ESP VOLVO XC90 TWIN ENGINE 2018 Manual Online

||WHEELS AND TIRES
574
WARNING
Please keep the following points in mind
when using the tire sealing system:
• The sealing compound bottle (no. 8 in the
illustration) contains 1) rubber latex, natu-
ral and 2) ethanediol. These substances
are harmful if swallowed.
• The contents of this bottle may cause
allergic skin reactions or otherwise be
potentially harmful to the respiratory tract,
the skin, the central nervous system, and
the eyes.
Precautions:
• Keep out of reach of children.
• Do not ingest the contents.
• Avoid prolonged or repeated contact with
the skin. Remove any clothing that has
come into contact with sealant.
• Wash thoroughly after handling.
First aid:
• Skin: Wash affected areas of the skin
with soap and water. Get medical atten-
tion if symptoms occur.
• Eyes: Flush with plenty of water for least
15 minutes, occasionally lifting the upper
and lower eyelids. Get medical attention if
symptoms occur. •
Inhalation: Move the exposed person to
fresh air. If irritation persists, get medical
attention.
• Ingestion: Do NOT induce vomiting
unless directed to do so by medical per-
sonnel. Get medical attention.
• Disposal: Dispose of this material and its
container at a hazardous or special waste
collection point.
WARNING •
Do not remove the bottle while the tire
sealing system is being used.
• Do not remove the hose while the tire
sealing system is being used.
1.

Turn on the vehicle's hazard warning flashers
if the tire sealing system is to be used in an
area with traffic.
If the puncture was caused by a nail or simi-
lar object, do not remove it. It will help seal
the hole.
2. Peel off the speed limit sticker from the side of the compressor. Affix the decal to a clearly
visible location on the windshield to remind
the driver not to exceed this speed limit. Do
not drive faster than 80 km/h (50 mph) while
using a tire that has been temporarily
repaired with the tire sealing system. 3.
Make sure the switch is in the 0 (Off) posi-
tion and take out the electric cable and the
hose.
4. Unscrew the orange cover on the compres- sor and unscrew the cap on the sealing com-
pound bottle.
5. Screw the bottle onto the bottle holder as far as possible.
The bottle and the bottle holder are equip-
ped with catches to help prevent the sealing
compound from leaking. Once the bottle is
screwed into place into the bottle holder, it
cannot be unscrewed. The bottle can only be
removed by a workshop. Volvo recommends
an authorized Volvo workshop.
WARNING Do not unscrew the bottle. It is equipped with
a catch to prevent leakage.
6.

Unscrew the tire's valve cap and screw the
hose's valve connector as far as possible
onto the valve.
Be sure the air release valve on the com-
pressor's hose is completely closed.

||LOADING, STORAGE AND PASSENGER COMPARTMENT
594
WARNING
Objects in the cargo compartment must
always be securely anchored, even with a cor-
rectly installed cargo net.
Installing the cargo net
WARNING
All of the cargo net's upper consoles, hooks
and straps must be securely mounted and
attached before the net is used.
Never use the net if it is damaged.
NOTE
With front mounting, the cargo net is most
easily installed via a rear door.
1. Fold out the cargo net and make sure that
the upper rod folds out and locks into posi-
tion.
2.

Insert one of the net's hooks into the front or
rear ceiling mounting point with the strap
lock facing you. 3. Insert the other upper hook into the ceiling
mounting point on the opposite side. The
telescopic spring-loaded hooks make mount-
ing easier.
Make sure that the net's hooks are pushed
forward as far as possible into their respec-
tive mounting points. 4. Rear mounting: With the cargo net hooked
into the rear ceiling mounting points, attach
the net's straps into the front floor eyelets in
the cargo compartment. Rear mounting.
Front mounting: With the cargo net mounted
in the front ceiling mounting points, hook the
straps into the outer eyelets on the front seat
rails behind the seats. Attaching the net is
easier if the seat backrests are upright and
the seats are moved slightly forward.

