Engine TOYOTA SUPRA 1995 Service Manual PDF

Chapter 2. On±Vehicle Repair
( : A340E, A340F, A340H AUTOMATIC TRANSMISSION Repair Manual Pub. No. RM391U)
AT1±43AT1±43
See Page
Suspect Area
Symptom
Vehicle does not move in any forward position and reverse position
Vehicle does not move in particular position or positions
No up±shift
No down±shift
No lock±up or No lock±up off
Vehicle does not move in particular position or positions
(except R position)
Harsh engagement
Slip or Shudder
No kick±down
No engine braking
N " D
1st " 2nd
2nd " 3rd
3rd " O/D
O/D " 3rd
3rd " 2nd
2nd " 1st
N " D
N " R
1st " 2nd (2 position)
2nd " 3rd " O/D
2nd " 3rd
3rd " O/D
O/D " 3rd
Lock±up
1st " 2nd (D position)
1st " 2nd "
3rd " O/D
2nd
1st
Particular position
Forward and Reverse
Throttle cable1±2 shift valve2±3 shift valveThrottle valveManual valveParking lock pawlOil strainerTransmission
control rod
AT1±60± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONTROUBLESHOOTING

Chapter 3. Off±Vehicle Repair
(: A340E, A340F, A340H AUTOMATIC TRANSMISSION Repair Manual Pub. No. RM391U)
AT1±26
See Page
Suspect Area
Symptom
Vehicle does not move in any forward position and reverse position
Vehicle does not move in R position
No up±shift
No down±shift
Harsh engagement
Slip or Shudder
1st " 2nd
2nd " 3rd
3rd " O/D
O/D " 3rd
L position
2nd " 1st
D, 2 and L positions
D and 2 positions
2 position
Vehicle does not
move in:
No lock±up or No lock±up off
N " D
N " R
2nd " 3rd
3rd " O/D
Lock±up
Forward & Reverse (After warm±up)
Forward & Reverse (Just after engine starts)
R position
No engine braking
2nd
1st
3rd
2nd
1st
1st ~ 3rd
O/D
O/D
All position
Other than O/D
1st and 2nd
1st and R position
R position
Other than 2ndPoor acceleration
Engine stalls when starting off or stopping
O/D one±wayclutch (F
o)
O/D brake (B
o)
Torque converter
clutchO/D Planetary gear
unitO/D
direct clutch
(co)
1st reverse
brake (B
3)
AT1±62± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONTROUBLESHOOTING

CIRCUIT INSPECTION
DTC 38 A T Fluid Temperature Sensor Circuit
CIRCUIT DESCRIPTION
The fluid temp. sensor converts fluid temp. into resistance values which is input into the ECM.
 DTC No. Diagnostic Trouble Code Detection Condition Trouble Area
 
 
 
 
 
38
 
 
 
 
 
Either (a) or (b) are detected for 0.5 sec. or more
(a) Temp. sensor resistance less than 79

(b) After the engine has been operating for 15 minutes
or more, the resistance at the temp. sensor is more than
156 k
 
 
 
 
 

Harness or connector between A/T
fluid temp. sensor and ECM

A/T fluid temp. sensor

ECM
± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONTROUBLESHOOTINGAT1±64

See
Stop Light Switch Circuit
CIRCUIT DESCRIPTION
The purpose of this circuit is to prevent the engine from stalling, while driving in lock±up condition, when brakes
are suddenly applied.
When the brake pedal is operated, this switch sends a signal to ECM. Then the ECM cancels operation of the
lock±up clutch while braking is in progress.
WIRING DIAGRAM
INSPECTION PROCEDURE
Check operation of stop light.
Check and repair stop light circuit.
Check if the stop lights go on and off normally when the brake pedal is depressed and
released.
± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONTROUBLESHOOTINGAT1±83

SERVICE SPECIFICATIONS
SERVICE DATA
 Line pressure (wheel locked) Engine idling   
 D position 363±422 kPa 3.7±4.3 kgf/cm2 53±61 psi
 R position 500±598 kPa 5.1±6.1 kgf/cm2 73±88 psi
 AT stall (Throttle valve fully opened) 
 D position 902±1,147 kPa 9.2±11.7 kgf/cm2 131±166 psi
 R position 1,236±1,589 kPa 12.6±16.2 kgf/cm2 179±230 psi
 Engine stall revolution (D and R position) 2,200+150 rpm
 
