lock TOYOTA LAND CRUISER 2012 Owners Manual

453 3-6. Using the storage features
3
Interior features
L/C200_EE (OM60G38E)
Glove box
Open (push button)
Lock with the mechanical key
Unlock with the mechanical
key
Glove box light
The glove box light turns on when the tail lights are on.
Removing the separate tray
CAUTION
While driving
Keep the glove box closed.
Injuries may result in the event of sudden braking, sudden swerving or an
accident.
Pull out the separate tray.
Glove box

465
3-7. Other interior features
3
Interior features
L/C200_EE (OM60G38E)
Clock
The clock is displayed when
The “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON
mode.
When the battery is disconnected
The time display will automatically be set to 1:00.
With navigation system
Refer to “Navigation System Owner’s Manual”.
Without navigation system
The clock can be adjusted by pressing the buttons.
Adjust hours.
Adjust minutes.
Round the nearest hour.
*
*
:e.g. 1:00 to 1:291:00
1:30 to 1:592:00
2
1
3

468
3-7. Other interior features
L/C200_EE (OM60G38E)
Ashtray
Front
Press in and release the lid to
open.
Press down on the lock spring
plate to remove.
Push the lid to close.
Rear
Pull the ashtray lid to open.
Pull the ashtray upwards to
remove.

476
3-7. Other interior features
L/C200_EE (OM60G38E)
Seat heaters and ventilators
: If equipped
The seat heaters and ventilators heat the seats and maintain good
airflow by blowing air from the seats.
Front seat heaters/ventilators (if equipped)
Press the knob to release it.
Press the knob back in when
finished adjusting the tempera-
ture or the seat air flow.
Off
Blows air from the seat
The indicator light comes on.
The further you turn the knob
counterclockwise, the stronger
the airflow becomes.
Turns the seat heater on
The indicator light comes on.
The further you turn the knob
clockwise, the warmer the seat
becomes.

477 3-7. Other interior features
3
Interior features
L/C200_EE (OM60G38E)
Front seat ventilators (if equipped)
Press the knob to release it.
Press the knob back in when
finished adjusting the seat air
flow.
On
The indicator light comes on.
Adjusts the seat airflow
The further you turn the knob
clockwise, the stronger the air-
flow becomes.

501
4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
Hood
CAUTION
Pre-driving check
Check that the hood is fully closed and locked.
If the hood is not locked properly, it may open while the vehicle is in motion
and cause an accident, which may result in death or serious injury.
Release the lock from the inside of the vehicle to open the hood.
Pull the hood release lever.
The hood will pop up slightly.
Lift the hood catch and lift the
hood.
STEP1
STEP2

506 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine. (P. 649)
Make sure to check the oil type and prepare the items needed before
adding oil.
Remove the oil filler cap.
Add engine oil slowly, checking the dipstick.
Install the filler cap, turning it clockwise.
Engine oil selectionP. 649
Oil quantity
(Low  Full)1.5 L (1.6 qt., 1.3 Imp.qt.)
Items Clean funnel
STEP1
STEP2
STEP3

517 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
Fuel filter (diesel engine only)
You may drain the fuel filter yourself. However, as the operation is dif-
ficult, we recommend having it drained by your Toyota dealer. Even if
you decide to drain it yourself, contact your Toyota dealer.
The water in the fuel filter needs to be drained if the fuel system
warning light flashes and a buzzer sounds. (P. 574)
Turn the “ENGINE START STOP” switch OFF.
Place a small tray under the drain plug to catch the water and
any fuel that comes out.
Turn the drain plug counterclock-
wise about 2 to 2 1/2 turns.
Operate the priming pump until
fuel begins to run out.
After draining, tighten the drain plug by hand.
STEP1
STEP2
STEP3
STEP4
STEP5

538 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)
32A/PUMP
NO.1*150 A AI DRIVER
GLOW1
*2, *380 A Engine glow system
33A/PUMP
NO.2
*150 A No circuit
GLOW2
*2, *380 A Engine glow system
34 MAIN 40 AHeadlight, HEAD LL, HEAD RL,
HEAD LH, HEAD RH
35 ABS1 50 A ABS
36 ABS2 30 A ABS
37 ST 30 A Starter system
38 IMB 7.5 AID code box, smart entry & push
start system, GBS
39 AM2 5 A Main body ECU
40 DOME2 7.5 AVanity lights, overhead module,
rear interior light
41 ECU-B2 5 A Driving position memory system
42 AMP 2 30 A Audio system
43 RSE 7.5 A No circuit
44 TOWING 30 A Towing
45 DOOR NO.2 25 A Main body ECU
46 STR LOCK 20 A Steering lock system
47 TURN-HAZ 15 AMeter, front turn signal lights, side
turn signal lights, rear turn signal
lights, trailer
48EFI MAIN2*120 A Fuel pump
F/PMP*2, *320 A No circuit
FuseAmpereCircuit

539 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
49ETCS*110 A EFI
A/F*315 A A/F heater
50ALT-S5 A IC-ALT
51AMP 130 A Audio system
52 RAD NO.1 10 ANavigation system, audio system,
parking assist system
53 ECU-B1 5 ADouble lock system, smart entry &
start system, overhead module,
yaw rate & G sensor, tilt and tele-
scopic steering, meter, cool box,
gateway ECU, steering sensor,
VGRS
54 DOME1 5 A Illuminated entry system, clock
55 HEAD LH 15 A Headlight high beam (left)
56 HEAD LL 15 AHeadlight low beam (left), headlight
leveling system
57 INJ 10 A Injector, ignition system
58 MET 5 A Meter
59 IGN 10 ACircuit open, SRS airbag system,
gateway ECU, smart entry & push
start system, ABS, VSC, steering
lock system, GBS
60 DRL 5 A Daytime running light
61 HEAD RH 15 A Headlight high beam (right)
62 HEAD RL 15 A Headlight low beams (right)
63 EFI NO.2 7.5 A Air injection system, air flow meter
64 RR A/C NO.2 7.5 A No circuit
FuseAmpereCircuit