YAMAHA R6 RACE 2022 User Guide

Safety information
1-4
1
Many companies with no connection
to Yamaha manufacture parts and ac-
cessories or offer other modifications
for Yamaha vehicles. Yamaha is not in
a position to test the products that
these aftermarket companies produce.
Therefore, Yamaha can neither en-
dorse nor recommend the use of ac-
cessories not sold by Yamaha or
modifications not specifically recom-
mended by Yamaha, even if sold and
installed by a Yamaha dealer.
Aftermarket Parts, Accessories, an
d
Mo difications
While you may find aftermarket prod-
ucts similar in design and quality to
genuine Yamaha accessories, recog-
nize that some aftermarket accesso-
ries or modifications are not suitable
because of potential safety hazards to
you or others. Installing aftermarket
products or having other modifications
performed to your vehicle that change
any of the vehicle’s design or operation
characteristics can put you and others
at greater risk of serious injury or
death. You are responsible for injuries
related to changes in the vehicle. Keep the following guidelines in mind,
as well as those provided under “Load-
ing” when mounting accessories.
 Never install accessories or carry
cargo that would impair the per-
formance of your motorcycle.
Carefully inspect the accessory
before using it to make sure that it
does not in any way reduce
ground clearance or cornering
clearance, limit suspension travel,
steering travel or control opera-
tion, or obscure lights or reflec-
tors.
• Accessories fitted to the han- dlebar or the front fork area can
create instability due to improp-
er weight distribution or aerody-
namic changes. If accessories
are added to the handlebar or
front fork area, they must be as
lightweight as possible and
should be kept to a minimum.
• Bulky or large accessories may seriously affect the stability of
the motorcycle due to aerody-
namic effects. Wind may at-
tempt to lift the motorcycle, or
the motorcycle may become unstable in cross winds. These
accessories may also cause in-
stability when passing or being
passed by large vehicles.
• Certain accessories can dis- place the operator from his or
her normal riding position. This
improper position limits the
freedom of movement of the
operator and may limit control
ability, therefore, such accesso-
ries are not recommended.
 Use caution when adding electri-
cal accessories. If electrical ac-
cessories exceed the capacity of
the motorcycle’s electrical sys-
tem, an electric failure could re-
sult, which could cause a
dangerous loss of lights or engine
power.
Aftermarket Tires an d Rims
The tires and rims that came with your
motorcycle were designed to match
the performance capabilities and to
provide the best combination of han-
dling, braking, and comfort. Other
tires, rims, sizes, and combinations
may not be appropriate. See page 7-21
UBN6EBE0.book Page 4 Tuesday, October 19, 2021 8:35 AM

Safety information
1-5
1for tire specifications and for informa-
tion on servicing and replacing your
tires.
Transportin
g the Motorcycle
Be sure to observe following instruc-
tions before transporting the motorcy-
cle in another vehicle.  Remove all loose items from the
motorcycle.
 Check that the fuel cock (if
equipped) is in the off position and
that there are no fuel leaks.
 Shift the transmission into gear
(for models with a manual trans-
mission).
 Secure the motorcycle with tie-
downs or suitable straps that are
attached to solid parts of the mo-
torcycle, such as the frame or up-
per front fork triple clamp (and not,
for example, to rubber-mounted
handlebars or turn signals, or
parts that could break). Choose
the location for the straps carefully
so the straps will not rub against
painted surfaces during transport. 
The suspension should be com-
pressed somewhat by the tie-
downs, if possible, so that the mo-
torcycle will not bounce exces-
sively during transport.
UBN6EBE0.book Page 5 Tuesday, October 19, 2021 8:35 AM

Description
2-1
2
EAU94540
Left view(This image is of the street legal version and is for reference only.)
16789
3 4,5
2
1. Fuses (page 7-36F
2. Fuel tank cap (page 4-19F
3. Spring preload adjuster (page 4-26F
4. Fast compression damping force adjuster (page 4-26F
5. Slow compression damping force adjuster (page 4-26F
6. Rebound damping force adjuster (page 4-26)
7. Shift pedal (page 4-17F
8. Engine oil filter cartridge (page 7-15F
9. Engine oil drain bolt (page 7-15F
UBN6EBE0.book Page 1 Tuesday, October 19, 2021 8:35 AM

