immobilizer
→With key hole
illumination With immobilizer
→With key hole
illumination With immobilizer
→Without key hole
illumination function

02-338710-01
▶STICS Circuit for Tail Lamp Auto Cut (Battery Saver)
▶Tail Lamp Auto Cut (Battery Saver) The tail lamp is turn on or off according to the operations of the tail \
lamp switch.
The tail lamp relay is turned off (auto cut) when opening and closing the driver's door afte
r
removing the ignition key without turning off the tail lamp.
The tail lamp relay is turned on when inserting the ignition key into th\
e ignition switch.
The tail lamp relay is turned off (auto cut) when opening and closing the driver's door while the
ignition key is removed and the tail lamp is turned on.
1.
2.
3.
4.

02-36
▶Front Defogger TimerThe front defogger output is "ON" when turning on the front defogger switch with the engine
started (IGN ON)
The output stops when turning on the front defogger switch again during \
its operation.
The output is "ON" only for 6 minutes when turning on the front defogger\
switch within 10
minutes after completion of output for 12 minutes. This can be done only\
once.
The output is "OFF" when the ignition switch is "OFF".
1.
2.
3.
4.

02-378710-01
▶Rear Defogger TimerThe rear defogger output is "ON" when turning on the rear defogger switch with the engine
started (IGN ON)
The output stops when turning on the rear defogger switch again during i\
ts operation.
The output is "ON" only for 6 minutes when turning on the rear defogger switch within 10 minutes
after completion of output for 12 minutes. This can be done only once.
The output is "OFF" when the ignition switch is "OFF".
1.
2.
3.
4.

02-38
▶Door Lock/Unlock Control by Door Lock Switch
The door lock system outputs "LOCK" signal for 0.5 seconds when positioning the driver's o
r
passenger's door lock knob to the lock from unlock position.
The door lock system outputs "UNLOCK" signal fo r 0.5 seconds when positioning the driver's o
r
passenger's door lock knob to the unlock from lock position.
"LOCK" or "UNLOCK" by the door lock switch is ignored when outputting th\
e "LOCK" o
r
"UNLOCK" signal by other functions.
All door lock signals are "UNLOCK" for 0.5 seconds just for once when receiving the "LOCK"
signal within 0.5 seconds after closing the driver's or passenger's door while the ignition key is
removed.
1.
2.
3.
4.

02-418710-01
The door lock system outputs "LOCK" when the vehicle speed maintains over 30 km/h.
However, it doesn't output "LOCK" when all doors are locked or failed.
If any of doors is unlocked after outputting "LOCK" in step 1, outputs "LOCK" up to 5 times
(except step (1)) at the interval of one second.
If any of doors is unlocked after 5 times of "LOCK" outputs, the door (driver's/passenger's/rear) is
regarded as "FAIL".
If the door that was regarded as fail is changed (UNLOCK to LOCK), it will be recognized as a
normal one.
If any door is regarded as FAIL, the auto door lock function does not work. (if it is occurred when
the vehicle speed is over 30 km/h, the auto door lock output does not occur even if the vehicle
speed falls below 30 km/h and accelerates again to over 30 km/h.) Nonetheless, the central
door lock function works properly.
When the system receives "UNLOCK" signal fr om a door switch, it outputs "LOCK" signals 5
times. If additional "LOCK" signal from another door switch is detected during \
the period, the
system outputs five "LOCK" signals 5 times for the switch.
The door lock system outputs "UNLOCK" automatically if the "LOCK" output conditions are
established by this function or the key is cycled (IGN=OFF) (even when there is no "LOCK"
output while the vehicle speed maintains over 30 km/h under lock conditi\
on).
(If the LOCK condition is established with the ignition switch ON, the system outputs UNLOCK
signal unconditionally when turning the ignition switch to OFF position.\
)
However, when the ignition key is turned to "OFF" position, the lock output conditions will be
cancelled.
The "FAIL" condition of the door will be erased when the ignition key is\
turned to "OFF" position.
1.
2.
3.
4.
5.
6.
7.
8.
▶Auto Door Lock
T2: 0.5 s
(*1) LOCK: Driver's & Passenger's & Rear door & = Lock

02-42
▶Auto Door Unlock (Crash Unlock: Automatic Door Unlock in Collision)
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition
key to "ON" position.
After this period, the door lock system outputs "UNLOCK" for all doors for 5 seconds from 40 ms
after receiving the air bag collision signal.
Even though the key is turned to "OFF" position during the output of "UNLOCK", the output
continues on for remaining period.
The function is erased when turning "OFF" the ignition switch.
1.
2.
3.
4.
Cautions for door lock/unlock control
The "Unlock" control by air bag signal prevails over any "LOCK" or "UNLOCK" control by othe
r
functions.
The "LOCK/UNLOCK" request by other functions will be ignored after/durin\
g the output o
f
"UNLOCK" by the air bag.
However, the door lock is controlled by other functions when the ignitio\
n switch is "OFF".
"LOCK" (or "UNLOCK") output is ignored if "LOCK" (or "UNLOCK") output is required while
performing the output of "LOCK" (or "UNLOCK").
(However, UNLOCK by air bag signal and operation by the remote control \
key are valid.)
If the door lock system outputs "LOCK" and "UNLOCK" simultaneously, only\
the "LOCK" output
can be activated.
1.
2.
3.
4.