MAINTENANCE AND SERVICE
}}
603
Scheduling service and repairs
4
This service offers a convenient way to schedule
service and workshop appoints directly from the
vehicle. When it is time for service, and in certain cases if
the vehicle requires repairs, a message will be
displayed in the instrument panel and at the top
of the center display. The time for service is
determined by how much time has elapsed, the
number of hours the engine has run, or the dis-
tance driven since the last service.
To use the service
• Create a Volvo ID and register the Volvo ID
to the vehicle.
• To select a Volvo retailer you would like to
contact, go to www.volvocars.com and log in.
• To send and receive appointment informa-
tion, the vehicle must be connected to the
Internet 5
.
Book serviceWhen you schedule service from your vehicle, the
information is sent via your Internet connection 5
.
Submit an appointment request whenever you
need service or when a message regarding the
need for service or repairs has been displayed in the instrument panel and at the top of the center
display. 1.
Open the Car status app from App view in
the center display.
2. Tap the Appointments button.
3. Tap the Request appointment button.
4. Check that your Volvo ID is correct.
5. Make sure your preferred Workshop is cor-
rect.
6. In the Tap to write information to the
Workshop field, you can provide details on
what you would like performed during the
visit or other important information to your
workshop. 7.
Tap the Send appointment request but-
ton.
>

You will receive an appointment sugges-
tion to your vehicle within a couple of
days 6
. You will also receive the same
message via email and when you log in to
www.volvocars.com.
On some markets, the message in the
instrument panel indicating that the vehi-
cle requires service will go out once the
appointment request has been sent.
8. Tap Cancel request if you would like to
cancel your request.
The appointment request contains information
about your vehicle that helps the workshop plan
for your visit.
The retailer will send you a digital appointment
suggestion. Information about your retailer is also
available in the vehicle so that you can contact
your workshop at any time.
Accepting an appointment suggestionWhen the vehicle has received an appointment
suggestion, a message will be displayed at the
top of the center display.
1. Tap the message. 3
Certain markets only.
4 Certain markets only.
5 There may be a charge for transmitting data over the Internet, depending\
on your service plan.
6 Timespan may vary depending on market.

MAINTENANCE AND SERVICE
620Battery symbols
There are warning symbols and information on
the batteries. Wear protective goggles.
See the Owner's Manual for
additional information. Keep batteries away from
children. Batteries contain corrosive
acid. Avoid smoking, open
flames, and/or sparks. Risk of explosion.
Recycle properly.
NOTE
A used start battery contains lead and must
be recycled in an environmentally responsible
manner.
Related information
•
Start battery (p. 615)
• Hybrid battery (p. 619) Fuses and fuseboxes
All electrical functions and components are pro-
tected by a number of fuses in order to protect
the vehicle's electrical system from damage by
short circuiting or overloading.
WARNING Never use a foreign object or a fuse with a
higher amperage than that specified to
replace a fuse. This could cause significant
damage to the electrical system and possibly
lead to a fire.
WARNING
Orange wiring may only be handled by quali-
fied personnel.
WARNING
Several components in the vehicle work with
high voltage that can be hazardous in case of
an incorrect procedure.
Do not touch anything that is not clearly
described in this Owner's Manual.
If any electrical component or function is not
responding, the component may have blown a
fuse due to temporary overload. If the same fuse
blows repeatedly, there may be a problem with
the component. Volvo recommends contacting an
authorized Volvo workshop to have the compo-
nent checked.

SPECIFICATIONS
}}
655 Vehicle Emission Control Information. US
models. Your Volvo is designed to meet all appli-
cable emission standards, as evidenced by the
certification label on the underside of the hood.
For further information regarding these regula-
tions, please consult your Volvo retailer. Vehicle Emission Control Information.
Canadian models. Your Volvo is designed to
meet all applicable emission standards, as evi-
denced by the certification label on the underside
of the hood. For further information regarding
these regulations, please consult your Volvo
retailer. Vehicle Identification Number (VIN). The
VIN plate is located on the top left surface of the
dashboard. The Vehicle Identification Number
(VIN) should always be quoted in all correspond-
ence concerning your vehicle with the retailer and
when ordering parts. Tire inflation pressures. This label indicates
the correct inflation pressures for the tires that
were on the vehicle when it left the factory. Federal Motor Vehicle Safety Standards
(FMVSS) specifications (USA) and Ministry of
Transport (CMVSS) standards (Canada). Your
Volvo is designed to meet all applicable safety
standards, as evidenced by the certification label
on the driver's side B-pillar (the structural mem-
ber at the side of the vehicle, at the rear of the
driver's door opening). This label also includes
codes for paint color, etc. For further information
regarding these regulations, please consult your
Volvo retailer. U.S. models have the upper decal;
Canadian models have the lower one.