Description
2-2
2
EAU94550
Right view(This image is of the street legal version and is for reference only.)
1,2
3,4,5
6
8910 7
1. Fuses (page 7-36)
2. Battery (page 7-35)
3. Spring preload adjuster (page 4-24)
4. Rebound damping force adjuster (page 4-24)
5. Compression damping force adjuster (page 4-24)
6. Coolant reservoir (page 7-19)
7. Engine oil filler cap (page 7-15) 8. Engine oil dipstick (page 7-15)
9. Brake pedal (page 4-17)
10.Rear brake fluid reservoir (page 7-27)UBN6EBE0.book Page 2 Tuesday, October 19, 2021 8:35 AM

Description
2-3
2
EAU94560
Controls and instruments(This image is of the street legal version and is for reference only.)
12 4 35678
1. Clutch lever (page 4-16)
2. Left handlebar switches (page 4-3)
3. Main switch/steering lock (page 4-2)
4. Multi-function meter unit (page 4-8)
5. Front brake fluid reservoir (page 7-27F
6. Right handlebar switches (page 4-3F
7. Brake lever (page 4-17F 8. Throttle grip (page 7-21F
UBN6EBE0.book Page 3 Tuesday, October 19, 2021 8:35 AM

Special features
3-1
3
EAU76422
D-mode ( drive mo de)D-mode is an electronically controlled
engine performance system. This
model has three mode selections:
“STD”, “A”, and “B”.
WARNING
EWA18440
Do not chan ge the d rive mo de while
the vehicle is movin g.With the throttle grip closed, push this
switch to change the drive mode in the
following order:
STD → A → B → STD
TIP Make sure you understand each
drive mode before operating the
drive mode switch.
 The current drive mode is shown
in the drive mode display (page
4-12).
 The current drive mode is saved
when the vehicle is turned off.Mo de “STD”
Mode “STD” is suitable for various rid-
ing conditions.
This mode allows the rider to enjoy
smooth and sporty drivability from the
low-speed range to the high-speed
range.
Mo de “A”
Mode “A” offers a sportier engine re-
sponse in the low- to mid-speed range
compared to mode “STD”. Mo
de “B”
Mode “B” offers response that is
somewhat less sharp compared to
mode “STD” for riding situations that
require especially sensitive throttle op-
eration.
1. Drive mode switch “MODE”
1
UBN6EBE0.book Page 1 Tuesday, October 19, 2021 8:35 AM

Special features
3-2
3
EAU79735
Traction control systemThe traction control system helps
maintain traction when accelerating on
slippery surfaces, such as unpaved or
wet roads. If sensors detect that the
rear wheel is starting to slip (uncon-
trolled spinning), the traction control
system assists by regulating engine
power as needed until traction is re-
stored.
WARNING
EWA15433
The traction control system is not a
substitute for ri din g appropriately
for the con ditions. Traction control
cannot prevent loss of traction d ue
to excessive spee d when enterin g
turns, when acceleratin g har d at a
sharp lean an gle, or while b raking,
an d cannot prevent front wheel slip-
pin g. As with any vehicle, approach
surfaces that may be slippery with
caution an d avoi d especially slip-
pery surfaces.
The “ ” indicator light flashes when
traction control has engaged. You may
notice slight changes in engine and ex-
haust sounds when the system has en-
gaged.
When the traction control system is
turned off, the “ ” indicator light will
come on.TIP When the vehicle is turned on, the
traction control system is turned
on and set to the last used traction
control system setting. 
The current traction control sys-
tem setting is shown on the trac-
tion control system display (page
4-12).
Traction control system settin gs
“TCS OFF”
“TCS OFF” turns the traction control
system off.
“TCS 1”
“TCS 1” minimizes traction control
system assist.
“TCS 2, 3, 4, 5”
“TCS 2” through “5” sequentially in-
crease traction control system assist.
“TCS 6”
“TCS 6” maximizes traction control as-
sist; wheel spin is most strongly con-
trolled.
1. Engine trouble warning light “ ”
2. Traction control system indicator light “ ”
3. Traction control system display
12
3
UBN6EBE0.book Page 2 Tuesday, October 19, 2021 8:35 AM