 
Time lag N " D position
N " R position 
 
Less than 1.2 seconds
Less than 1.5 seconds
 
 
Engine idle speed
(In N position and air conditioner OFF) 
 
700+50 rpm 
 
 Throttle cable adjustment Between boot and face and inner cable stopper
 (Throttle valve fully closed) 0±1 mm 0±0.04 in.
 Drive plate runout Max 0.20 mm 0.0079 in.
 Torque converter clutch runout Max 0.30 mm 0.0118 in.
SHIFT POINT
NORM Mode
 Shift Position Shifting Point Vehicle speed km/h (mph)
 
 
 
 
 
 
 
D
Throttle valve fully opened 1"2
2"3
3"O/D
O/D"3
3"2
2"1
Throttle valve fully closed 3"O/D
O/D"353±62 (33±39)
104±112 (65±70)
163±175 (101±109)
157±169 (98±105)
98±105 (61±65)
42±48 (26±30)
34±39 (21±24)
20±25 (12±16)
 
 
 
2
Throttle valve fully opened 1"2
* 3"2
2"153±62 (33±39)
121±132 (75±82)
42±48 (26±330)
 LThrottle valve fully opened * 2"148±53 (30±33)
MANU Mode
 Shift Position Shifting Point Vehicle speed km/h (mph)
 
 
 
 
 
D
Throttle valve fully opened 2"3
3"O/D
O/D"3
3"2
Throttle valve fully closed 3"O/D
O/D"3104±112 (65±70)
163±175 (101±109)
157±169 (98±109)
98±105 (61±65)
163±175 (101±109)
20±25 (12±16)
 2Throttle valve fully opened * 3"2121±132 (75±82) 
 LThrottle valve fully opened * 2"148±53 (30±33)
AT1±96± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONSERVICE SPECIFICATIONS

LOCK±UP POINT
NORM Mode
 
 
D position km/h (mph)
Throttle valve opening 5% 
 Lock±up ON
 
 Lock±up OFF
 3rd Gear (O/D switch OFF) 56±62 (35±39) 53±59 (35±39)
 O/D Gear 56±62 (35±39) 53±59 (35±39)
MANU Mode
 
 D position km/h (mph)
Throttle valve opening 5%
 
 Lock±up ON
 
 Lock±up OFF
 
 3rd Gear (O/D switch OFF)
 
 98±105 (61±65)
 
 92±99 (57±62)
 O/D Gear 163±175 (101±109) 56±62 (35±39)
HINT:
(1) There is no lock±up in the 2 and L positions.
(2) In the following cases, the lock±up will be released regardless of the lock±up pattern.
w When the throttle valve is completely closed.
w When the brake light switch is ON.
(3) Shift up to 3rd will not occur when the engine coolant temp. is below 35°C (95°F) and the vehicle
speed is below 40 km/h (25 mph).
(4) Shift±up to O/D will not occur when the engine coolant temp. is below 60°C (140°F) and the vehicle
speed is below 63 km/h (39 mph)
(5) When the vehicle speed drops to 10 km/h (6 mph) or more below the cruise control set vehicle speed,
shift down from O/D to 3rd occurs.
± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONSERVICE SPECIFICATIONSAT1±97

TORQUE SPECIFICATIONS
 Part tightened NVm kgfVcm ftVlbf
 Engine block X Transmission 14 mm 37 380 27 
 17 mm
 
 72
 
 730
 
 53
 Rear mounting X Body 25 260 19
 Extension housing X Transmission case 36 370 27
 Valve body X Transmission case 10 100 7 
 Oil strainer
 
 10
 
 100
 
 7
 Oil pan 7.4 75 65 in.Vlbf
 No.1 vehicle speed sensor 16 160 12
 No.2 vehicle speed sensor 5.4 55 48 in.Vlbf 
 Solenoid wiring stopper plate
 
 5.4
 
 55
 
 48 in.Vlbf
 Rear center floor crossmember brace X Body 13 130 9
 Propeller shaft X Differential 79 805 58
 Manual shift linkage X Control shaft lever 13 130 9 Center support bearing X Body 49 500 36 
 Throttle cable X Transmission case
 
 5.4
 
 55
 
 48 in.Vlbf
 Cooler pipe union nut 34 350 25
 Drive plate X Crankshaft 74 750 54
 Torque converter clutch X Drive plate 33 340 25 
 Control shaft lever X Park/Neutral position switch
 
 16
 
 160
 
 12
 A/T fluid temp. sensor 15 150 11
 Drain plug 20 205 15
 Solenoid valve X Valve body 10 100 7 
 Parking lock pawl bracket
 
 7.4
 
 75
 
 65 in.Vlbf
 Transmission mounting bracket X Extension housing 25 250 18
 Heat insulator X Body 5.4 55 48 in.Vlbf
 Starter 37 380 27
AT1±98± AT340E (2JZ±GE) AUTOMATIC TRANSMISSIONSERVICE SPECIFICATIONS

ComponentFunction
O/D Direct Clutch (Co)
O/D Brake (Bo)
O/D One±Way Clutch (Fo)
Forward Clutch (C1)
Direct Clutch (C2)
2nd Coast Brake (B1)
2nd Brake (B2)
1st & Reverse Brake (B3)
No.1 One±Way clutch (F1)
No.2 One±Way Clutch (F2)
Connect overdrive sun gear and overdrive carrier
Prevents overdrive sun gear from turning either clockwise or counterclockwise
When transmission is being driven by engine, connects overdrive sun gear
and overdrive carrier
Connects input shaft and front planetary ring gear
Connects input shaft and front & rear planetary sun gear
Prevents front & rear planetary sun gear from turning either clock-
wise or counterclockwise
Prevents outer race of F1 from turning either clockwise or counterclockwise,
thus preventing front & rear planetary sun gear from turning counterclockwise
When B2 is operating, prevents front & rear planetary sun gear from turning
counterclockwise
Prevents rear planetary carrier from turning counterclockwise
Prevents rear planetary carrier from turning either clockwise or counterclockwise
± A340E (2JZÐGTE) AUTOMATIC TRANSMISSIONOPERATIONAT2±3

ELECTRONIC CONTROL SYSTEM
The electronic control system for the A340E automatic transmission provides extremely precise control of
the gear shift timing and lock±up timing in response to driving conditions as sensed by various sensors
located throughout the vehicle and in response to the engine's running condition.
At the same time, the ECM control reduces vehicle squat when the vehicle starts out and gear shift shock.
The electronic control system is also equipped with a self diagnosis system which diagnoses malfunctions
for the vehicle to continue functioning when a malfunction occurs.
CONSTRUCTION
The electronic control system can be broadly divided onto three groups; the sensors, ECM and actuators.
No. 1 Vehicle Speed Sensor
No. 2 Vehicle Speed Sensor
Crankshaft Position Sensor
Camshaft Position Sensor No.1, No.2
Park/Neutral Position Switch

Neutral Start Signal

Shift lever Position Signal

Idling Signal

Throttle Position Signal
Main (Sub) Ð throttle Position Sensor
Engine Coolant temp. Sensor
A/T Fluid Temp. Sensor
O/D Main Switch
Cruise Control ECU
Kick±Down Switch
Stop Light Switch
Pattern Select Switch
SENSORSECMACTUATORS
No.1 Solenoid Valve
No.2 Solenoid Valve
No.3 Solenoid Valve
No.4 Solenoid Valve
No.5 Solenoid Valve
Engine Torque Control (ESA)
Igniters
Ignition Coils
Distributors
Spark Plugs
O/D OFF Indicator Light
(Diagnostic Trouble Code
Display)
TRAC ECU
O/D Direct Clutch Speed Sensor
± A340E (2JZÐGTE) AUTOMATIC TRANSMISSIONOPERATIONAT2±7

ARRANGEMENT OF COMPONENTS
ComponentsFunction 
 Pattern Select Switch
 
 Selects the Power mode or the Normal mode for shift and
lock±up timing.
 
 Crankshaft Position Sensor and Camshaft Position
Sensor 
 Detects the engine speed.
 Park/Neutral Position Switch Detects the shift lever position.
 Stop Light Switch Detects if the brake pedal is depressed.
 Throttle Position Sensor Detects the throttle valve opening angle.
 O/D Main Switch Prevents up±shift to the O/D gear if the O/D switch is off.
 
 
 
Cruise Control ECU
 
 
 
This ECU prevents the transmission from shifting into O/D
and prohibits lock±up control when the vehicle's speed
drops below the cruise control set speed parameter.
 
 No.1 and No.2 Vehicle Speed Sensor.
 
 
Detects the vehicle speed. Ordinarily, transmission control
uses signals from the No.2 vehicle speed sensor, and the
No.1 vehicle speed sensor is used as a back±up.
AT2±10± A340E (2JZÐGTE) AUTOMATIC TRANSMISSIONOPERATION