Special features
3-3
3
NOTICE
ECA16801
Use only the specified tires. (See
pa ge 7-21.) Usin g different size d
tires will prevent the traction control
system from controllin g tire rotation
accurately.Setting the traction control system
To turn the traction control system offStop the vehicle and:  push up on the traction control
system switch for two seconds to
turn the traction control system
off. 
push down on the traction control
system switch to turn the traction
control system back on.
TIPTurn the traction control system off to
help free the rear wheel if it is stuck in
mud or sand, etc.To change the traction control systemsettingsStop the vehicle or close the throttle
and:
 push up on the traction control
system switch to decrease trac-
tion control (6 →5→ 4→ 3→ 2→ 1).
 push down on the traction control
system switch to increase traction
control (1 →2→ 3→ 4→ 5→ 6).TIPThe traction control system settings
can also be changed when moving in
straight line if the throttle grip is held in
a fixed position for two seconds while
in 4th, 5th, or 6th gear.
WARNING
EWA18940
Take extra precaution when chan g-
in g mo des while rid ing.Resettin g the traction control sys-
tem
The traction control system will auto-
matically disable when:  the front wheel or rear wheel
comes off the ground while riding.
 excessive rear wheel spin is de-
tected while riding.
 either wheel is rotated with the
main switch turned on (such as
when performing maintenance).
If the traction control system is dis-
abled, both the “ ” indicator light and
the “ ” warning light will come on.
Should this occur, try resetting the sys-
tem as follows. 1. Stop the vehicle and turn the main switch off.
2. Wait a few seconds and then turn the main switch back on.
3. The “ ” indicator light should turn off and the system be en-
abled.
1. Traction control system switch “TCS”
1
UBN6EBE0.book Page 3 Tuesday, October 19, 2021 8:35 AM

Special features
3-4
3
TIPIf the “ ” indicator light remains on af-
ter resetting, the vehicle may still be
ridden; however, have a Yamaha deal-
er check the vehicle as soon as possi-
ble.4. Have a Yamaha dealer check thevehicle and turn off the “ ”
warning light.
EAU79482
Quick shifterThe quick shifter allows for full-throttle,
clutch lever-less upshifts. When the
shift switch detects motion in the shift
pedal, engine power and drive torque
are momentarily adjusted to allow the
upshift to occur.TIPThe quick shifter operates when travel-
ing at least 20 km/h (12 mi/h) with an
engine speed of 2000 r/min or higher,
and only when accelerating. It does not
operate when the clutch lever is pulled.NOTICE
ECA26261
To prevent d rivetrain damag e, al-
ways use the clutch lever to shift
when rid ing at slow speed , when
d ownshiftin g, or if the quick shifter
is off.
UBN6EBE0.book Page 4 Tuesday, October 19, 2021 8:35 AM

Instrument and control functions
4-1
4
EAU10979
Immo bilizer systemThis vehicle is equipped with an immo-
bilizer system to help prevent theft by
re-registering codes in the standard
keys. This system consists of the fol-
lowing:
 a code re-registering key
 two standard keys
 a transponder (in each key)
 an immobilizer unit (on the vehicle)
 an ECU (on the vehicle)
 a system indicator light (page 4-7) A
bout the keys
The key with the red bow is used to
register codes in each standard key.
Store the code re-registering key in a
safe place. When necessary, take the
vehicle along with all three keys to a
Yamaha dealer to have them re-regis- tered.
Do not use the key with the red bow for
driving. It should only be used for re-
registering the standard keys. Always
use a standard key for driving.
TIP Keep the standard keys as well as
keys of other immobilizer systems
away from the code re-registering
key.
 Keep other immobilizer system
keys away from the main switch
as they may cause signal interfer-
ence.NOTICE
ECA11823
DO NOT LOSE THE CODE RE-REG-
ISTERING KEY! CONTACT YOUR
DEALER IMMEDIATELY IF IT IS
LOST! If the cod e re-registering key
is lost, the existin g stan dar d keys can still b
e used to start the vehicle.
However, re gisterin g a new stan-
d ar d key is impossi ble. If all keys
have been lost or damag ed , the en-
tire immo bilizer system must be re-
placed . Therefore, han dle the keys
carefully.  Do not su bmerse in water.
 Do not expose to hi gh tempera-
tures.
 Do not place near mag nets.
 Do not place near items that
transmit electrical si gnals.
 Do not han dle rou ghly.
 Do not grin d or alter.
 Do not disassem ble.
 Do not put two keys of any im-
mo bilizer system on the same
key rin g.
1. Code re-registering key (red bow)
2. Standard keys (black bow)UBN6EBE0.book Page 1 Tuesday, October 19, 2021 8:35 AM